Question about 1995 Toyota Camry

2 Answers

1995 Toyota Camry, stering wheel

Hi, for some reason my stering wheel isn't secure. If you pull on it, it will actually come off. I don't have the repair manual, any ideas how to reattach it?

Posted by on


2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Toyota had a recall for loose steering wheel nuts on some camrys, apparently they were just putting them finger tight on some

Posted on Oct 28, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has achieved Level 3.

  • Master
  • 497 Answers

The consequences are likely to be loss of control of your vehicle while u drive
i suggest you take your car to its dealer...the remedy is that ur dealer would just fix the steering nuts

All the best
Have a nice day!

Posted on Jun 13, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer


pull the steering wheel and check the wear ring under the wheel that the brass contact plunger runs on
it is possible that for the straight ahead position the ring is worn away

Jul 11, 2016 | 1995 Toyota Camry

1 Answer

The key will not turn in the ignition. I have tried turning the steering wheel.

the problem is most likly your stering wheele lock turn wheel left & right till wheel locks in place then your ingition key souyld turn

Feb 17, 2011 | 1989 Toyota Camry

1 Answer

My toyota has been through it with my 8 year relationship ending pretty bad. My keys have been stolen 3 times 1 time recovered slammed the egnition twice. Car stolen 4 times all relays and fuses pulled...

If it turn over too fast maybe the timing belt.

Remove one spark plug after crank it long if the spark plug is wet, there is no spark.
If the spark plug is dry, thre is no fuel.

if there is no fuel or spark check all the fuses, if there is no spark swap EFI relay, this relay is in engine compartment.

Jan 06, 2011 | 1995 Toyota Camry

1 Answer

Toyota camry what should be the level of pwer stering oil

The dipstick will show a line for cold and a line for hot. Remove the dipstick, wipe it and replace it. Pull the dipstick again and read the level on it.

Dec 04, 2010 | 2000 Toyota Camry

1 Answer

My vehicle is stuck in gear what can i do, I tried rocking it and nothing. The vehicle starts and the stering wheel moves

I had this problem with my rover i just put my foot on the clutch and pulled it really hard and it came out .i would check the gear linkage if it does i again.

Jan 26, 2010 | 2002 Toyota Camry

1 Answer

1996 toyota camry stering wheel tightening up and power steering fluid is full

belt slipping or the pump is worn ,other causes could be track control ball joints (not to be confused with the track rod ends)bearings corroded up on top of the mcphersan struts and sometimes the actual steering rack ,do a plan renewal and get the goverment subsidy and buy a new car

Jul 01, 2009 | 1996 Toyota Camry

2 Answers

My toyota camry 1995 key switch won't turn. i am able to use the key to open the doors and the trunk but when trying to start the ignition it will turn 1/4 and won't start.

I have had this problem. There could be a few reasons. ONE. The key itself is worn out...might be time for a replacement. Its amazing how fast that actually happens... TWO my brother who also has the same 95 camry as i do [in another color] had too much weight on his key chain [with all his other keys and twrinkets] for so long that it caused the ignition switch inside to pull down and not line up correctly inside. Which caused the key to only turn partway in the ignition and stop before the car could actually turn on. [He had to replace that part] I hope this has helped.

Jun 14, 2009 | 1995 Toyota Camry

1 Answer

Having trouble with power stering

could be the power steering pump or other possibility rack and pinion

Jan 26, 2009 | 1995 Toyota Camry

Not finding what you are looking for?
1995 Toyota Camry Logo

Related Topics:

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides