Question about 1992 Ford Ranger

1 Answer

Ford ranger 3 new altarnators and batt. still not charging??

Posted by on

  • todrob Jun 12, 2008

    1992 4x4 4.0L xlt ranger

  • hefe1 Aug 19, 2008

    have installed 3 new alternators, and a new batt, not getting a charge. all fuses are good. ranger will start, but runs very rough. any thoughts?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Mine was doing that and it was a fueable link between the battery and altenator.

Posted on Aug 25, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2000 Ford Ranger is killing alternators immediately after install


the best way to test an alternator is with a load test-partstores dont do that--battery may still have a bad cell even tho it tested good--an alternator can burn up charging a completely dead batt--make sure batt reads at 12.6volts and no less-----if it reads say at 12.3 its only 50% charged!

Sep 18, 2014 | Ford Ranger Cars & Trucks

1 Answer

2002 ford ranger battoury won't stay charged new


You have had the battery load tested on a tester? If not do that, you can be fooled.

Oct 05, 2012 | Cars & Trucks

1 Answer

2000 ford ranger, new alt not charging ran battery dead. batt. light on dash on.


Defective alternator, burnt fuseable link, problem with key switch not sending signal to alternator-regulator.

Jun 27, 2012 | Ford Ranger Cars & Trucks

1 Answer

Why it wont start if the fuel throtal sensors,tune up,batt.., and altarnator are new


If it cranks, it is probably the fuel filter, clogged. Replace and try again.
If it just clicks then the solinoid/starter need to be checked.
If it does nothing, the connection to the solinoid can be the problem.
If it does nothing and the connection to the solinoid is OK, only other suggestion I have is the electric in the key switch or wires in the stearing column.

Dec 03, 2011 | Cars & Trucks

1 Answer

I have a 87 ranger 2.8 wont start


earth cable from engine to chassis ,renew it ,or check the ends for corrosion

Jan 18, 2010 | 1987 Ford Ranger

1 Answer

Battery isn charging, its a brand new battery. 1977 ford f250 ranger with a 460 in it.


with ignition key on does the batt. indicator in the cluster lit?using a testlight(one side connected to ground), probe the wires at the connector of the alternator with ign. at on position.you shld be getting a live +12volts.if there is a +12 volts to any of the wire while ignition is on then the wirings or the fuse is ok.Need to remove the alternator and check the carbon brushes

Jan 15, 2010 | Ford F-250 Cars & Trucks

1 Answer

I have a 1989 fordf350 deisel batt light stays on


I would check the plug going into the alternator. They have been known to fail at times. I would also check the fuse for the alternator if equipped.

Apr 25, 2009 | 1989 Ford F 350

Not finding what you are looking for?
1992 Ford Ranger Logo

Related Topics:

88 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

63242 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...