Question about 2003 Ford Windstar

Open Question

2003 Ford Windstar interior lights will not shut off 2 lights above doorsbehind front seats and lower lights by bottom of door

Posted by on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
godspeed808
  • 125 Answers

SOURCE: Ford 2003 Windstar Interior Floor Lights Stay On

to repair this problem you must remove floor lights from seats and check the circuit for either a short or a stuck switch use a multi tester this can get to be irritating as the short may be not directly behind switch could be along wiring that runs through car my suggestion if your not electrically proficient is take it to an electromechanic shop or simply unplug the light from socket to avoid draining the battery.

Posted on Feb 06, 2009

Ad
csmock132
  • 4669 Answers

SOURCE: door lights not turning on when the door is opened

Windstars have problems with door switches. The last owner likely clipped the wires to the defective switches because the lights would not go off.

Posted on Feb 27, 2009

  • 1 Answer

SOURCE: 2003 Ford Windstar Power Window Failure

I have the same issue, but mine got a little worse as time went on. I got a new motor for and when I took the door apart I had to lower the window. so I had to plug the switches back in, and what do you know it started working. so I tested for 15 mins stiaght and it statred working every time I pushed the button. So, I would try that first before you spend over $70 dollars just for the part.

Posted on Jun 07, 2009

cobra777
  • 80 Answers

SOURCE: need fusebox diagram for 1999 Ford Windstar SE



ef07f16.gif 342512b.gif


4cdb386.gif


58765ab.gif


Hope this helps.. :-)

Posted on Jul 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why do the interior lights stay on when doors are closed and engin is off in 2003 ford windstar


one of the door switches is stuck. you can try and free up, however you need to find which one it is. try and spray pblaster, or rust renetrant into the top of the latches, and dont forget the hatch door as they usually stick the most. someone with a good scanner can tell which door switch is staying on, or the dealer can for a fee........jim

Aug 30, 2014 | 2003 Ford Windstar

1 Answer

2003 ford windstar interior lights stay on when key is taken out of ignition but work properly when key is left in after turning off. What would cause this?


there is a dimmer switch to dim the dash lights. when you turn it all the way over it turns the interior lights on it is the same switch as your headlights.

Nov 26, 2013 | 2003 Ford Windstar

1 Answer

My interior lughts won't go out when the doors are closed after the van is shut off


Could be the front electronic module. The module has a timer that holds the lights on for about 60 seconds after you exit the van.

Aug 09, 2012 | 1996 Ford Windstar

1 Answer

Door ajar light stays on but all the doors apear to be shut?? 2003 Windstar


The post sensor needs to be adjusted the most common problem is the side door sometimes it's the switch goes bad and other times the sensor has to be adjysted, the sensor will be on the door post by the passenger side door at the bottom. Look for it you will see it. Aslo the rollers go bad on the top of the door and when shut may close but will not kill the door ajar light the front upper roller assembly is the most common problem, it has three bolts you can unblot and remove and then pull it out and see if the rollers are bad if there is plastic missing or flat spots on the rollers replace them a roller kit that you can get from ford is 10 bucks and it doess all rollers hope this helsp and thanks for using fix-ya.

May 16, 2010 | 2003 Ford Windstar

1 Answer

The interior lights stay on after the van has been shut off and the interior lights will not go off. the van is a 1998 ford windstar.


it is problem with any door lock or door (switch if switch is there), if it is not going off after you make it off manual with help of lamp switch, then problem with lamp.

Jan 24, 2010 | 1998 Ford Windstar

1 Answer

Interior lights flash on and off in windstar van


is the dome switch in the correct position it may also indicate a Trouble code is it a steady blink or a few blinks followed by a series of rapid blinks ....try lowering the intensity on the switch for the interior lights it may just be connecting enough to allow it to flash rapidly the door switch may be just opening and closing just enough to cause this an adjustment may be required to fix it does it happen if you hold the door switch in the fully closed position ?

Sep 07, 2009 | 2003 Ford Windstar

1 Answer

Ford 2003 Windstar Interior Floor Lights Stay On


to repair this problem you must remove floor lights from seats and check the circuit for either a short or a stuck switch use a multi tester this can get to be irritating as the short may be not directly behind switch could be along wiring that runs through car my suggestion if your not electrically proficient is take it to an electromechanic shop or simply unplug the light from socket to avoid draining the battery.

Jan 23, 2009 | 2003 Ford Windstar

3 Answers

Interior lights wont shut off?


sounds like door switch is bad

Nov 11, 2008 | 1998 Ford Windstar

5 Answers

Inside lights


Remove "Door Ajar" switch. Clean the switch and use a graphite type lubricant (I recommend "Dry-Slide") to lubricate the actuator on the switch. Reassemble the switch.

The switches are located inside the door panels, attached to the catch mechanism.

1) Remove interior door panel.

2) Using a T-27 Torx driver, remove the 3 bolts holding the catch in the door.
2a) The door ajar switch is the only part on the mechanism with the 2-wire harness.
2b) The switch is located at the rear catch for the sliding door.

3) Using a small flat screwdriver, gently lift the black tab on the catch mechanism and rotate the switch to remove it from the catch assembly.

4) Using a rag, clean the small round actuator and apply a small amount of graphite lubricant to the actuator and work the switch so it moves freely.

5) Reassemble the catch and the door.

Jul 20, 2008 | 2003 Ford Windstar

Not finding what you are looking for?
2003 Ford Windstar Logo

Related Topics:

88 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

83810 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22413 Answers

gerry bissi

Level 3 Expert

4387 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...