Question about 2004 Ford F150

Open Question

Remove and replace the ashtray on my 2004 F150 XLT

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 178 Answers

SOURCE: i have a1990 f150 xlt i replaced a fuel pump

How you doing first thing you might want to check for any leaks in your lines if okay disconnect your fuel filter try to blow threw it possible clog if okay you say the pump was installed recently when you installed the pump on to the sending unit did you tighten the clamp on the hose to the pump tight and make sure it was around the same depth as the previous check your gas level make sure theres enough for the pump to be emerged under if you then get pressure its most likelely the little rubber hose is letting the pressure out of where it clamps on your sender if not check your fuel pressure regulator faulty internal diaghram rupture good luck please rate

Posted on Aug 28, 2009

Ad
emissionwiz
  • 80668 Answers

SOURCE: WAT IS THE TORQUE SPECS ON THE FRONT SPINDLE NUT

U DON'T TOQUE A SPINDLE NUT!!! JUST TIGHTEN WITH PLIERS AND INSTALL COTTER PIN.

Posted on Mar 09, 2010

sscullys
  • 984 Answers

SOURCE: Location of the IAC value

The New Body Style 5.4 does not have an IAC, this is controlled by the throttle position motor on the side of the throttle body, and is operated by the PCM ( new body style is throttle by wire ).

If this is a 2004 Heritage or lightning ( the same body style as the 97-03 MY ) the IAC is on the back the throttle body, held on with 2 8mm screws. You would need to remove the plastic throttle body cover to get to it.
sscullys_118.jpg

Posted on Feb 17, 2011

  • 3 Answers

SOURCE: 2004 kia sorento interior storage

Both of the panels on ether side of the radio, with the vent in them, will pull straight out.
you can then access the screws to remove the radio ect.

Posted on Aug 02, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Remove Ashtray


How can I remove the entire ashtray - F150online Forums

www.f150online.com/.../315299-how-can-i-remove-entire-ashtray.html
Jan 6, 2008 - Can anyone tell me how to remove the entire ashtray door and all. I want to put ... Vehicle: 2007 ford F150 ... This is for a 2007 F150 KingRanch. ashtray/cup holder removal
Jul 7, 2011
Ashtray Removal?
Jun 11, 2009
Please help !!! Ashtray Removal on a 2000
Mar 3, 2007
ashtray/cupholder fix?
Aug 11, 200

Sep 29, 2015 | Cars & Trucks

1 Answer

Ashtray won't stay closed. how to remove ashtray assembly


The trim panel around the radio / HVAC controls needs to be removed to get to the screws.

To remove the trim panel, open the ash tray and pull on each lower corner. There are 3 spring clips on each side holding the trim in place. The 1st time you do this, they are a bit hard to pull out.

The black circles in this picture are where the spring clips are
sscullys_162.jpg

If you can just hang the panel to the side or have someone hold it, you can get to the 2 screws on the top of the ashtray assembly ( there are just above the black sides of the ash tray in the picture above ). The ash tray is pulled out and down, it is farther in the dash than it looks. Once out, you can take a look at the springs on the side / back that hold it in, to see if they broke off or fell off.

Apr 20, 2011 | 2004 Ford F150

1 Answer

How do you disconnect the ashtray light to replace the bulb in a 2004 s10 blazer?


I just did this on my 04 blazer. Remove the ashtray from the holder. There are 2 small scews in the corner of the ashtray (remove them) pull out the ashtray holder, it will only come out about 1 to 2 inches just enough to get your fingers behing the back of the holder. Here you have to removed the cig lighter connector then you could see the ashtray bulb holder, It is plastic so be careful. You have to push in and turn the buld holder. It only has 1 plastic tag on the side to hold it in place. Then you can remove the buld. It look like the old tail light buld fixtures with the slot on the side. Its easy to replace but a pain to get to.

Apr 08, 2011 | 2004 Chevrolet Blazer

1 Answer

Location of the IAC value on a 2004 Ford F150 XLT pickup with an 8 cylinder Triton engine


The New Body Style 5.4 does not have an IAC, this is controlled by the throttle position motor on the side of the throttle body, and is operated by the PCM ( new body style is throttle by wire ).

If this is a 2004 Heritage or lightning ( the same body style as the 97-03 MY ) the IAC is on the back the throttle body, held on with 2 8mm screws. You would need to remove the plastic throttle body cover to get to it.
sscullys_118.jpg

Feb 15, 2011 | 2004 Ford F150

1 Answer

Where would i find a ashtray/ drink enclosure for a 2004 f 150 heritage


Your dealer, aftermarket accessories shop, or local autoparts store should be able to supply the package. No new vehicles come with ashtrays. But, the dealers normally sell a "smokers package" for them.

May 31, 2010 | 2004 Ford F150

2 Answers

Need to replace control panel on driver door. do I have to remove the door panel


usually as the control panels are held in place but the door panel. try to sneak a peak of a repair manual somewhere or buy one as you may need it anyway to remove the door panel. each one is a little different and you can easily break the mounting clips if your not careful. it will also show where all the screws and attachment points are so you dont get frustrated when the panel wont come loose when you think you have everything released. good luck.

May 17, 2010 | 2004 Ford F150

1 Answer

WAT IS THE TORQUE SPECS ON THE FRONT SPINDLE NUT ON A 2004 FORD F150 XLT!?


U DON'T TOQUE A SPINDLE NUT!!! JUST TIGHTEN WITH PLIERS AND INSTALL COTTER PIN.

Mar 09, 2010 | 2004 Ford F150

1 Answer

I need to replace the cigarette lighter unit and don't know how to take the dash apart


turn ignition switch to on ,shift trans into neutral,i'm assuming this is a baja,remove 2 screws under lid of center console cover lift this piece out of the way now remove bezel surrounding shifter,remove ashtray,above ashtray are 2 screws holding ashtray frame in place remove those now bezel surrounding radio can be removed and now you can remove cigar lighter good luck

Aug 19, 2009 | 2004 Subaru Baja

1 Answer

My Ford F150 XLT Triton driver's side power window


window regulator failure. Check window regulator guide for damage. If damage replace!! Hopefully this helps

Jul 20, 2009 | 2004 Ford F150

1 Answer

2004 ford f150 XLT the driver side window will roll down, but it won't roll up. What's wrong?


the regulator possibly is out, I had a similar experience on my vehicle. part cost at the dealer is around 130 dollars, need to remove the door panel. change out the power window regulator, and re-assemble. this is something that is common on the new F 150 trucks, eventually you will need to replace the passenger side as well.Good luck. I hope this helps.

Mar 23, 2009 | 2004 Ford F150

Not finding what you are looking for?
2004 Ford F150 Logo

Related Topics:

480 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...