Question about 2005 Hyundai Sonata

1 Answer

2005 Hyundai Sonota 2.4GL no sound when alarm triggerred.

I bought a used 2005 Hyundai Sonota 2.4GL that came with the alarm. The alarm can be armed but no sound when tested - ie no horn when alarm is trigger, only light flashing. How do I armed it to horn when alarm is trigger? Thank you so much for your help.

Posted by on

  • Anonymous Jan 23, 2009

    when the keyfob is pushed twice all i get is blinking lights and no beep. The panic alarm doesn't sound either!

  • Anonymous May 09, 2009

    I have the same problem on my 06 Elantra. It used to beep but was messing with the remote one day and some how turned off the sound. So no sound for almost 2 years

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Mine acts the same way. I found that it doesn't alarm unless you trigger the alarm. Be sure to check that the alarm fires correctly as mine didn't and they covered this under warranty.

Posted on Dec 22, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 2004 Hyundai accent's alarm goes off randomly some time after the car is locked


The alarm system has a sensitivity control and it needs to be turned down. This cannot be a factory alarm system?

Jun 21, 2012 | Hyundai Motor 2004 Accent

1 Answer

H02s heater control circuit low bank 1 sensor 2 for hyundai sonota 2000


Here is a picture of where they are, do not be alarmed if your car is a four cylinder this picture is generic. Bank one sensor 2 should be after the cat in a 4 cylinder. But use the picture as a reference. mcneb_23.jpg

Mar 30, 2011 | 2000 Hyundai Sonata

1 Answer

Hyundai tucson 2007 rear door wont open, alarm switch, power switch and key will open all doors except rear.


Sounds like the acutator that pushes and pulls. either lost power or died. I would assumed died. U need to check to see if it is on a seperate fuse first, it may be. If the fuse is ok, remove the hatch inside plastic panel and arm and disarm the alarm. See if the actuator moves.

Dec 08, 2009 | 2005 Hyundai Tucson

1 Answer

Which fuse controls the burglar or anti-theft alarm on a 2004 Hyundai Elantra? I removed the one called "burglar alarm" (or "start"), but it is not the right one.


The OE alarm is part of the ETACS
To disable it:
1) Sound the alarm
2) Put the key in the ignition and turn to start
3) Hold there until the alarm turns off
You should now be able to start the vehicle. The alarm will remain dis-armed until armed through RKE

Nov 18, 2009 | 2004 Hyundai Elantra

1 Answer

The clock on 2005 hyundai sonota keeps resetting back to 1:00


check connections at rear of digital clock (connector) . if no problem, check the 'power bar' fuses at the fuse panel (interior) ... there may be a loose connection there. If you don't find any problems there, then best guess is the clock itself is going bad.

Jun 28, 2009 | 2005 Hyundai Sonata

1 Answer

2003 Hyundai Elantra.. Numerous problems with the alarm.....


Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.

Jun 27, 2009 | Hyundai Motor 2003 Elantra

1 Answer

Changing cabin air filter in a 2005 sonota


http://www.santafemods.com/Mods/CabinAirFilter.htm I think the filter is behind the glove compartment.

Mar 27, 2009 | 2005 Hyundai Sonata

1 Answer

VEHICLE WONT START


Section 13-11: Anti-Theft System, Active 1998 Windstar Workshop Manual DESCRIPTION AND OPERATION Anti-Theft Alarm System NOTE: The system immediately monitors the ignition key lock cylinder upon removal of the key from the ignition. It is not necessary to arm the system for ignition key lock monitoring.

The anti-theft alarm system:
  • protects the vehicle from unauthorized entry into the passenger compartment, engine compartment and cargo area.
  • monitors the status of the ignition key lock cylinder.
  • is controlled by a remote anti-theft personality (RAP) module. The remote anti-theft personality module also controls the electronic door lock functions. Refer to Section 01-14B for more details.
  • when armed, detects unauthorized entry into the passenger compartment by using an input from the GEM module regarding the state of the door or liftgate (open or closed).
  • protects the engine compartment with a hood switch which is located on the LH cowl vent panel and is part of windshield wiper motor wiring (17A477) .
  • triggers an alarm if the ignition lock cylinder is forcibly removed from the steering column.
Once triggered, the system responds by:
  • flashing the low beam headlamps, the parklamps, rear lamps and the alarm indicator warning light emitting diode (LED).
  • sounding the horn (13832).
  • disabling the starter circuit until the system is disarmed.
---------------------------------------------------------------------------------------------
Remote Anti-Theft Personality Module
  • The remote anti-theft personality module is located behind the instrument panel (04320).
  • It contains a radio receiver that receives the RF signal from the keyless entry remote transmitter (15K601) through the alarm and lock system antenna (15603) and sends the appropriate command to the power door locks, the horn relay, or the generic electronic module.
  • The remote anti-theft personality module is equipped with an internal backup power supply which holds the programmed code in memory in the event the vehicle battery is disconnected.
-------------------------------------------------------------------------------
Remote Anti-Theft Personality Module Removal
  1. Disconnect battery ground cable (14301). Refer to Section 14-01 .
  1. Remove radio. Refer to Section 15-01 .
  1. Remove lower instrument panel center finish panel. Refer to Section 01-12 .
  1. Lower glove box.
  1. Remove two remote anti-theft personality module bracket retaining screws.
  1. Disconnect electrical connectors and alarm and lock system antenna (15603).
  1. Remove remote anti-theft personality module and bracket.
  1. Remove remote anti-theft personality module from mounting bracket.
Installation
  1. To install, follow removal procedure in reverse order.
  1. Tighten remote anti-theft personality module bracket retaining screws to 6-8 Nm (54-70 lb-in).

    34bdf35.gif
Components The system is composed of the following components:
  • remote anti-theft personality (RAP) module with integral antenna
  • alarm indicator LED
  • door lock cylinder switch RH, door lock cylinder switch LH
  • liftgate door lock cylinder switch (220A40)
  • hood switch (part of windshield wiper motor wiring (17A477))
  • ignition lock anti-theft switch (19A438)
The following vehicle components are also used by the anti-theft alarm system:
  • generic electronic module
  • power door lock switch (14028)
  • door open warning lamp switch (14018)
  • autolamp relay (14N089)
  • horn relay and bracket (13853) and horn (13832)
  • low beam headlamps
  • rear lamps (13404) and parking lamps (13200)
  • starter relay
  • door lock relays
  • keyless entry remote transmitter (15K601)
--------------------------------
Disarming an Untriggered System NOTE: A perimeter alarm will "shut off" after 165 seconds, but the system is still triggered and is not disarmed.

An armed but untriggered perimeter anti-theft system can be disarmed by one of the following four events:
  1. Unlock the doors by pressing the keyless entry remote transmitter (15K601) UNLOCK button once.
  2. Unlock any door with a key.
  3. Turn ignition switch to RUN or ACC.
  4. The remote entry PANIC button will disarm the anti-theft system only when the perimeter alarm is triggered and sounding.
------------------------------------------------
System Triggering NOTE: Although the remote entry PANIC alarm is not associated with the monitoring of the vehicle, the user will frequently say that the theft system was triggered when actually the keyless entry remote transmitter PANIC button was inadvertently pressed. A panic alarm will not flash the THEFT indicator.

The alarm can be triggered by the following events if the system has been armed and has not been disarmed first:
  • Open any door or liftgate.
  • Open the hood (16612) (if the hood was open when the system was armed, it must be closed before it can trigger the alarm).
  • Dislodge the ignition key lock cylinder.
  • The anti-theft system may be triggered inadvertently when the module is disconnected and then reconnected. To avoid inadvertent alarm triggering, disconnect the smaller 22-way connector first.
When the system is triggered the perimeter alarm will operate as follows: The remote anti-theft personality module will pulse the following outputs at approximately 1.3 Hz, 50 percent duty cycle for two minutes 45 seconds for North America. NOTE: Other perimeter alarms can be programmed for the system.

  • low beam headlamps
  • parking lamps
  • horn
  • THEFT indicator
The perimeter alarm can be retriggered, after a perimeter alarm has sounded for 165 seconds. After a perimeter alarm has timed out, if any trigger input is first seen as normal and is then seen in its trigger state, the perimeter alarm will be retriggered. The perimeter alarm can be triggered a total of three times between an arming sequence and a disarm event. An active panic alarm will be deactivated when a perimeter alarm is triggered (a perimeter alarm overrides a panic alarm).

Mar 02, 2009 | 1998 Ford Windstar

2 Answers

Winshield wiper


c2e618a.gif2003 > G 2.4 DOHC > Body Electrical System

May 22, 2008 | Hyundai Motor 2003 Sonata

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

640 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

63661 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21986 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...