Question about 1990 Ford Bronco II

1 Answer

Keeps shutting off when cold, cant accelerate, tries to stall after stopping. also if you can give me name & phone#, of a shop with obd1 daignostics,

Posted by on

  • George Hels
    George Hels Nov 05, 2010

    Have you checked for cracked / off / missing vacuum lines? spray under the hood around the motor with carb cleaner spray in 1 second bursts - when rpms go high there's your problem. Where are you located? You should be able to get me a message directly through fixya by responding to this communication.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 133 Answers

Do not know where you are located, but every shop should be able to scan and have obd and obd2 connection capabilities.

Posted on Nov 05, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The car keeps stalling splutters then stops running


Hyundai Elantra Questions - Engine stalls / hesitations at ...

www.cargurus.com > Questions > Hyundai > Elantra

CarGurusApr 20, 2013 - Engine stalls / hesitations at idle and low acceleration - Model: 1999 Hyundai ... stopped... and then at one last desperate pump of the gas pedal, the ...Despite all this, most of the time, the car runs smoothly, and several shops have .....Keep in mind that my car is Elantra 2001 with 82k miles on it, the car will ...

My car keeps shutting off when idle.. - CarGurus

www.cargurus.com > Questions > Chevrolet > Impala

CarGurusFeb 15, 2013 - whenever im on breaks or, it stutters for then cranks right back up. ... of your question, the stalling, hopefully somebody will come by to help you on that. ....Car having trouble starting,rough idling,shutting off at stop 2 answers.

How to Fix a Car That Stalls: 7 Steps (with Pictures) - wikiHow

www.wikihow.com > ... > Cars > Car Maintenance and Repair

wikiHowThere are many things that could cause a car to stall. ... Your engine stops runningbecause it is not igniting gas in the cylinders, this occurs either because there ...

Jan 01, 2016 | Cars & Trucks

1 Answer

Why does my 1990 Daihatsu charade want to cut out and stall when giving throttle unless it's in high rpms it doesn't want to go we've replaced the fuel pump and filter could it be the injectors?


Daihatsu Charade low idle problems Questions & Answers ...

www.fixya.com > ... > low idle problems > Cars & Trucks > Daihatsu
Daihatsu Charade cars & trucks low idle problems questions and answers. ... but idles unevenly with foot on accelerator. does not want to accelerate. please . ... problem daihatsu cherade 1991. when the airconditioner is on the car stalls when changing down to a lower . ... 1990 daihatsu applause 101a 1.6lt 5spd manual.

Daihatsu Charade car keeps cutting out when stop ... - Fixya

www.fixya.com > ... > Cars & Trucks > Daihatsu
Daihatsu Charade cars & trucks car keeps cutting out when stop questions and answers. ... 1997 Daihatsu Charade CS G203 1.5i manual stalling when warm ... gear) while accelerating or when coming to a stop and you take it out of gear and ... 1990daihatsu applause 101a 1.6lt 5spd manual car starts normaly. when auto ...

Nov 17, 2015 | Daihatsu Cars & Trucks

1 Answer

Car wont accelerate


I would step on accelerator and the car would hesitate and half the time stall and shut off engine. I had the PCM flashed to more current software (tis s3114b8) and the car stopped hesitating and stalling. Cost 135 bucks at dealer although some shops can do it cheaper.

Nov 25, 2013 | 2009 Pontiac G3

1 Answer

Engine stalls but starts right back up


How long since a tune-up? To check for some codes, use a jumper wire between A and B terminals at datalink connector. Then, turn key just till dash lights come on. The mil starts flashing, you count the flashes to get the codes, your looking for two digit numbers. This is 12 pin data link connector obd1.
obd 1-wi1jyiqghwstzm451bsa0jgc-2-0.jpg

May 23, 2017 | Pontiac Grand Am Cars & Trucks

1 Answer

1991 Suzuki Swift GTi very low idle and stalling


Oxigen sensor. Check accelerator pot also, and fuel pump.

Jan 13, 2013 | 1991 Suzuki Swift

1 Answer

Veh stalls when i put it in reverse


Engine stalls cold or RPM fluctuates at idle up and down or dies near idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 (or OBD1) fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control. If the above cleaning doesn't cure your issues you need to have the computer controlled automatic idle speed control system diagnosed and repaired by a dealer or electronic engine control repair shop.

Dec 22, 2012 | 1998 Dodge Dakota

2 Answers

I have a 2001Chevy S-10. We don't drive it a lot, it only has 61K miles on it. The last few years we started having "hesitation" problems. You'll be driving along just fine, stop at a light or...


yeah, if you have to tell the shop how to repair the vehicle i would find a better reputable shop. When is the last time you did a tune up? Plugs,fuel filter,air filter,wires. Clean sensors, check intake gasket for vacuum leaks, check vacuum lines for cracks, leaks.

Mar 09, 2011 | 2001 Chevrolet S-10

2 Answers

My 1994 Camry, 4 cylinder has a major problem. This started about two months ago. At stoplights, or stop signs it idles very hard, and then when I try to accelerate, it goes very slowly, and makes awful...


Bring it to a shop and ask the to test drive it...IT SOUNDS VERY UNSAFE !...It sounds more like a transmission problem. At the shop, ask for a free estimate.

Mar 29, 2010 | 2002 Toyota Camry

1 Answer

1993 oldsmobile cutlass supreme engine stalls choking


soundl like idle air control valve sensor
try a clean .............if no better replace

Apr 30, 2017 | 1993 Oldsmobile Cutlass Supreme

1 Answer

91 volvo 240 - keeps stalling out, shakes a lot when idling


My 1990 240DL was doing the same thing and it turned out to be the fuel pressure regulator. It, unfortunatley, is a shop repair. $117 for the part and $150 for labor. It runs fine now.

Jul 09, 2008 | 1991 Volvo 240

Not finding what you are looking for?
1990 Ford Bronco II Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...