Question about 2001 Saturn SL

1 Answer

Rpm seems to be sticking between 2000 and 3000 rpms . Its a pulling sensation and if u take it easy and let it go slowly it will go as normal. May be a gear dunno. 2001sl 5 speed

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 258 Answers

Transmission slipping i would say changing the trans filter would cure that problem unless your are having valve body problems

Posted on Aug 23, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will go in gear but car will not move


A/T or M.T?
auto or stick?
is the tranny full of lube.
lost the operator guide? its there how to check. read it.
does engine race to 3000 RPm in neutral? easy, and normally?

Nov 24, 2013 | Jeep Liberty Cars & Trucks

1 Answer

RPM's rev high and low


"Could this be a throttle positioning sensor problem?" - probably not. The Throttle Position Sensor (TPS) tells the computer how hard you are stepping on the gas. It does not really control idle speed.

Your problem is more likely the Idle Air Control (IAC) valve. This is a small electric valve that the computer can open and close in small steps to set the idle RPM at the desired point (a little higher when cold, then down to normal speed when warm). The IAC valve is notorious for getting all crudded up inside. Then it sticks open too much (really fast idle speed) or sticks shut (really low speed).

You can try taking it off the engine, cleaning it with carb cleaner spray, and putting it back on. That is easy and cheap.

If cleaning does not fix it, you need to buy a replacement valve and put it on. Pretty easy to do but costs more $$$.

Apr 29, 2013 | 2000 Honda Odyssey

1 Answer

Our '03 Trailblazer shutters at stop signs and feels rough when turning. Help.


Check engine for vacuum leak if no leak found a check map sensor

Mar 14, 2013 | 2003 Chevrolet Trailblazer Ext

1 Answer

Sluggish acceleration. High RPM, High Oil Pressure


I hope I'm wrong but I think your torque converter is failing. Sorry, Gary

Jul 27, 2010 | 2003 Chevrolet Blazer

1 Answer

My 2003 suburban seems to run at a higher rpm.


Hummm, 2000 rpm does not seem high, really. But another item to look at is your FAN. The clutch fan fails and drives the fan full engauge. Sounds like a jeep...massive sounding, relating to engine RPM, but not necessarily different.

I mentiont his because a trans does not typically fail and give a few hundred RPM. Usually a slipping sensation is described....

Jul 12, 2010 | 2003 Chevrolet Suburban 1500

1 Answer

I have 1995 Mits Lancer glxi matic. I observed that at normal idle or running condition, the engine rpm is slowly, slowly dropping to zero. Im just pressing the gas in order to keep running. otherwise will...


Try checking the codes. You can do this at part stores like auto zone for free. It might be the maf sensor or if it says lean o2 sensor than it's the fuel filter.

Jun 29, 2010 | Mitsubishi Lancer Cars & Trucks

1 Answer

When starting,Idle over a 1000 rpm


could be a ilde air controll valve sticking or gummed up

May 16, 2010 | 1988 Dodge D-Series Pickups

1 Answer

When I start my 1999 honda CRV it surges to about


no the surge that high is not normal a normal cold start should go to around 1500 then settle slowly to 750 or so but this all depends on engine temp and ambient air temperature

Feb 07, 2010 | Honda CR-V Cars & Trucks

2 Answers

Intermittent High Idle, Dies on cold starts, bad mileage


These cars are notorious for intake manifold leaks. This could also be a throttle position sensor. If you have a MIL (check engine light) I would scan it with an OBD II scanner and pull the relevent code off the scanner it will give us a much more accurate direction to proceed

Feb 01, 2009 | 2002 Cadillac Deville

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

155 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

64052 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...