Question about 2007 Acura MDX

1 Answer

Acura MDX 2007 Navi Shows Check Engine Oil Level, Low Oil Pressure Indicator but oil level is fine

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,902 Answers

Check your oil pressure switch located next to the oil filter. Sounds like that will need to be replaced.

Posted on Nov 06, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Code B256 on acura mdx 2007?


Acura Service Codes

A: Replace Engine Oil
B: Replace Engine Oil and Filter. Inspect various systems and components

1: Rotate Tires and check tire pressure and condition
2: Replace air cleaner element, check drive belt and replace dust and pollen filter
3: Replace transmission fluid and transfer fluid (if equipped)
4: Replace spark plugs, replace timing belt (if equipped), inspect water pump, and inspect value clearance
5: Replace Engine Coolant
6: Replace rear differential fluid (if equipped)

Mar 08, 2015 | 2007 Acura MDX

1 Answer

201 Lincoln 4.6 v8,no oil pressure,was fine when shut off last nite this morning no oil pressure??


Do not run engine further. The indicator light shows oil pressure but not oil level. You could be out of oil.

Check your oil level immediately--with the engine off, open hood, remove dipstick, wipe it clean. Insert it and extract it again. The oil level.should be between the Fill and Add lines. If it is lower than that, add oil, a quart at a time, until it reaches the proper level.

If the oil level is okay, then the engine needs to be repaired. You could have a broken oil pump, clogged intake screen, or some other internal engine failure. Do not drive the car to a shop. Have it towed.

Mar 02, 2015 | 2001 Lincoln Town Car

1 Answer

What does A1236 code on Acura MDX mean?


Acura Service Codes

A: Replace Engine Oil
B: Replace Engine Oil and Filter. Inspect various systems and components

1: Rotate Tires and check tire pressure and condition
2: Replace air cleaner element, check drive belt and replace dust and pollen filter
3: Replace transmission fluid and transfer fluid (if equipped)
4: Replace spark plugs, replace timing belt (if equipped), inspect water pump, and inspect value clearance
5: Replace Engine Coolant
6: Replace rear differential fluid (if equipped)

Apr 29, 2014 | 2007 Acura MDX

1 Answer

2005 grand Prix oil pressure light an dinging comes on


1. Check your oil level. If oil level is not ok, correct oil level and find out why oil level was low and correct the problem. (Leaks, bad PCV, Burning oil due to severe engine wear, nobody has bothered to check it for the last 3000 miles, WAY overdue for an oil change, etc.) If oil level is ok, proceed to next step.

2. Remove the oil pressure sensor and install a manual oil pressure gauge. Run engine to verify low oil pressure. If gauge shows that the oil pressure is low, overhaul or replace engine. If oil pressure is ok, replace oil pressure sending unit and retest.

Mar 06, 2012 | 2005 Pontiac Grand Prix

1 Answer

Oil pressure indicator lamp illuminates intermittently


1. check oil level now! If low, add as needed, and keep checking regularly.
2. If level is OK, check oil pressure switch (or sending unit), and the connections at the switch.
3. Have the oil pressure measured by a good mechanic. If the pressure is good, it means that the problem lies somewhere in the pressure sensor or indicator circuit. If the pressure is low, there is a problem in the engine - either a clogged oil filter, bad oil pump, or blockage within the engine.

Nov 28, 2011 | 2002 Jeep Liberty

1 Answer

I did engine oil change at a local garage and the oil level shows 100%. But "CHECK ENGINE OIL LEVEL" sign is on and off.


Try unplugging and reconnecting the connector a few times. It will be close to the bottom of the engine oil pan. Might even be loose.

Aug 29, 2011 | 2007 Acura MDX

2 Answers

I have a 2000 chevrolet venture and the low oil pressure light is on is this the oil pump or could this be the oil sending unit


I WOULD CHECK OIL PRESSURE FIRST, IF OIL PRESSURE OKAY,OIL PRESSURE SENDING UNIT FAULTY MORE LIKELY.IF OIL IS LOW YOU WILL HEAR RODS KNOCKING NOISE.

Jul 13, 2011 | 2001 Chevrolet Venture

3 Answers

I had my oil changed in my 2007 Acura MDX this morning and the Honda Dealership had no idea how to reset the indicator. How do I do this?


Courtesy of oilreset.com:
Turn the ignition to (II) - do not start the engine. Press the SEL/RESET button on the steering wheel repeatedly until engine oil life is displayed. Press and hold the SEL/RESET button for more than 10 seconds. The remaining engine oil life reset mode will be shown on the multi information display. Select RESET by pressing the INFO (??²/??¼) button, then press the SEL/RESET button to reset the engine oil life display. The maintenance item code(s) will disappear, and the engine oil life will reset to 100. Turn the ignition off and then start the engine to verify the indicator has been reset. *Models equipped with the keyless access system have an engine start/stop button instead of an ignition switch. Pushing start/stop button once without starting engine is equivalent of ignition (II).
Best of luck! Greg

Jan 28, 2011 | 2007 Acura MDX

1 Answer

I have a 2007 acura mdx. i need to turn off the the oil service notice on the dash. how would i do it?


you could check the oil pressure and check the oil pan for damage. if the pan has been banged in, then the pressure increases.

Jan 10, 2011 | 2007 Acura MDX

1 Answer

BLINKING OIL LIGHT


Yes....Check oil level. Listen for tapping noises from engine....Change oil, have someone put a pressure gauge on engine (a real mechanical one) If pressure is OK, change oil pressure sending unit. If pressure is low, you have a real problem (internal wear) If so, consider a rebuild or replace vehicle.

Nov 17, 2008 | 1994 Acura Integra

Not finding what you are looking for?
2007 Acura MDX Logo

1,192 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...