Question about 1994 Cadillac DeVille

1 Answer

Chenge heater cord - 1994 Cadillac DeVille

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 23 Answers

Changing a heater core is very difficult. the dash usally needs to be removed. very expensive repair. try your local radiator shop.

Posted on Nov 03, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Who to chenge atomitic transmisan oil chenge

if you have to ask then take it to an accredited auto transmission shop and have it done properly

May 03, 2015 | Cars & Trucks

1 Answer

Cant find the block heater cord

need more info, what year, make, model, engineering. just because the owners manual says.there is a block heater, that doesn't mean you have one look around, try to find a short power cord that you would plug into a extension cord, also look at the engine block, all your freeze plugs, this is where most block heaters go, if you do not see anything in.any of the freeze plugs, do not have one the other kind of engine heater, would be in the top or bottom radiator hoses, or even.heat core hoses, again.there would into. most of the time, they would pull the cord up to the front, by the grill, so you can plug it in

Dec 05, 2013 | Cars & Trucks

1 Answer

Dealer told me you can't just test the block heater cord (2004 CRV) to see if that is the problem and wants to charge me $130 to check and or replace both the heater and the cord? Is this true?

No. If you can get to it you can test it. If the cord can be disconnected. you can check it with an ohm meter. The heater can be check the same way. If you get continuity it is still working. All you have to do is set the meter on ohms (lowest setting) take the leads and touch them to the cord first.Leaving it plugged into the heater. If you get continuity then the unit is till working. if not then test them separate and see which is bad. If they both test good then check the ends of the cord for corrosion. clean and reinstall, check again they should work

Nov 13, 2010 | 2009 Honda CR-V

2 Answers

Service recommendation code p0171 p174 sytem too

2001 Buick LeSabre 3.8L V6 Check Engine Light come on after driving in 20 minutes,error code P0171.....O2 sensors and fuel filter changed ,how can I pinpoint the source.

Feb 09, 2010 | 2001 Hyundai Santa Fe

2 Answers

Heating is too low. AC is good . That keeps the insidew temperature at night very cold. What has to be done? It is a Mercury Sable SW 1997

You may need to replace the thermostat with a 190 degree,and make sure the heater core is flushed out,you can use a water hose to flush the heater core out if needed.I fit has not had a thermostat chenged in a good while,or there is only a 160 degree in it,then this is most likely what it needs.

Nov 19, 2009 | 1997 Mercury Sable

1 Answer

I want to change a block heater cord

If you have a frost plug type heater the cord does unplug from the unit.
if its a in line hose type heater chances are you wont be able to replace just the cord.
Most auto parts stores cary replacement parts

Jan 14, 2009 | 1999 Chevrolet Cavalier

1 Answer

Location of electrical cord for engine coolant heater

Unless your vehicle is diesel powered you probably don't have a coolant heater.

Jan 04, 2009 | 2005 Chevrolet Trailblazer Ext

2 Answers

Location of block heater cable on 05 F350 diesel

The block heater is already installed in your 6.0. The cord may not be there as it is an option in some states and standard equipment in others. The best way to see if your cord is there is to crawl under and look up by the # 4 cyl and you will either see 2 prongs sticking out for the cord or you will see the cord. The cord should end in the front bumper behind where the front tag would be. If you dont have the cord Id suggest getting it off ebay as it should be cheaper than the dealer. Hope this helps.

Dec 22, 2008 | 2005 Ford F 350 Super Duty

1 Answer

Engine coolant heater cord plugin

the heating element is in 1 or 2 engine core plugs in the side of the engine block , kinda hard to see from on top but just follow the wire coming from it to the end of the cord , thats if your vehicle has the option of block heaters.

Dec 20, 2008 | 1995 Chevrolet Blazer

Not finding what you are looking for?
1994 Cadillac DeVille Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts


Level 3 Expert

83850 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22413 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides