Question about 2004 Jeep Grand Cherokee

1 Answer

Check engine light on; check gages light on - 2004 Jeep Grand Cherokee

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,565 Answers

Do a self test. insert key
turn key to off-on, off-on, off-on ( on is when the dash lights come on, off is one click back)

The codes will either flash out on the check engine light in pairs of numbers, 5-5 being the end of the test. Or the codes will display in the digital odometer. write down the codes and report back

Posted on Nov 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the gages located for fuel, battery,& temp on 2002 olds bravada


Check for a blown fuse under the dash. It will be marked gauges or instruments.

Jun 14, 2017 | Cars & Trucks

1 Answer

Why does chech gage show on speedometer also check check gage light comes on


Check your oil level and antifreeze level or change your oil if the problem continues

May 16, 2014 | Ford Cars & Trucks

1 Answer

The "Check Gages" light comes on all the time now.


The "check gages" light comes on in response to the oil pressure (not oil level) gage dropping too low. Step one is to check to make sure the engine has oil pressure. Use a mechanical gage inserted directly into the engine when the oil pressure sensor screws in. If the pressure is good, you need to check the gage. Your dealer has a tool that attaches to the connector from the pressure switch that gose to the gage. He can then test the gage, cluster and circuit wiring. If that is ok the culprit is the oil pressure sensor itself. I normally don't recommend replacing parts without a proper diagnosis but an oil pressure switch is relatively inexpensive. You might want to try that first. It's relatively common anf if that's the culprit, you will save a bunch of $$$ no having to go to your dealer. If you still have a problem, you have at least eliminated one item and are only out a couple of bucks.

Nov 22, 2010 | 2000 Dodge Durango

1 Answer

Check gage light goes on intermitantly along with the temperature going to hot. At the same time the engine sounds like I turned the ac on. I also notice a loss of power. Any ideas???


The "check gage" when ever the engine coolant is high or the engine oil pressure is low. First step of diagnosis, check the coolant level and your oil level immediately and then go from there. Hopefully, this will help you to FixYa problem!

May 20, 2010 | 2004 Ford F250

1 Answer

What is the check gauges light


CHECK GAGES light (1) indicates a potential engine failure(low oil pressure, low coolant, coolant overheating) has occurred.
· Check gages and shut down engine. Gages should read as follows: Oil pressure 5 to 10 psi (34 to 69 kPa) at idle; Water Temp gage below 230 degrees (110 C).
· Check engine oil level (Para 2-11) if OIL PRESS gage indicates low reading. Check coolant level (Para 2-11) if Water Temp gage indicates high reading. Notify Unit Maintenance if levels are low.

If CHECK ENGINE light (2) is on, check engine oil pressure gage (3) and water temperature gage (4). If both indicate normal, proceed with mission and then notify Unit Maintenance. If either one does not indicate normal, stop engine immediately and notify Unit Maintenance


Oct 16, 2009 | 1999 GMC Jimmy

1 Answer

The check engine light came on it seems to run fine the only other thing i noticed is the temp gauge runs up to 210 then comes back down,it only does that right after you start it then its fine


Check engine light can be any number of reasons, dirty air filter, need oil change, or more serious engine trouble. The temp gage issue is normal, this is the computer resetting itself. My car the fuel gage and temp gage do this...don't be alarmed. Take it to Advance Auto Parts and they can run a free engine diagnostics test on it to see which error code is tripping your check engine light.


Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/matthew_d24b835e574ef6ca

Oct 07, 2009 | 1998 Chevrolet C1500

1 Answer

Check gages light comes on after truck shuts off


clean throttle body...make sure disconnect battery first

Jun 12, 2009 | 2004 Chevrolet TrailBlazer

2 Answers

Check gage light comes on for 2004 chevrolet trailblazer''


Check gauge light can come on for a number of different things, from Low fuel to low oil pressure to high engine temperatures. When the light comes on check all the gauge's and see whats causing it, one or more of the gauge's will be showing an issue, Low fuel or low oil pressure, Low battery power. Any of the mentioned things can cause it... Figure out whats causing it then you can remedy the situation...

Apr 19, 2009 | 2004 Chevrolet TrailBlazer

Not finding what you are looking for?
2004 Jeep Grand Cherokee Logo

416 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...