Question about 2001 Saab 9-3

1 Answer

Stalling no idle

Saab 9-3 2l turbo ,i need diagram of vacuum hoses and throttle body please

Posted by on

  • s1ms Jan 12, 2009

    I have the same problem, I need vacuum system diagram. I think I have a leak somewhere because of a specific noise and check engine indication.

  • Rabindra Robinson May 11, 2010

    give me the 8th and the 10th digit of your VIN and i can help you

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 25 Answers

Hi,if you want to now where is a leak ,start the car if is possible and spry the hosing pipes wen suddenly rpm increase you now where is the problem or ken be the trottle body!

Posted on Jan 16, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need a factory vaccum diagram for 2002 93 turbo saab


Go to a partstore...they show u....dont rush

Jan 02, 2016 | Saab Cars & Trucks

1 Answer

My 2002 Saab 9-5 turbo started smoking. There is oil going into the throttlebody. Is this a failed turbo or something else?


it would appear that the oil seal on the input side of the turbo may need replacing. oil at the throttle body could also be from a faulty PCV valve operation. Have the turbo inspected by an accredited turbo specialist shop. if itr is a seal then there will be traces of oil in the hose from the turbo and in the inter-cooler pipes.

Dec 27, 2014 | 2008 Saab 9-5

1 Answer

Thermostat on a saab


4 Cylinder Thermostat Removal


1. Drain the coolant by opening the drain cock or removing the lower radiator hose. Remove the lid to speed up process

2. Remove the throttle body cover on turbo cars

3. Remove the bypass hose and the pressure pipe between the Intercooler and the throttle body on turbo cars

4. Rempve the screw that holds the coolant pipe to the water pump

5. Remove the screw that holds the coolant pipe in the front left of the engine

6. Remove the hose to the throttle body pre-heater

7. Remove the thermostat housing and remove the thermostat

8. Refit in Reverse

Feb 07, 2014 | 1997 Saab 900

1 Answer

Engine vibrates in idle real bad


sound like idle speed low idle you need to remove throttle body clean entire throttle body spray cleaner down throttle body bore if cleaning throttle body dont help the dealership has to check it out.a faulty egr valve could be stuck partially open that will cause rough idle and stalling. replace air filter clean fuel injectors.your fuel system could be too lean caused by clogged fuel injectors or weak fuel pump check fuel pressure and also check all intake vacuum hoses make sure pcv valve working should have suction and make sure its in place and the pcv valve hose not cracked open or damaged.

Nov 16, 2011 | 1994 Chrysler Concorde

1 Answer

Do you know where i can find a 'vacuum diagram' for a turbo 350 transmission (1980 chevy blazer...stalls when you put it in gear)


There is usually only one vacuum connection on a turbo 350. It connects to the modulator valve on the side of the transmission. This valve uses engine vacuum to determine transmission shift points. The other end usually connects to a direct engine vacuum source. A "direct source" is a hose connection on the throttle body that has a vacuum signal available at idle. If it doesn't, then it's considered a "ported source".I have had some experience with the chevy blazer/gmc jimmy series, both the early large body models and the small body versions. The stalling when put into gear complaint is most likely caused by a bad intake gasket which is common on the older versions with the small block V8 motors. The newer versions with the vortek motors also had allot of trouble with throttle body gaskets. If these problems have not already been addressed, then there's a good chance that it will take care of the problem. Other possible sources of vacuum leaks are the pcv hose that is hard and brittle. Check the hose out carefully, especially the side that normally faces the engine. Check the throttle body bolts (carburetor bolts) for tightness. I hope that this information is helpful to you. Thank you for using Fixya.com.

Jun 07, 2011 | 1985 Chevrolet S-10 Blazer

1 Answer

9-3 Saab stalls while driving on freeway without warning and after drifting to side put in park starts right back up and drives


The problem may be a dirty throttle body. Clean the throttle body with a recommended cleaner and you might want to add some injector cleaner to your gas tank. You may also want to check your vacuum hoses and make sure they are in good repair. I hope this helps. Good luck.

May 06, 2010 | Saab 9 3 Cars & Trucks

2 Answers

2000 93 saab black smoke out of exhaust losing power wants to stall out when idling check engine light is on please respond


Sounds like you might have blown a ring on a piston. and the black smoke is oil being burned...find out what the engine code is....but a blown ring usually requires an engine rebuild to fix. Hope this helps.....sorry about the bad news

Jun 09, 2009 | 2000 Saab 9-3 Viggen

1 Answer

Engine Stalls When stopped and in Drive


Question, did you replace the throttle body, or clean the throttle plate, it will carbon up and block air needed for the idling speed to be correct. Also check for vacuum leaks, as the older vehicles didn't have good vacuum hoses. Good luck

Apr 18, 2009 | 1990 Chevrolet Astro Extended

Not finding what you are looking for?
2001 Saab 9-3 Logo

Related Topics:

733 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saab Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

yadayada
yadayada

Level 3 Expert

63801 Answers

rgbypoet

Level 2 Expert

162 Answers

Are you a Saab Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...