Question about 1996 GMC Yukon

1 Answer

My rear is knocking

When i drive a hear a loud knocking sound in th rear of my vehicle i took it to a mechinic ande he told me it was my baerings not so same noise can you help me . i think its my rear axle thats shoot

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 21 Answers

Check u joints

Posted on Jul 12, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Transmission make loud sound when put it in revers


PLEASE HELP! SOS! car starts but doesnt move! - Club3G Forum ...

www.club3g.com > ... > Performance & Tech Forums > Problem Reports

Nov 16, 2010 - 61 posts - ‎14 authors
now yes, i will take the transmission is fubar into consideration but theres an .....however... idk about my cv joint, my car ONLY would make a loud ping noise when i move from a stop or brake ..... almost always when i put it into reverse. such as an engine mount sound, ... Vehicle: 2004 Eclipse Spyder GT. Loud knocking sound after oil change..
14 posts
Sep 20, 2010
Horrible noise upon start when cold
21 posts
Dec 24, 2009
Sporty knocking.. Oh noez!!one!!1!
16 posts
Mar 22, 2006
More results from www.club3g.com

Loud thump when I shift into drive or reverse - CarGurus

www.cargurus.com > Questions > Chevrolet > Cavalier

CarGurusDec 19, 2012 - And while driving loud thump when car motor shifts th... ... Bad throttle position sensor can trip both lights and make the transmission shift at high rpms and shift hard even under light acceleration. .... the transmission will shift hard when firstput into reverse or drive ... 2004 Chevrolet Cavalier LS For Sale.Missing: mitsubishi ‎eclipse

Mitsubishi Transmissions & Drivetrains Repair Questions ...


Dec 06, 2015 | 2004 Mitsubishi Eclipse

3 Answers

Steering is swirving my 2000 oldsmobile silhouette van and I hear a knocking sound


I am not familar with this modle vehicle but the knocking could be worn shocker or busher ,wheel baering could be in bad need of ajustment this could cause problem with steering also steering box
track rod end and kingpin and bush also rack and pinon,

Sep 11, 2014 | 2000 Oldsmobile Silhouette

1 Answer

I have a 2003 nissan xterra and when I crank it up a loud knocking noise can be heard I do mean loud. I took it to autozone a while back when the check engine light was on and they said I needed a new...


I would have to be there to hear it. You may want to have it towed to a shop to get their opinion.
A knocking noise is usually a rod bearing or other internal engine part, and very serious damage can result.

Jul 03, 2013 | Cars & Trucks

1 Answer

Loud knocking sound


They did not hear the noise or did they not drive the truck ?
It could be something in the brake system too.

Jul 24, 2012 | Chevrolet Suburban Cars & Trucks

1 Answer

Knocking noise


Hi Janay, It would not take a good mechanic more than lifting the hood and listening to the engine to determine that the engine had knocked. By all means have someone else have a listen and a look and wait to hear the diagnosis they give. It's always a good idea to have a vehicle serviced on a regular basis. If you needed to add oil, to have the sound of the engine change, It sounds like you didn't bother? If the engine knocks more when you apply gas it seems to me that the connecting rod bearings and the small end bearing have both been damaged by the lack of lubricant (Engine oil). If you like the vehicle replace the engine, if not replace the vehicle. Regards John

Jun 07, 2012 | Jeep Grand Cherokee Cars & Trucks

1 Answer

I took the car for repair and they fixed my oil pan valve cover gasket and the oil pan gasket. they put the knock sensor wire direct to the knock sensor since they didnt have a connector. i drove off and...


the knock sensor changes the timing of the motor when it senses knock ,it sounds like the wire may have come off ,it sounds as if when you press the gas the timing should advance and it sounds as if its not advancing thats why you are hearing a clattering noise on accelerating.if you keep driving it like that you can do engine damage

Mar 03, 2011 | Toyota Tercel Cars & Trucks

1 Answer

Loud knocking and sluggish engine


Loud knocking is usually not a sound you want to hear. Sounds like serious engine damage but I maybe wrong. Someone has to physically look at the vehicle

Feb 24, 2010 | 2000 Dodge Caravan

2 Answers

Backing up very loud grinding like bearings


I would investigate the transfer case. By your description here it sounds as if the gears inside are worn and the drive chain inside is rubbing, causing the loud noise you hear.

Nov 20, 2009 | 2002 Chevrolet Suburban 2500

1 Answer

02 Lancer ES help with diagnosing left side of Engine Vibration noise.


sounds more like a wheel bearing,jack the car up and support with axle stands,then grab the front left wheel at both sides and shake it hard.then grab it at the top and bottom and shake it hard.if a knocking can be felt through the wheel then its most likely a wheel bearing.repeat the test for the rear wheel.also with the vehicle jacked up,spin the wheel and put your ear next to it,if it makes a dry whirring or grinding sound as it spins,this is a symptom of a worn wheel bearing

Oct 11, 2008 | 2002 Mitsubishi Lancer

Not finding what you are looking for?
1996 GMC Yukon Logo

Related Topics:

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...