SOURCE: my battery cable was disconnected
You need an unlock code for it. It should be in the owner's manual, but if not, take your registration, title, and photo ID to the dealership. They can look up the code based on the VIN number of the vehicle, but it can cost you anywhere up to an hour's labor (that varies by dealer).
SOURCE: 1999 Chevy Blazer Starter
the starter is located on the passenger side lower motor. it has two bolts in it that hold it in place. it actually goes through a hole/slot in the transmission to the flex plate.
1st. disconnect the negative cable on the battery.
2nd. raise the vehicle safely and place a jack stand under the vehicle out of your way but near where you will be working(for safety).
3rd. remove the two bolts that hold the starter in place.
4th. remove the wires from the back of the starter.
5th. install in reverse order of above.
note: there may be little plates between the starter and the mounting points called shims. if there are then make sure you put them back.
SOURCE: 1999 Chevy S10 Blazer 4x4. Replacing rear pad's,& Bleeding Breaks
have one person in the blazer pumping the brake pedal and then hold to the floor, crack the bleeder then tighten, release pedal, repeat till all air is out one side at a time, if this does not work then your ABS unit is bad witch if u follow your lines from your master cylinder u will find a black box with a motor on it, or the master cylinder itself is bad, it also can cause u to have no pedal, replace the master cylinder first, most likely cheaper.
SOURCE: 1999 chevy blazer distributor cap diagram
need 8th digit of vin and engine size, email address to send diagrams to you
SOURCE: where is the fuse located for the cruise control
there you go,thank you for using FixYa.com, Lee
415 views
Usually answered in minutes!
×