Question about 1999 Dodge Durango

1 Answer

My 1999 dodge durango starts but will not keep running, what will cause this

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 381 Answers

Well if the Durango starts and runs for like 15 mins and quits then won't start again untill it has cooled off a bit I would be checking the crank sensor and the pick up coil. If it starts then dies right away but will run if you hold the gas I would clean the throttle body with carb cleaner and make sure to clean around the butterfly edges inside the throttle body.

Posted on Nov 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Will a bad pick up coil stop a 1999 dodge Durango from cranking


It wouldn't stop the engine from turning over while trying to start. But it can make engine not start or run poorly

Sep 12, 2015 | Dodge Cars & Trucks

Tip

Dodge Durango Won't Start, Turns over, NO BUS on instrument cluster


1998 - 1999 Dodge Durango 3.9L
2000 - 2001 Dodge Durango 4.7L
1998 - 2000 Dodge Durango 5.2L
1998 - 2001 Dodge Durango 5.9L

The PCM has 3 connectors plugged into it. Try wiggling each connector and listen for a clicking sound, starting with the connector furthest from the front of the Durango, and the middle connector with a white top.

If this doesn't help, replace your PCM. The PCM (power control module) can get hot, causing a short or broken circuit inside the module. Replacing the module will fix the problem. If your truck dies randomly when it's hot outside, but will start back up after it cools down, this is probably the problem.

on Jun 18, 2010 | Dodge Durango Cars & Trucks

1 Answer

1999 Dodge Durango issues


Any codes? You may have a bad dash ground or need to change the complete dash.

Apr 09, 2017 | 1999 Dodge Durango

1 Answer

The fan and pulley are loose on my '99 dodge durango which is shaking my belt off into the fan, what would cause this and how can I fix it


You have a bad water pump. Have it fixed ASAP, it can suddenly get worse and send your fan through the radiator! Pretty easy to replace, should cost you around $200 total

Oct 04, 2012 | 1999 Dodge Durango

1 Answer

1999 dodge durango is hard to start. Starts with rough idle with some backfire, then idles smooth. after sitting idle for a minute it will act as if wanting to stall on takeoff! Have changed the fuel pump...


FIrst have you tried giving the engine a tune up (ie replaced the spark plugs)

Also you need to check the condition of all the vacumn lines on the engine loss of vacumn can cause poor idling.

Aug 16, 2009 | 1999 Dodge Durango

2 Answers

99 dodge durango keeps shuttin down every so often cleaned battery cables and replaced clamps on both terminals worked for a day then same thing and security light will come on if i unhook pos cable and...


2002 Durango shuts down without warning. Sit for about 30-45 min and will restart, run for a while, and shut down again. Shows "NO BUS" code. Took it to Dodge Dealer and had a diagnostic done....nothing!!! Have changed PCM, crank shaft sensor and am getting ready to RUN IT OFF A CLIFF if I can get it running long enough!!! It is a black hole and we are getting no where!! I can't even sell the dang thing!!

Aug 14, 2009 | 1999 Dodge Durango

1 Answer

1999 durango 318 no bus error,


Ussually caused by internall ecm failure.

Jun 16, 2009 | 1999 Dodge Durango

1 Answer

Po133 code on 1999 durango


The sensor is about the same as 1 hour labor time at the dealer, the sensor will not in most cases be defective with this code, something else is causing this engine to run rich.

Mar 23, 2009 | 1999 Dodge Durango

1 Answer

HORN DOES NOT WORK ON 1999 DODGE DURANGO


The horn is a simple circuit. Check your fuse, and see if you get power to the horn itself. The remote start and alarm are separate problems, and probably need a technician to straighten out.

Nov 15, 2008 | 1999 Dodge Durango

Not finding what you are looking for?
1999 Dodge Durango Logo

Related Topics:

293 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...