Question about 1997 Ford F150 Regular Cab

1 Answer

Had starter rebuilt, bolted back in, reconnected wires, try to start and it just clicks. Any ideas?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Ford Master
  • 22,156 Answers

The earth strap from the engine to the chassis ,check for a feed to the heavy cable as well in case its not getting power ,if it still doesnt work then buy a genuine bosch exchange unit

Posted on Nov 06, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

It clicks then stops won't turn over

bad starter or drained battery. if it clicks and lights are bright, most likely the starter. easy fix if starter. starter is bolster in with just two bolts. two more bolts connect the wires. I've found best price on starters at amazon prime. branded new starters for same price as autoparts stores sell used rebuilt unbranded started. also, no core charge and no shipping old back. great deal. with luck you also will find a video showing replacement on your truck. good luck

Mar 19, 2015 | 2006 Ford F-150

1 Answer

2000 mountaineer won't start or crank over batt good all connections good even try jumping it

You'll need to check your starter. It's typically accessed under the car. Sounds like that went out on you. If you hear a click / ticking sound when you try to start the car but it will not turnover (run), it could be a bad battery. If no click / tick, most likely the start has gone bad. It's not hard (a bit dirty) to pull it out and take it to a Auto store to get it tested. If you are handy, slide under the car and look around / near where the engine connects to the transmission (see picts online - lots around). There should be an electric motor like device (about 5 inch round and 7 inch or so long) with 2 or 3 wires coming from it. It will be secured by typically 2 bolts. Remove the negative lead from your battery and then go back under the car and disconnect the 2 or 3 wires). These are typically secured with small nuts (about 1/2"). Remove the wires and then the 2 securing bolts and pull it our - same direction as the bolts. Take down and have it tested for free at any major auto parts store. They can sell you rebuilt ones - I find them fine. Replace it (assuming its bad) the opposite as you took it out, reconnect the battery and you should be good to go. Best of luck (no worries, it's easy).

Mar 09, 2015 | 2000 Mercury Mountaineer

1 Answer

1998 S-10 will not turn over

have u reconnected ground wire to engine and chassie

May 03, 2013 | 1998 Chevrolet S-10 Pickup

2 Answers

How to put in a starter on a 1993 mercury marguis

get a lift
buy a new or rebuilt starter
drive the car onto the lift
disconnect the negative battery cable
put the car up in the air
disconnect the wiring from the starter, use your cell phone camera to take a picture before removing the wires
take the top and bottom bolts out which hold the starter to the bell housing
pull starter out and down
put new starter in and put bolts back in
look at cell phone picture and reconnect wiring the same way
let car down and reconnect battery
you are done

Jun 25, 2011 | 1993 Mercury Grand Marquis

3 Answers

How do I change the starter?

first unhook the battery! then unbolt the cables from the back of the starter! be sure to mark them with masking tape, or something you can use to identify what wire goes where! then unbolt the starter bolts from the starter, and remove it! reverse this to put new starter back in!

Mar 04, 2011 | 1996 Ford Explorer

1 Answer

Turn key and get nothing. had starter rebuilt. still get nothing when turn key to start. used a tester power to starter. but when hooked to wire that hooks to cylinoid, light doesn't light up...

When you rebuilt the starter if you didn't replace the solinoid that is probably the problem providing the wiring was reconnected correctly.

Dec 04, 2010 | 2000 Kia Sephia

1 Answer

How do i put the starter on the car myself?

undo the possitive battery cable jack car up in front place jack stands under the A arms for support unbolt starter from transmission & all wires get new starter & replace all wires on new new starter put starter back in bolt it down & make sure all bolts are tight & reconnect battery & it sure start

Nov 10, 2009 | 2000 Dodge Neon

1 Answer

How do you change the starter on a 2005 ford expedition

The answer will vary - depending on the engine you have...Generally, you first remove the neg. cable from the battery.
Then you remove the 2 (or 3) wires from the starter.
Then you remove the 2 bolts that hold the starter to the bell housing.
Lube the bolts (must be clean too) - place the new starter... install the bolts... Torque to about 30 lbs .... the reconnect the wires to the new starter.
Finally reconnect the neg battery cable and start your Expedition!!

Oct 09, 2009 | 2005 Ford Expedition

1 Answer

Bad starter. how do you remove. how many bolts are there??

once you have located the starter ther are two bolts and two wires the bolts are located directly accross from eachother on each side of the starter the wires are on the back of starter hope i could help

Mar 23, 2009 | 1986 Chevrolet Celebrity

Not finding what you are looking for?
1997 Ford F150 Regular Cab Logo

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers


Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides