Question about 1991 Chevrolet Corvette

1 Answer

Power antenna There are three wires on the power antenna what do they get connected to?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

One wire is a ground. to metal under the car. one goes to the antenna inside of car above the left wheel well.and the last is your
electrical inside of car toward the back of the car. hope that helps.

Posted on Jun 16, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What does fuse called radio-b do?


If your unit has digital display as most do now, RADIO-B will supply constant power to power the units memory so it can remember the preset channels, starting volume etc. The power antenna is usually controlled by a separate wire from the unit (normally blue) this wire supplies a low voltage signal to the antenna, The antenna will also have its own power supply and earth at the base of the antenna, the problem could be there. depending on the antenna, some have a controlling relay that is separate, again another possible source. there will also be a fuse in the main fuse box. These will all need to be checked, along with connecting a power source to the antenna to ensure the antenna does actually work.

Feb 23, 2013 | Cars & Trucks

1 Answer

Antena not working


I am ussuming this has an electic antenna that goes up when the radio is turned on. It is the wire going to the antenna or the motor has just burned out. You can get a replacement motor or a replacement power antenna at most auto parts places. If you are looking for the original then try a junk yard and call around. It is also possible that the antenna wire came unplugged from the back of the radio. It is usually one of these three things. Unpugged wire, motor burned out or break in the wire somewhere.

Apr 10, 2012 | 1994 Acura Integra

1 Answer

How do I remove power antenna from 1992 300 zx


pop the rear deck lid and remove the right rear plastic trunk cover. To do this you will remove the small plastic piece that is directly in front of the right rear tail light. Then remove the big plastic screw that retains the center plastic deck lid cover. Now remove the three 10mm nuts that keep the right rear plastic cover secured. Remove the right rear plastic cover. Be careful as it can crack if you put too much pressure on it. Look inside and to the right rear where the antenna mast comes up. You will see a small 10mm nut that holds the antenna mast to the body. Take that nut off. This will release the outer body cover from the inner cover. Remove the outer body cover and then remove the two screws from the OUTSIDE of the body cover. Now follow the antenna body down and you will see two or three additional small nuts that hold the antenna assembly metal bracket in place. Remove these. Unplug the antenna co-ax cable from the input. It just slides out. Unplug the antenna connection as well. This is the jack that has the power wires. You will also need to unscrew the ground wire from the inner body frame. There might be a nut on top of the actual antenna mast. If so, just unscrew it. The entire antenna assembly will now lift out. It's a mildly tight fit but you don't need to be too gentle in this step. Normally the problem is the antenna belt has broken inside the antenna assembly and there is no hope of replacing that belt. You have to replace the entire assembly. I found mine on Craigslist from a guy parting his totaled Z. May it rest in peace. His loss - my gain! Typical price is $65, maybe you can talk him down to $50. Installation is the above process in reverse.

Sep 03, 2011 | 1992 Nissan 300ZX

1 Answer

Where is the power steering fluid reservoir and the antenna control


power steering pump reservoir is located on the drivers side of the engine ( up front ) right behind the power steering pump.
the antenna control wire should be connected to the radio and when the radio is powered on it sends a signal to the antenna relay that in turn activates the antenna motor.

c...

Jan 03, 2011 | 1996 Nissan Pathfinder

2 Answers

Power antenna motor won't stop running. Do you know where the cutout switch is located?


There is no switch. When the plastic gears inside the power antenna strip out they continue to run because the limiter switch inside the unit never gets tripped. If you can assist the antenna up when it's running, leave it up and disconnect the power to the motor. If i remember correctly the antenna is mounted on the passenger rear quarter panel. You should be able to pull some of the truck trim out a little and disconnect the two or three wire connector.

Jul 08, 2010 | 1993 Buick LeSabre

2 Answers

How to connect kenwood radio to Toyota antenna relay


Most aftermarket car stereos have a blue wire for power antenna control. Connect the blue wire to your car's power antenna control wire. Also, Crutchfield has nocut connector kits to install most car stereos in most cars, with instructions. You can either buy these kits or Crutchfield gives them to you, free, when you buy a stereo from them.

Jul 16, 2008 | Toyota Supra Cars & Trucks

1 Answer

AFTERMARKET REPLACEMENT FOR AUTO ANTENNA


sounds simple
placement of antenna is important this will determine which wires to use
most antenas are in the trunk of vehicle with a wire clip to connect or disconnect
tools needed
test light
find your wire clip running from old antena this will be where test light will be used one side of clip is full powered the other is key powered find good ground tip the test light on first prong light stays on this is full power other will be key powered

now your looking for the simple color wires ok on the back of your sterio there is an atenna wire which is blue this will power on only when sterio is on the other wire
you use test light to find without key in take your test light and find a permannent powered full on wire hot supply then connect antenna into these 2 things

at top the reason i mentioned this is cause the old power antena you can find the right leads in the trunk area where new antenna going to be placed with the test light you might need a second person to help you testing wires you in the back and them in the front turning the key on when you need it it makes things simpler with 2 people
i hope this helped you in your quest for knowledge

May 31, 2008 | 1990 Toyota Celica

Not finding what you are looking for?
1991 Chevrolet Corvette Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...