Question about 2006 Buick Lucerne

Open Question

How to change my front motor mount on my 2006 buick lucerne. It is the type with fluid in it

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 5 Answers

SOURCE: loud exhaust type noise in rain

I had a trooper that did the same thing (it had a GM motor). I discovered that when water hit the exhaust pipe in the front of the vehicle it warped and came loose from the exhaust manifold. When it dried off it warped back and made full contact with the exhaust manifold and was quiet again until the next puddle. It kept getting worse. The actual problem was that the clamp that held the exhaust pipe to the exhaust manifold was cracked. You needed to look very close to see the crack. Once I had the clamp replaced the problem was gone. Hope this helps.

Posted on May 22, 2009

  • 521 Answers


Battery is locate dunder the rear seat bottom cushion.

Posted on Aug 04, 2009

  • 1 Answer

SOURCE: 93 buick park ave Ultra. replacing water pump

Yes. Put a jack under the motor and remove 3 bolts from side of engine and the long center pivot bolt in mount and the 2 bolts that go top down into the frame and loosen the 2 bolts below mount. Jack up the motor until you can separate the mount, leaving the engine side in and removing the frame side. The engine side can be moved out of the way without completely removing.

Posted on Aug 08, 2009

Testimonial: "answered the question completely and thoroughly!"

  • 7 Answers

SOURCE: how do you access the windshield washer pump on

The washer pump is located on the bottom of the wash fluid bootle. you can access it by removing the front passanger fender liner..

Posted on Jan 12, 2010

  • 1 Answer

SOURCE: how to change motor mounts on a 1996 nissan altima gxe

install motor mount

Posted on Mar 13, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the starter located on a 2006 Buick Lucerne cxl

Which do you have ? LD8 or L26
Starter Motor (LD8) V-8
Center of the engine under the intake manifold
Engine Electrical Component Views
Engine Electrical Connector End Views
Starter Motor (L26) V-6
Front of the engine, below the exhaust manifold

Dec 30, 2015 | 2006 Buick Lucerne

1 Answer

The front motor mount has gone on our 2006 Buick Lucerne, also their is a bar on the right side of motor at the top . It is attached to the motor and goes back by this a motor mount as we

Anything attaching a moter to the body "should be a moter mount" and have a rubber dampener for vibrations. As for replacement It is usualy done by jacking up under the moter with a floor jack and a good size block of wood to distribute the weight to a larger area. Once it is supported you can release the bolts and slip out the old mount to replace it. Hope this helps.

Sep 12, 2014 | 2006 Buick Lucerne

1 Answer

2008 lucerne clunk

motor mounts check front mount in front of engine.

Feb 15, 2013 | 2008 Buick Lucerne

Not finding what you are looking for?
2006 Buick Lucerne Logo

Related Topics:

1,281 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

83779 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22413 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides