Question about 2000 Lincoln LS
Remove the steering knuckle from vehicle
Remove the wheel hub and bearing assy
Remove the ball joint
Moog --Problem Solver Bulletin (Oct 2010 Brake and Front End, Publication)
Lincoln LS 2000-2001 Part # K500084
2002-2005 Part # K500085
Posted on Nov 05, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Dec 06, 2015 | Dodge Cars & Trucks
Oct 05, 2012 | Cars & Trucks
Jan 31, 2012 | 1991 Mercedes-Benz 420
Jan 22, 2012 | 2001 Ford Expedition
Jan 17, 2012 | 1997 Chevrolet Lumina
To perform the following procedure, the lower control arm must be removed from the vehicle. Refer to Removal And Installation for that procedure.
NOTE: When installing ball joint in lower control arm, position the ball joint in control arm so notch in ball joint stud is in the direction shown. This will ease assembly of the ball joint to the steering when installing pinch bolt.
CAUTION: Do not use an arbor press to install the sealing boot on the ball joint. Damage to the sealing boot will occur if excessive pressure is applied to the sealing boot when it is being installed.
CAUTION: A replacement ball joint is not pre-lubricated. Properly lubricate the replacement ball joint using Mopar Multi-Mile grease or an equivalent. Lubricate ball joint after seal boot is installed but prior to top of seal boot being pushed down below notch in ball joint stud. Air must vent out of the seal boot at notch when grease is pumped into ball joint, failure to do so will balloon and damage seal boot. Do not over grease the ball joint, this will prevent the seal boot from pushing down on the stud of the ball joint.
CAUTION: After the ball joint is properly greased, clip the end of the grease fleeing off below the hex. The ball joint seal boot is non-purgeable and further greasing is not required and can result in damage to the seal boot.
Mar 07, 2011 | 2000 Dodge Caravan
Apr 26, 2010 | 1988 Pontiac Grand Prix
Nov 30, 2009 | 2002 Oldsmobile Bravada
Oct 08, 2008 | 2004 Toyota Tacoma
Sep 12, 2008 | 2002 Chevrolet TrailBlazer
388 people viewed this question
Usually answered in minutes!