Question about 2005 Chrysler Town & Country

Open Question

Location vss wire color code 2005 chry town and country

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

chryslertech
  • 115 Answers

SOURCE: low speed fan relay for the 2005 chrysler town and country

If you are talking about the cooling fan relay for the radiator there is no low speed and high speed relay. There is only one relay and it is behind the grill revitted to the bumper rail. It is doesnt look like you typical relay.

Posted on Mar 08, 2009

dsacco86
  • 1077 Answers

SOURCE: check engine light on 2005 town and country 3.3

(DTC) CODE # P0700....Transmission Control System (MIL Request)

Translation:
Transmission Control Module (TCM) Malfunction or Failure.

P0700 Information Code

The Transaxle Control Module (TCM) monitors the malfunction of sensors and actuators relating to transaxle control. If any malfunction is detected, the TCM informs the PCM by sending a signal (P0700 code). P0700 means that a code has been set in the TCM.

This code is for information ONLY. If this code is present, check for transaxle codes.


P1776: Solenoid Switch Valve Latched in Low/Reverse Position. The TCM monitors the L/R solenoid to ensure that the fluid transfer happens. It uses a Pressure switch to verify this. Usually this code is set by a switch that is stuck or a solenoid that is not mechanically operating.

A transmission shop would be better suited for this type of work.

Posted on Apr 11, 2009

  • 3600 Answers

SOURCE: MAP or MAF Sensor Diagram for 2005 Town&Country Touring Van 3.8l.

Yes it has a sensor and they are color coded however I don't think it's called a maf or map sensor that’s a GM name, there would be three wires on it on ground one 5 volts reference and one for connection to the computer to tell the computer how much air flow there is, and the reading would be from 1.5 volts to 4 volts.

Posted on Jun 22, 2009

  • 117 Answers

SOURCE: 2005 crank position sensor location

The crank shaft sensor on that model should be on the driver side towards the back of the tranny its not hard to get to.

Posted on Jun 27, 2009

johnjohn2
  • 5763 Answers

SOURCE: Replacing a thermostat in 2005 Town and Country Mini Van

yes you are correct.

Posted on Nov 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2005 Chrysler Town & Country 3.8L V6 . just started misfiring


possible bad injector - recomend have injector checked and or do compression test on cylinder # 2

Jul 07, 2012 | 2005 Chrysler Town & Country

1 Answer

Belt keeps slipping off my 2000 chry town and country


Most commonly the pully is worped, If you have 'nt replaced the bely it could be ***** out.These are what usually make this happen, Good luck to you.

Apr 12, 2011 | 2000 Chrysler Town & Country

1 Answer

Changing out thermostat in Chry. 2001 Town and


Buy a thermostat, a thermostat gasket, and some blue sealant (RTV) from any auto parts store. On the driver side of the engine, there is a radiator hose that connects to the engine just under the wires for the spark plugs. There are two bolts. Remove the bolts and pull off the hose. Some coolant will leak. Remove the old thermostat and gasket. Note how the thermostat is oriented so you can replace the same way. Put the gasket and thermostat back using some of the sealant and then re install the bolts. Total cost is around 15-20 dollars. Feel good that you saved a few hundred bucks and only takes about 20-30 minutes.

Jan 29, 2010 | 2001 Chrysler Town & Country

1 Answer

2005 chry tc van 3.8 eng code po 406


hi you have a failure on your exhaust gas sensor < erg solenoid >

Nov 19, 2009 | 2005 Chrysler Town & Country

2 Answers

HAve a 2003 Chry. Town & Country, 124K. The


Try output sensor for the transmission (it is similar to a vehicle speed sensor), these can control the speedo and shifting. Not sure if it does anything to the rpm guage, but very possible.

Nov 14, 2009 | 2003 Chrysler Town & Country

1 Answer

Need info on a shift solenoid for 97 3.8 liter chry town an country


The shift solenoid is a valve that controls shift timing.
The solenoid pack is located inside the transmission on top of the valve body.

It looks like this...

a5567fa.jpg

Oct 18, 2009 | 1997 GMC Jimmy

1 Answer

MAP or MAF Sensor Diagram for 2005 Town&Country Touring Van 3.8l.


Yes it has a sensor and they are color coded however I don't think it's called a maf or map sensor that’s a GM name, there would be three wires on it on ground one 5 volts reference and one for connection to the computer to tell the computer how much air flow there is, and the reading would be from 1.5 volts to 4 volts.

Jun 20, 2009 | 2005 Chrysler Town & Country

Not finding what you are looking for?
2005 Chrysler Town & Country Logo

Related Topics:

135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...