Question about 2004 Buick Park Avenue
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
When you remove the clipers you have to get very agressive with them to pry them loose. When installing the new pads, you first must compress the hydraulic cylinder that compresses the brakes when you step on the pedal by using a C clamp to squeeze the round-shaped cylinder back as far as it will go. You may experience some overflow from your brake master cylinder (refill container on the top aft of your enginee compartment) because you are removing volume from the system by compressing the cylinder. Replace the pads, then when you rassemble it will easilly fit over the rotors. Otherwise it will not go back together. Also, watch out when reinstalling the pins (the ones that hold the calipers on). They can be cross-threaded easily and you don't want that to happen. You'll know you have them cross-threaded if you have to tighten them too hard. STOP! and back them out and look carefully at the angle of the pins as you thread them in. They should not be too hard to turn. It is also a good idea to lubricate the caliper pins with grease made especially for this purpose (check with your parts store). DO NOT get grease on the surface of the pads or rotors. Brake parts cleaner spray is handy to have to clean eveything after it is assembled together. Tighten all bolts and pins A LOT! They can come out if you don't tighten them pretty well. Hope this helps.
Posted on Mar 20, 2009
SOURCE: 1997 Buick Park Avenue
This is the diagram but you should have factory belt diagram sticker is still somewhere under the hood
To replace the serpentine belt on a V6 3800 you must jack up the motor and remove a motor mount. You must then use a breaker bar with a socket (13/64") and pull it toward the front of the car to release the belt tensioner. Put the new belt on, tighten it, put the mount back on, and lower the jack.
Driving without a belt can cause the motor to overheat, will cut power steering, and will not recharge the battery, so you should probably get a tow
Posted on Jan 08, 2009
Check out this link. It may help you with your problem.
Posted on Apr 23, 2009
need to take car somewhere to have the code read with a scanner,try parts stores first some will do it for free if not the dealers have them
Posted on Sep 15, 2009
Tips for a great answer:
Sep 19, 2012 | Cars & Trucks
May 30, 2012 | 1997 Buick Park Avenue
Sep 13, 2011 | 1991 Buick Park Avenue
Mar 22, 2011 | 2000 Buick Park Avenue
Please see my tip at http://www.fixya.com/cars/r6003525-abs_traction_control_lights . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.
Feb 27, 2011 | 1995 Buick Park Avenue
Jun 14, 2010 | 1991 Buick Park Avenue
Feb 17, 2010 | 2003 Buick Park Avenue
Jul 03, 2009 | 2001 Buick Park Avenue
Feb 13, 2009 | 2000 Buick Park Avenue
525 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: