Question about 1999 Ford Crown Victoria

1 Answer

Fuel gauge not working

Ford crown vic 1999

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Chances are its the sending unit in the fuel tank unfortunatly there is no easy solution for this other than droping the tank and removing the float or the info wire has broke and thats not fun to find either

Posted on Jun 12, 2008

5 Suggested Answers

  • 11 Answers

SOURCE: Crown Vic will turn over but not start

first do you hear your fuel pump running? if you don't more then likely the relay may have went bad. second check your connection to your coil's..make sure there clean and tight..and getting back to the fuel problem if you hear your pump running then it could be the fuel filter clog...try this and let me know....

Posted on Nov 13, 2008

  • 62 Answers

SOURCE: 1999 crown vic keeps getting air locked at the fuel rail?

check your fuel pressure
if you dont have enough pressure this will happen
when the fuel pressure is good the system will just push the air out through the injectors or the fuel return line

Posted on May 16, 2009

  • 234 Answers

SOURCE: 1999 FORD CROWN VIC. 4.6 - PROBLEM, NOISE

This is caused by the IAC valve. Over time the valve becomes gummy and inoperative. Get it replaced and the problem is solved. IAC stands for idle air control, hence the stalling concern.

Posted on Oct 18, 2009

  • 1 Answer

SOURCE: 1999 ford crown vic with ignition coils going bad a lot.

have look at ur wires that is caming from the car in to the coil it self

Posted on Mar 27, 2010

Testimonial: "Thanks for the info. I did replace coils made in the good ol USA and the car is running much better. Better gas mileage as well. Thanks again."

Breed1956
  • 483 Answers

SOURCE: I have a 1999 Ford Crown Victoria Police

MOST INTERCEPTER CARS, MEAN THEY HAVE AN ADDED GEAR IN THE TRANSMISSION! WHAT YOU'LL BE DOING IS GOING TO A TRANSMISSION WITHOUT THAT EXTRA GEAR! TO ANSWER YOUR QUESTION: YES YOU CAN REPLACE IT WITH A REGULAR TRANSMISSION! YOU JUST WON'T BE ABLE TO CHASE BURGLARS! HAHA

Posted on Mar 04, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 ford crown vic won't start. changed fuel


Maybe your problem is with the one or many injectors, if just one is bad, you will have problems. Get yourself a multimeter and set it to read in ohms and find what spec the injectors should be at. If out of spec, then you need to replace that one injector(s).

Mar 25, 2013 | Cars & Trucks

1 Answer

I dont know which fuse controls my fuel pump on my 1999 ford crown vic


On fuse pannel it should say fuel pump. It should be near battery or inside car. Read owners manual for more detail.

Jun 10, 2011 | 1999 Ford Crown Victoria

1 Answer

How big is the gas tank on a 1992 ford crown vic. how many miles to the gallon. my gas gauge doesnt work. so i dont know anything about the gas.


1992 Ford Crown Vic 4.6 L V8 Automatic

Fuel tank capacity is 20 gallons (US).

Your fuel consumption will be affected by many factors, such as :
- how you drive the vehicle
- the condition and tune of the motor
- driving conditions (traffic, city use, highway use etc)
- tire pressures
- type and grade of fuel used .

It is impossible for me to estimate what fuel consumption you can expect from your own particular car without a whole lot of information.

It's unwise to run the vehicle for long with no working fuel gauge.

Dec 17, 2010 | 1992 Ford Crown Victoria

1 Answer

Temp gauge does not work 95 crown vic


Probably a bad temp sending unit. Believe it screws into the water neck or intake manifold and has wires plugged into it

Oct 02, 2010 | 1999 Ford Crown Victoria

1 Answer

How to replace fuel pump 1999 crown vic


Almost all vehicles made the last 30 years ,need to remove the fuel tank to get the sending unit and or fuel pump out. Can not believe the thousands of people with that question!

May 03, 2010 | 1999 Ford Crown Victoria

1 Answer

Where is the gas filter for this 1999 ford crown vic located


If it is fuel injected, the fuel filter is located under the car, on the inside of the right frame rail, under the drivers seat.

May 01, 2010 | 1999 Ford Crown Victoria

1 Answer

1999 crown vic keeps getting air locked at the fuel rail?


check your fuel pressure
if you dont have enough pressure this will happen
when the fuel pressure is good the system will just push the air out through the injectors or the fuel return line

May 15, 2009 | 1998 Ford Crown Victoria

1 Answer

Car dies when accelerate. do i need new fuel pump?


Hello;
It sounds from your description that the fuel pump is weak. To check the fuel pressure you need a fuel pressure test gauge for fuel injection. Attach the gauge to the test port schrader valve and turn the ignition to the on position. Record the reading. Now start the engine and record that reading. Unplug the pressure regulator vacuum line and record the reading.
The pump should have pressure with in specs but if low, start with the installation of a new complete pump. It is located in the fuel tank. Also replace your fuel filter.
Hope this helps you.
Thanks;
Rich
RPM Northwest

May 12, 2009 | 1999 Ford Crown Victoria

4 Answers

My 99 Crown Vic acts like it isn't getting gas


check for clogged fuel filter first, usually the pump works or it dosen't, check and get back to me.

May 01, 2009 | 1988 Ford Crown Victoria

Not finding what you are looking for?
1999 Ford Crown Victoria Logo

329 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...