Question about 1995 Dodge Intrepid

1 Answer

How do you get access to the rear turn signal lights in a 95 dodge intrepid

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 8,841 Answers

From autozone.com. Please let me know if you have any questions.

  1. Release the trunk latch and open the trunk lid.
  2. Remove the fasteners holding the trunk lining to the lower rear deck panel.
  3. Separate the trunk lining from the deck panel.
  4. Detach the lamp wiring from the wiring harness.
  5. Remove the nuts that retain the tail lamp to the lower deck and quarter panel.
  6. Remove the tail lamp from the vehicle.
  7. Remove the socket and pull the bulb out if replacement is needed.

To install:
  1. Push a new bulb into place if required, then insert the socket into the lamp.
  2. Insert the wire harness through the hole in the lower deck panel.
  3. Install the wiring harness grommet into the lower deck panel.
  4. Place the tail lamp into position on the vehicle.
  5. Install the nuts to hold the lamp to the lower deck and quarter panel.
  6. Attach the wire from the lamp to the body harness.
  7. Place the trunk lining into position on the lower deck panel.
  8. Install the fasteners that hold the trunk lining to the lower rear deck panel.
  9. Check the operation of the lamp.
  10. How do you get access - jturcotte_60.gif

Posted on Nov 05, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 dodge intrepid rear driving lights will not come on


well they could b blowed if they are not then its an electrical problem like a short

Apr 07, 2012 | 2002 Dodge Intrepid

2 Answers

Signal lights are not working,can you show me in a diagram where the flasher is located on a 1996 intrepid?


The turn signal/hazzard flasher is a small unit ( little black box, 5 prongs ) Located between the fuse box and brake peddle on a braket under the drivers side air conditioning duct. At some point and time in 1995 dodge swiched over in the middle of production so some 95 intrepid and 96 and 97 should all be the same.
ep27

Feb 14, 2011 | 1996 Dodge Intrepid

1 Answer

How do you replace the rear left signal lights


you either access the lamp from the outside of the car. Or, you open up the trunk and you'll find the access to the lamp there. they typically just unplug.

Kdog

Dec 29, 2010 | 1999 Dodge Intrepid

1 Answer

How do I access the rear tail lite assembly so I can change the turn signal bulb


Look inside the trunk -- you may have to move the liner aside -- there are three plastic wing nuts holding in each tail light assembly. Remove the nuts and the entire assembly will come out. The light sockets come out with a quarter turn twist.

Aug 16, 2009 | 2002 Dodge Intrepid

1 Answer

I need to know how to replace my turn signal bulb


it should be a twis off on top or beind the carpet if im not mistaken..

Jul 09, 2009 | 2002 Dodge Intrepid

1 Answer

Need to locate signal light flasher 2001 dodge intrepid


If you mean the flasher, which makes the turn signals and hazards to blink, then...

It's a combo flasher which operates both the turn signals and the hazard lights. To access the combo flasher with ease remove the drivers knee bolster and then remove the brake release cable end from the handles notch, then disconnect the harness from the trunk release switch. Next there will be a reinforcement panel, remove that as well. Finally locate and replace the combo flasher from behind this panel. It is a black box that has a harness connected to it with a pink wire, a black and yellow wire, a red wire, a dark blue and pink wire, and finally a black wire. To help locate the flasher either turn the turn signal on or apply the hazards and listen for its location.

Apr 17, 2009 | 2003 Dodge Intrepid

1 Answer

Finding flasher on 95 dodge intrepid


The flasher relay should be located in the fuse panel on the left end of dasboard which is visible with driver door open and there you will see a panel to remove to gain access.

Mar 17, 2009 | 1995 Dodge Intrepid

2 Answers

Need diagram fuse block 1995 Dodge Intrepid (missing panel)


Have you gone to the wrecking yard to find parts for your 95 intrepid? I know they will have a ton of them. they do here in Denver. I bet they only charge you around $5.00 for it too. Let me know if this helps. Otherwise I can email you a schematic

Dec 05, 2008 | 1995 Dodge Intrepid

3 Answers

Turn signal dodge intrepid


the relay is under the dash buy the steering column. it is a small black plastic square box

Jul 04, 2008 | 1999 Dodge Intrepid

Not finding what you are looking for?
1995 Dodge Intrepid Logo

205 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...