Question about Isuzu Trooper

Open Question

Headlight Switch replacement on 1994 Isuzu Trooper. Didn't know if I needed special tools... I have the new switch. Was wondering if there was a schematic available... Thanks!

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

r_mcalhoun
  • 166 Answers

SOURCE: isuzu trooper

no on the free owner man. try junk yards and ebay

Posted on Mar 29, 2009

  • 1 Answer

SOURCE: Starter removal - 1994 Isuzu Trooper

pull the starter away from the bellhousing and turn the drive end upwards then it will come out from the engine compartment tight i know but i have just done mine so i know it will come

Posted on Mar 30, 2009

  • 60 Answers

SOURCE: brake job on 1994 isuzu trooper

are they drums on the rear? if not you can do this. on the caliper there should be 2 bolts holding it on. loosen one and pull the other out. lift the caliper up or down remove pads open the master cylinder so that you can compres the piston on the caliper. if you dont open the master sylinder cap it will be very tough. replace pads. tighten bolts nice and snug. then with car off pump brakes till tough. make sure you fill the master sylinder up that way no air gets in to it. if you do you gonna have to bleed the brakes. if that happens start at the passenger side rear then driver side rear then passenger front then driver front. please lemme know if you need help or if i helpd at all

Posted on Apr 24, 2009

emissionwiz
  • 75797 Answers

SOURCE: need to know the firing order diagram for a 1994 isuzu trooper

go to link for your info.
http://autorepair.about.com/library/firing_orders/bl-fo-7349.htm

Posted on Jun 11, 2009

germcelchar
  • 389 Answers

SOURCE: change a cv boot on a 1996 isuzu trooper

First their are two different front axles in 1996 troopers. Isuzu changed the 4wd system from auto lock hubs to drive control axle.auto lock hube are on the older trooper's with the light and wiper switches on the dash. The same way to change both. Auto hub remove the six hex. screws slide off the hub remove the sirclip from the driveshaft. Newer hub has 6 alan-head screw's again remove them then the hubcap then the sirclip on the shaft and slide off the round spacer. Next 4 bolts from the lower balljoint and the brake's. Pull out the hub until it clear's the shaft remove the inner boot clips slide the inner boot out the shaft. Clean the grease from the end of the axle then with your fingernail feel along any of the 3 tracks in the axle and near the outer end of the track you will find a wirelike split ring slide a screwdriver under the ring and lever it off . Pull out the drive clean off the grease. You will see a sirclip on the end of the joint remove it and slide off the joint. You can replace either boot from that end. The outer joint is held on with a snap ring on the shaft inside the joint and is not easily removed need a hammer and drift to drive off the end and when removed its hard to get the snap ring on the shaft back into its place.You can change both boots from this end as well. Cheers

Posted on Sep 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1994 trooper trans light blinking took it in shop did a trans flush filter,gaskit and tran oil change. but this is the thing trooper misses and tran hold back but when shop checks computer reads nothing...


check out the neutral saftey switch on trans, if its reporting unknown gear on scanner while moving t bar it wont know what gear to be in and give you similar problems, also has oil been leaking into switch before?

Feb 17, 2011 | 1994 Isuzu Trooper

1 Answer

My truck overheated. i changed the radiator and put new coolant. is there a engine switch or anything i need to reset. the truck will not turn on.


Hello, rigomorales2 and thank you for asking your question on Fixya!

Here is a simple process that will walk you through a few steps that will pinpoint the overheating problem on your
1994 Isuzu Trooper, without even using any tools. It has helped millions of people, and I am certain that it will help you, because I wrote it for people in your exact situation.
How to diagnose your overheating
1994 Isuzu Trooper

Get more great money saving tips and tricks about your vehicle from: twitter.com/acoates23234

Thanks for the vote, and good luck!

Jan 09, 2011 | 1994 Isuzu Trooper

2 Answers

Power window Wiring Diagram color codes for 94 Isuzu Trooper


hello; i bought a wrong window power switch for my Isuzu Tooper which resulted in wrong mountings and now i cant join the the two together...need help in understanding the diagrams of both the GenuineĀ® W0133-1598721-OES - Front Driver Side Window Switch

Aug 15, 2010 | 1994 Isuzu Trooper

1 Answer

How to change headlight


This is the same for the pick up as is the Trooper:

Aerodynamic Type

e5d8044.gif
Replacing a headlamp bulb—1994 Trooper shown


8391601.gif
Replacing a headlamp bulb—1994 Trooper shown


  1. Disconnect the negative (−) battery cable.
  2. Open the hood and disconnect the headlight bulb electrical connector.
  3. There are two possible designs. For the first design, turn the bulb to remove it from the housing, for the second unscrew the retaining cap and remove the bulb.

    WARNING Do not touch the glass portion of the halogen bulb. Any contamination on the bulb may cause the bulb to burst when turned ON. If the bulb is contaminated, clean the glass portion with rubbing alcohol.

  4. Hold the bulb by the plastic portion only. Install the bulb and connect the wiring harness. Make sure the sealing ring is in place.


Non-Aerodynamic




3dbcbc6.gif Replacing a sealed beam headlamp—1990 Amigo shown

  1. Disconnect the negative (−) battery cable.
  2. Remove the front grille and/or headlight bezel.
  3. Remove the headlight bulb retaining rim, headlight and disconnect the wiring.
  4. Before installing, spray some silicone grease into the bulb socket.
  5. Connect the wiring and install the bulb.
  6. Install the retaining rim and grille.
  7. Adjustment: turn the adjusting screw (A) for vertical adjustment. Turn the screw (B) for horizontal adjustment.

Feb 14, 2010 | 1994 Isuzu Pickup

1 Answer

1994 V6/AT Isuzu Trooper- Exhaust Manifold Bolt Studs stripped at muffler pipe connection. Can they be replaced without removing the passengers side manifold? What is best manual to cover this? Bob in...


there are several stud removers on the market and several broken bolt removers as well.
The best ones are the ones that have a reversed spiral inside them and tighten down on the stripped or broken bolt / stud as they are turned to remove it.
The Sears unit I use are about 1 inch tall and can be used with a wrench or socket.
Set over the bolt / stud , tap lightly as you slowly turn the tool with a small hammer to start it on the bolt, as soon as it catches switch to a wrench and remove as you would a regular bolt.

Jan 23, 2010 | 1994 Isuzu Trooper

2 Answers

The sunroof on my 1994 issuzu trooper sometimes works and some times not. It may open but not close. I have replaced the switch and it made no difference. How can I close it manually?


you should have a SUNROOF tool in your glove box. over the rear seats, in the head liner, there is a cut out for the SUNROOF tool. place the tool in the cut out and crank manualy. if you don't have the tool, a hex wrench is needed.

Mar 24, 2009 | 1994 Isuzu Trooper

1 Answer

I need to replace the altenator in my 1994 Isuzu Trooper. Do I have to remove the Power Steering Pump to reach the part?


no just jack the vehicle and go through the passenger fenderwell, its there and you do not have to remove the p/s pump

Jul 25, 2008 | 1994 Isuzu Trooper

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...