Question about 1995 Chrysler Sebring

1 Answer

Chyrsler sebring lxi 1995 2.5 v6 24 valve

1995 lxi sebring changed fuel filter,o2 sensor,computeramd idil motor.IT wasstalling all the time but after i put in the idiling motor it stopped stalleing but now revs very high at almost 3000 rpms i checked for vacum leaks but havent found anything yet any ideas?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Chrysler Master
  • 1,224 Answers

Ok this sounds easy when you ran the vehicle the computer controled the idiling motor now that you replace the idiling motor the computer hasnt been reset to except the new parameters
once you reset computer this should bring the idle back down to its specified idle
you can also adjust back of gas pedel the idle cable and on the throttle body by the idling screw

Posted on Jun 13, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is bank 2 sensor 2 on a 2002 Sebring lxi 3.0 two dr coupe ?


This should be the O2 sensor on the passenger side, after the converter. Its job is to report to the ECU on exhaust after passing through the converter, so has no effect on the way the car runs, but just reports on how the converter is doing its job.

Oct 03, 2016 | Cars & Trucks

1 Answer

Where are the O2 sensors located99 chrysler sebring lxi?


They should in the exhaust pipes just before the catalytic converter

Feb 16, 2015 | 1999 Chrysler Sebring LXi

2 Answers

Would an O2 sensor make your car stall?


Not usually, but O2 sensors have about 60 to 70 thousand mile life spans

May 06, 2014 | 1998 Chrysler Sebring

1 Answer

Where if fuel pressure test port 1990 oldsmobile cutlass ciera 4 cylinder - O2 sensore read code 44


The internet is filled with all sorts of OBD1 Code 44 info to read

Bad Egr Valve --letting unmetered air in
Vacuum Leaks in the Exhaust Before the O2 Sensor
Bad Oxygen Sensor or corroded wiring
Vacuum leaks anywhere
Fuel Pressure too low
& more

You'd have to tee into the fuel filter to use a fuel pressure gauge,
if you got no shrader valve on the motor

You changed a fuel pressure regulator-- in the throttle body?

You won't see much with a scope on that system, if you scope
the O2 Sensor,their sort of slow compared to OBD2

Mar 28, 2014 | 1990 Oldsmobile Cutlass Ciera

1 Answer

Trouble code p0154


code p0154 refers to heated oxygen sensor (HO2S) 1 bank 2 -- no activity detected===causes --wiring---HO2S---= ECM
it also refers to oxygen sensor (O2S) --no activity detected--===causes --- wiring---O2S sensor---ECM. May be you did not replace the sensors causing the fault.

Jan 03, 2014 | Cars & Trucks

1 Answer

2004 chev 2.2 ecotec motor idling rough


Could be a fuel pressure problem or one of the O2 sensors.
Is the check engine light on ?

Sep 07, 2012 | Cars & Trucks

3 Answers

Why doesn't my 2001 Chevy Blazer 4.3l start without starter fluid and tends to bog down if I hit the gas?


Do you the 4.3 l vortec with Central SFI fuel injection system ? On these the fuel pressure regulator is under the top part of the intake manifold , They like to leak ! Leaking Fuel Pressure Regulator

Aug 14, 2011 | 2001 Chevrolet Blazer

1 Answer

Which 2 wires power the IAT sensor? On a 2003 Chyrsler Sebring LXI


Hello degarmo1960,

Below is a wiring diagram showing the idle air control.

netvan_151.png

I hope this helps.

Regards,

netvan

Aug 07, 2011 | Chrysler Sebring Cars & Trucks

1 Answer

I have a 1998 Chrysler Sebring LXi 2 door coupe with the 2.5L SOHC I have 123500 miles on it changed spark plugs and wires distributer cap and rotor not to long ago and did fuel filter to and it sputters...


COULD BE WEAK FUEL PUMP WEAK IGNITION SYSTEM CAUSED BY A BAD COIL CLOGGED AIR FILTER..CLEAN FUEL INJECTORS SEE IF IT HELP.IF NOT YOU HAVE LEAKING INTAKE OR LOW COMPRESSION CYLINDERS.CODE SCAN FOR FAULTY TPS SENSOR.

Mar 21, 2011 | 1998 Chrysler Sebring

Not finding what you are looking for?
1995 Chrysler Sebring Logo

502 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

71338 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22059 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7018 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...