Question about 2008 Chevrolet Equinox

1 Answer

Luggage carrier slats for 2008 chev. equinox

Apparently one has to remove plastic boot on side rails to install same, how does one do so?

Posted by on

  • toughguy1313 Jul 17, 2008

    I have the same question. I don't know if they slide toward the rear of the vehicle or should be pried upwards. I'm afraid too much pressure might break the plastic cover.

×

1 Answer

I purchased them but did not have them installed. the instructions seem simple. 1 with flat bedded tool pry the plastic covers up. 2 open the latches on the crossbars and slide them into position. 3 replace plastic covers. I have not yet try to install them yet with the same worries of scrathing or damaging the covers. The illustration shows th entire cover to come up but does not give a hint to wher you should pry it from.

Anty other info would be appreciated.

Posted on Jul 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2008 chev equinox heat gauge redlines


Coolant level full? Rad fan operational? Possible defective thermostat. Worse case plugged rad or head gasket

Dec 20, 2012 | 2008 Chevrolet Equinox

1 Answer

HOW TO OPEN 2008 CHEV EQUINOX HOOD LATCH IS NOT WORKING


my hood lock is broken, the one on the hood not the latch in the car, on my 2009 Chevy equinox. how do I fix it

Apr 23, 2012 | 2008 Chevrolet Equinox

1 Answer

How to change a headlight on a 2008 chev equinox


Step-by-step instructions for replacing the headlamps on your 2008 Chevrolet Equinox are located in the Owner's Manual that came with your truck. These instructions start on page 5-45.

If you have lost your Owner's manual or for some other reason cannot find it, you can download a PDF version of it at the following link:

2008 Chevrolet Equinox Owner's Manual

Dec 24, 2011 | 2008 Chevrolet Equinox

1 Answer

Where is the fuse location for the cigarette lighter for 2008 chev malibu?


{: ) hi! Check out the rear fuse block which is on the left side of the luggage compartment, behind the left rear wheel well. Look for fuse labeled CIG/AUX 20amps.

Aug 20, 2011 | 2008 Chevrolet Malibu

1 Answer

I purchased a Hyundai 00285-03006 fully enclosed luggage carrier and the instructions are one picture with no words. The picture does not describe where the carrier is in the picture, where the rails fit...


That same luggage carrier is sold (as OEM approved equipment) for MANY different makes and models of automobiles. From what I can see, it simply clamps onto the cross-rails on your luggage rack. (Not much instruction needed) It does require however, that you have a luggage rack and a cross-rail kit. The cross-rail kit is sold separately. I would give you the part number, but the cross-rail kit varies depending on your make, model, and year.


dttech_88.gif


Cross-Rail Kit


dttech_21.jpg

May 22, 2011 | Hyundai Veracruz Cars & Trucks

1 Answer

Where is the battery in a 2008 bmw 535


BMW battery is on right side inside carrier (luggage) compartment.

Dec 30, 2009 | 2008 BMW 535i Sedan

1 Answer

I need to remove the luggage racks from my 2007 Hummer h2 SUT


I have the same vehicle and was able to remove mine with the following steps: 1) remove light behind each rear of luggage rack rail using phillips screwdriver (one screw each side). 2) remove molding underneath each light using T20 torx driver (2 screws each side). 3) Loosen cross rails nobs. 4) Side cross rails off of roof.

Nov 27, 2009 | 2007 Hummer H2 SUT

2 Answers

Location of battery in 2008 equinox


Under the Hood Drivers Side You will see a black plastic box
which holds the computer. Right in front of the fuse box, Two sets of wires comming out of it.
It needs to be removed ,the whole box it unsnaps , Under it is a larger black cover, under that you will find the battery.

Dec 21, 2008 | 2008 Chevrolet Equinox

1 Answer

Luggage rack cross rail installation


They have torx screw or allen wrench's they just unbolt look at the top and then look on the sides of these extensions as soon as you get them loose you should be able to pull them out/Please rate my response thank you very much

Dec 14, 2008 | 2008 Chevrolet Equinox

1 Answer

Installing Luggage Rack Crossbars


the trim piece is held on by an adhesive that is very difficult to remove. my suggestion is find the location where you want to install the foot part of the rack. then take a small cutting tool like a dremel and just remove that section. this way you should not have to remove the whole trim piece. please rate this........thanks

Sep 05, 2008 | 2006 Chevrolet Equinox

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...