Question about 2000 Ford F350 Super Duty Super Cab

1 Answer

I need to drain the marked fuel in my tank to replace it with unmarked what is the easiest way without drilling a hole in the tank

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 87 Answers

At wal-mart you can buy a suction bulb tube which you can place tube down the tank and siphon the fuel out.

Posted on Nov 06, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Easiest way to drain my gas tank on my 02 Chevy Impala

Hot wire the fuel pump to a 12 volt source and collect fuel by line to fuel rail.

Feb 26, 2017 | 2002 Chevrolet Impala

1 Answer

Easiest way to drain 2004 VUE fuel tank. AWD w/ V-6

easiest and safes way is use a vaccume evacuator pump and catch tank , but I do suppose you could siphon it too !! but be carefull !! and don't use a drill powered pump , that's too dangerous !!

remember gasoline dissolves most plastics !!!

Dec 21, 2016 | Cars & Trucks

2 Answers

Fuel pump on vg holen ute not working. Relays and fuses fine I'm thinking its packed it in. How can u find out for sure without geting stuck in and probally have to drop the tank??? Thanks. Ryan

When I have to get at a fuel pump in the tank off my car . I take out the back seat and cut an access panel , so I do not have to drop the tank. You can also cut and access panel if it is in the truck of the vehicle .
Drill a couple of holes carefully ( make a stop on the drill bit by using a piece of pipe ; make sure that the end of the drill bit is sticking out just enough to go through the tin and not hit the tank . I use a vise grips to locked on to the pipe with my left hand and drill in the right . ) , take a tin snips to cut the hole to the size you need , then pull the pump and replace it . then take a piece of sheet metal and a tube of seam sealer ( That you buy at auto parts store ) . Make sure you use the seam sealer to keep the exhaust out !!!!! Good luck and Remember that once you have the hole , you can check the wires at the fuel pump ; to see that it is getting power when you turn the key , before pulling the pump .

Aug 11, 2014 | Cars & Trucks

1 Answer

Ford fiesta fuel is there a drain off on the 1.8tdi tank

drill a hole in it with a cordless drill and catch the fuel.

May 20, 2014 | Ford Cars & Trucks

1 Answer

Replacingn Fuel Sending Unit

If you have access to it without removing the fuel tank, there is no reason to drain the tank. Just relieve the pressure. Have rags handy when the lines are pulled apart to catch fuel drips. Clean the area well around the pump assembly to tank mounting hole. Use an air compressor if available, or just make sure no dirt falls into the tank after the pump is removed.

May 16, 2013 | Cars & Trucks

2 Answers

Do you have to drop the fuel tank on a 2003- 4 cyl - Chevy Tracker to replace the fuel pump or can you access it by removing the back seat?

sorry but you do have to remove the fuel tank there is no other time is 2.6 hours so its not that bad a job would make a good weekend project.

Sep 14, 2011 | 2003 Chevrolet Tracker

2 Answers

Where is the fuel tank and fuel lines located? I need to drain the fuel tank as the car has been totaled due to front end damage and has a full fuel tank.

Since you are totaling the car why don't you drill a hole in the tank and catch the fuid in a container, it's still a pain to remove the tank and try to pour into a container (takes three people to do it, two to handle the tank and one to hold the container)

Aug 26, 2011 | 2002 Chrysler Concorde

1 Answer

Front passenger side floor soaking wet,is aircon overflow blocked ?

It probably is blocked and i think the easiest way to unblock it is to drill a hole in the bottom of the heater box.You can pick up a plug at the dealer to block the hole you drilled. The drain tube is located inside the frame so it cant be blown out thats why you have to drill the hole. Call the dealer and he will tell you what size hole to drill

Mar 19, 2011 | 1998 Jeep Grand Cherokee

2 Answers

Having what i assume is a fuel system problem. I've replace the fuel filter, fuel pump, sending unit, and fuel relay all with brand new parts, but the car will either not start or die while i'm driving...

Once the car has died, open the fuel cap. If you hear a sound like air being sucked into the tank though the filler pipe, you may have a blocked breather pipe on the tank. Safest bet would be to locate the pipe and remove whatever the restriction is. Easiest would be to drill a 1mm hole as close as possible to the top of the filler pipe, although it is not recommended due to fuel/vapour release.

May 31, 2010 | 1993 Buick LeSabre

1 Answer

How do you drain fuel from a 1993 ford thunderbird

drill a small hole in the tank and let it drain out into a container

Sep 16, 2008 | 1993 Ford Thunderbird

Not finding what you are looking for?
2000 Ford F350 Super Duty Super Cab Logo

Related Topics:

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides