Depending on who installed it, there should be a small button, located somewhere under the driver side dash. Different shops install these buttons in different locations, so it's hard to tell where it may be, but that's the usual place.
Turn the key to the "on" position and push the button.
Depending on the alarm, there may be a certain number of times you have to push it, but normally it's just once. You will hear a confirmation "chirp" from the alarm horn when it is disabled.
Engine stall or RPM fluctuates
at idle.
This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control
190 views
Usually answered in minutes!
well i snipped the wires to the sound of the alarm cuz it was wakin up my neighbors. im goin to to deal with it when theres daylight. i will check that. thank you nitrotrike!
×