Question about 2007 Toyota Land Cruiser

1 Answer

Hello How are you, we just bought a car and there is water sreaks in the windows do u know how to remove them

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 116 Answers

If the streaks are on the outside, clean glass with denatured alcohol on a rag (wear gloves). scraping with NEW razor blades may help. if all else fails, try vinegar.

Posted on Nov 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hello - I just bought a 2004 Jetta - day one - mil light came on. Car runs fine. What could it be? 2 mechanics checked the car over before I bought it and carfax said it was one owner no problems.


Have VW check it out. I had just got my 04 GLI with 70,000 miles when the light came on. The thermostat triggered the light and so I had the whole timing belt, thermostat, and water pump service. Worth the money.

May 21, 2010 | 2004 Volkswagen Jetta

1 Answer

My window will not go down on the driver side window


just change once-again after installing one by one separately and cheek the options of motor regulator of 2002

Mar 20, 2010 | 1999 Pontiac Grand Am GT

1 Answer

Water leak passager floor rear


Hello there:
THIS CONDITION MAY BE CAUSED BY AN INADEQUATE SEAL AT REAR WINDOW OR THE SIDE PANES SEALS BY THE DOOR CONNECTION, OR EVEN THE TRUNK SEAL YOU MAY EVEN HAVE A LEAK IN THE FRONT AND IT COULD BE RUNNING TO THE BACK WHEN DRIVING
SO WHAT I RECOMMEND IS TO INSPECT ALL OF THE SEALS AND IF YOU NEED TO USE A GARDEN HOSE AND START AT ONE AREA OF THE CAR AND RUN WATER OVER LETS SAY THE REAR WINDOW AND THAN CHECK TO SEE IF THERE IS ANY STANDING WATER AND ONCE YOU GET TO A POINT THAT YOU FIND WATER YOU WIL KNOW WHERE IT IS COMING FROM OK?
BEST REGARDS MICHAEL

Nov 14, 2009 | 1988 Pontiac Sunbird

2 Answers

Driverside window wont go up! motor works but seem like the control wires are not connected cables are loose can this be fixed


Hello Sir.
Welcme To Fixya's Community.


  1. Remove the rear door trim panel, as outlined in this section.
  2. Remove the plastic sheet water deflector.
  3. Remove the window-to regulator bolts by raising the window far enough to gain access to the bolts through the door metal.
  4. Raise and securely tape the window in the full up position.
  5. Detach the electrical connector.
  6. Remove the mounting bolts and remove the regulator from the door.
  7. If the motor is to be replaced, simply unbolt the motor from the regulator.

To install
  1. If the motor is to be replaced, install the motor to the regulator. The motor can be installed with the regulator in any position. Tighten the bolts to 89 inch lbs. (10 Nm).
  2. Install the regulator to the door and install the mounting bolts. To ensure proper orientation of the window regulator to the door, it is very important that the window regulator bolts are tightened in the specified sequence. Tighten the bolts to 89 inch lbs. (10 Nm) in this sequence.
    1. Lower Right
    2. Upper Right
    3. Lower Left
    4. Upper Left
  3. Attach the electrical connector.
  4. Carefully untape the window and lower the glass far enough to gain access to the bolts through the door metal. Tighten the bolts to 89 inch lbs. (10 Nm).
  5. Install the plastic sheet water deflector.
  6. Install the door trim panel, as outlined in this section.
Thank You For Using Fixya.

Please give a good feedback, also let me know if you need any further Info.
Good luck.

Fixe_You ^^

Jun 25, 2009 | 1999 Pontiac Grand Prix

1 Answer

How to change Water Pump.


Remove the radiator upper hose. Remove the emmision control canister. Loosen the alternator belt. Remove the fan blades and the alternator pulley. Now the pump is all exposed for removal and replacement. Just do the reverse when putting all things back.

Apr 25, 2009 | 1994 Suzuki Swift

1 Answer

Leaking water pump


hello,yes you can do it,first remove negative cable of battery,remove all belt,remove engine fan,shroud,water pump pulley,then remove water pump,installing in vise versa, ty

Apr 22, 2009 | 1986 Mercedes-Benz 300

4 Answers

Water swishing about in trunk of Honda CRX del sol 1993


check all the rubber seals and rear lights, water tends to get trapped in those areas

Feb 21, 2009 | Honda CRX Cars & Trucks

1 Answer

Water pump


I don't have pictures for you but here is instructions:
Drain all the coolant.
Jack up the car on the front passenger side.
Remove the passenger side wheel.
Put a jack under the oil pan.
Detach the engine mounts on the passenger side of the car.
Remove all external belts.
Remove the upper timing belt cover bolts
Lower the engine using the jack.
Remove the water pump pulley. (3 bolts)
Remove the upper timing belt cover.
Disconnect the coolant line running across the front of the engine from the water pump. (2 bolts on a flange)
Pull the timing belt.
Pull the water pump.
Installation is just reversed.

If you need images, go to your local library. I never bought a manual, where is the fun in that? LOL plus everything I need to know can be found on the internet.

Oct 11, 2008 | 1989 Ford Festiva

2 Answers

Ford focus radio display is out


The display of the radio has micro contactes around the edges of the display. The cleaning agent used to clean the dash area could have been damaged. Best reccomandation is to have the unit replaced or taken to a repair shop and have the face plate repaired.

May 29, 2008 | 2003 Ford Focus

Not finding what you are looking for?
2007 Toyota Land Cruiser Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...