Question about 1999 Chrysler Sebring

Open Question

Working on a 1999 Chrysler Sebring the cranks but no start. Check the spark so there is a spark. Check the fuel line no fuel traveling from the pump to the motor. Replace the fuel pump and still no start. Is there a Auto Shut Down relay or fuel pump cut off switch

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

04 Chrysler Sebring cranks and won't start. I have changed the plugs, wires, and distributor. I have a 3.0 engine


Standard practice is check for spark at each plug when you crank. If you're getting spark, then check for fuel getting to cylinders.

Feb 06, 2017 | 2004 Chrysler Sebring

2 Answers

My 1999 Chrysler Sebring jxe convertible will not start, but does turn over. How do I troubleshoot this problem?


Start by ensuring any immobiliser is disengaging.

To start, an engine needs a decent cranking speed, compression, timing, the right amount of fuel and a quality spark.

Discovering why an engine doesn't start means working through that list of requirements until the fault is discovered. Checking the ignition components and spark is usually the easiest to begin with.

It is worth knowing too much fuel can also prevent an engine starting...

Jan 25, 2017 | Chrysler Cars & Trucks

1 Answer

1999 Chrysler searing xli... I can not find cut switch no where.... Is there somewhere I can get a picture??? Please help me..... Thank u.....


Make sure battery has a full charge and battery connections all good. Cut-off switch for what? If your talking about the fuel pump, you don't have one. How long since a tune-up? Any applicable trouble codes? Engine cranking, do you have spark at the plugs and fuel injector pulse?

Oct 20, 2016 | 1999 Chrysler Sebring

2 Answers

1998 Sebring Jxi convertiable turn over but want start


Make sure you have spark and fuel. when you first turn the key to the "ON" position you should be able to hear the fuel pump whirr or run for about 3 seconds to prime the fuel system, if not you need to check the fuel pump fuse and the fuel pump relay to make sure the fuel pump is getting power when you turn the key on. If you can hear the pump run and do have fuel pressure, then you need to make sure the engine has spark. You can do this by removing a spark plug from the engine and putting it back into the plug wire, make sure the metal bottom of the plug is touching a metal part of the engine and have someone crank on the engine while watching the gap in the electrode of the plug. You should have a very sharp blue spark jump the gap in the electrode. If you have no spark or a weak orange looking spark then I would look to the crank sensor or the coil.

Apr 21, 2013 | 1998 Chrysler Sebring

2 Answers

Replaced fuel pump . car will not start. not getting fuel.


Check your fuel relay under your hood.Located under hood in a black box, This is the most common problems with fuel pump's not working. Good luck.

Apr 04, 2011 | 1999 Chrysler Sebring

1 Answer

After running for 10 minutes car died on the road. Gauges were working, no idiot lights were on. Battery and alternator dont seem to be an issue. Believe its the fuel pump. Where is it located on a 2004...


The fuel pump is in the gas tank. but the next time it dies you might want to check and see if it has spark. If it don't it could be a problem with the crank sensor and then you would have replaced the fuel pump for nothing. Good luck

Nov 10, 2010 | 2004 Chrysler Sebring

1 Answer

1999 chrysler sebring convertible jxi code p1495 intermittant shut off while driving. Replaced fuel pump and filter, distributor, spark plugs and wire. Was advised by ZJLimited to remove connector from the...


replacing the fuel pump relay is one thing but what about the (ASD auto-shut down) relay

additionally...
  • what engine size?
  • what transmission?
  • any codes?
  • does the pump run KOEO?
  • Do you have spark?
  • What is the cranking speed?

you may find faster service by subscribing to a "live chat" since there are so many questions and variables in your concern

Jun 03, 2010 | 1999 Chrysler Sebring

1 Answer

2001 CHRYSLER SEBRING, THE STARTER IS CRANKING THE ENGINE OVER, THERE IS A SPARK, THE FUEL PUMP IS DOING ITS JOB, YET THE ENGINE WILL CRANK OVER BUT WILL NOT START, ANY SUGGESTIONS WOULD BE APPRECIATED.


what size engine this vehicle has? if it is a 2.4 inspect timing belt, also you may remove spark plug and inspect air pressure coming out of cylinder while cranking engine

Nov 19, 2009 | 2001 Chrysler Sebring

1 Answer

1997 Chrysler Sebring convertable engines turns over doesn't start. Was running fine then stopped.


Two things to check for. Spark and fuel spay some fuel injector cleaner directly into the intake and if it want to start and shuts off you have a fuel delivery problem, probably a fuel pump or relay. If nothing happens check the spark . If you have no tools the old fashioned way of using a philips screw driver and attaching it to a plug wire and then putting it close to the block while it is turning over. Insulate yourself first. If you have no spark the usual reason on a Chrysler is the crank sensor, but it should be diagnosed before throwing parts at it.

Hope it gives you somewhere to go.
Rich

Sep 28, 2009 | 1997 Chrysler Sebring

Not finding what you are looking for?
1999 Chrysler Sebring Logo

1,056 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

81342 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...