Question about 1999 Dodge Stratus

1 Answer

Replace a catalytic converter for a 1999 dodge stratus

How do i replace a catalytic converter for a 1999 dodge stratus

Posted by on

  • 1 more comment 
  • Anonymous Mar 23, 2014

    Seems to in bind under acceleration

  • Anonymous Mar 23, 2014

    Install new spark plugs

  • Anonymous Mar 25, 2014

    replaced injectors ,coil wires,thottle sencor,o2sensors still short on power idle fine

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 702 Answers

The cat is located just off of the exhaust manifold. You have to remove things to get out of the way. Loosen down pipe to converter and unclamp the converter and it should pull right out. Use a good penetrating oil to help loosen the down pipe bolts.

Posted on Jun 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is bank 1 sensor 2 located at on 2003 dodge stratus wit a 2.4 engine ?


    Dodge Chrysler - YouTube

    ? 2:54
    https://www.youtube.com/watch?v=vs2DuvehVGA
    Oct 31, 2013 - Uploaded by 1A Auto Parts
    I want to know about a Dodge Stratus 2002 sensor. ... I have a 05 Chrysler 300 2.7 engine with a fault code ... images for Where is bank 1 sensor 2 located at on ...


    More images for Where is bank 1 sensor 2 located at on 2003 dodge stratus with a 2.4 engine

    Where is bank 1 sensor 2 located at on 2003 dodge stratus wit

    www.fixya.com/cars/t26025690-bank_1_sensor_2_located_2003_dodge
    22 mins ago - SOURCE: check engine light is on...bank 1 sensor1 oxygen sensor. if u have one .... 2.7L dodge stratus/ #1 bank #2 sensor location? on 2004 Stratus. Oct 24 ... How can I set the timing on a 1996 dodge stratus 2.4l engine.

    P0137 02 Sensor Circuit Low Voltage - OBD-Codes.com


Dec 28, 2015 | Dodge Cars & Trucks

2 Answers

Where should I place a hole in the clogged catalytic converter on my 1999 Dodge Neon onto clean it out?


Most cat converter products I know of are poured into the fuel tank. The car is then driven until empty. These preps won't fix a dead converter, but can boost one that is just dirty inside.

Do you have a different sort?

http://www.startribune.com/cleaning-additive-can-t-restore-a-failed-catalytic-converter/186090071/

All this all fails, cheaper generic converters are available from Autozone and similar places

http://www.autopartswarehouse.com/shop_years/dodge-neon-catalytic-converter-1999.html
.

Dec 07, 2015 | Dodge Cars & Trucks

1 Answer

I replaced an oxygen sensor in my 99 dodge stratus twice and the check engine came back on with the same code


make sure you don't have a plugged up catalytic convertor or other exhaust restrictions

Oct 13, 2015 | 1999 Dodge Stratus

1 Answer

2.7L dodge stratus/ #1 bank #2 sensor location? on 2004 Stratus


on the exhaust pipe just below the catalytic converter

Oct 24, 2011 | 2004 Dodge Stratus

1 Answer

2004 Dodge Stratus Sedan. engine light stays on,


Take the vehicle to any auto parts store that offers to read the fault codes with a scanner for free and find out what that code is. If it shows Upstream or Downstream O2 sensor replace the O2 Sensor. There is a catch, dodge had an issue in the 2000 - 2004. The ECM will show a fault code that indicates the Catalytic converter is faulty. This is actually a faulty Downstream O2 Sensor. If you get a Catalytic converter fault code replace the O2 sensor first if you still have the problem then replace the converter.

Jun 25, 2010 | 2004 Dodge Stratus

1 Answer

I have code p0301 in my dodge stratus 1999 2.4


P0301 Code - Cylinder #1 Misfire Detected

What does that mean?
A P0301 code means that the the car's computer has detected that one of the engine's cylinders is not firing properly. In this case it's cylinder #1.

Symptoms may include:
* the engine may be harder to start
* the engine may stumble / stumble, and/or hesitate
* other symptoms may also be present

Causes
A code P0301 may mean that one or more of the following has happened:
* Faulty spark plug or wire
* Faulty coil (pack)
* Faulty oxygen sensor(s)
* Faulty fuel injector
* Burned exhaust valve
* Faulty catalytic converter(s)
* Running out of fuel
* Poor compression
* Defective computer

Possible Solutions
- If there are no symptoms, the simplest thing to do is to reset the code and see if it comes back.

- If there are symptoms such as the engine is stumbling or hesitating, check all wiring and connectors that lead to the cylinders (i.e. spark plugs). Depending on how long the ignition components have been in the car, it may be a good idea to replace them as part of your regular maintenance schedule. I would suggest spark plugs, spark plug wires, distributor cap, and rotor (if applicable). Otherwise, check the coils (a.k.a. coil packs). In some cases, the catalytic converter has gone bad. If you smell rotten eggs in the exhaust, your cat converter needs to be replaced. I've also heard in other cases the problems were faulty fuel injectors.

Hope this help (remember rated this). Good luck.

May 15, 2010 | 2002 Dodge Stratus

1 Answer

How to replace/remove both catalytic converters


Below are the steps needed to remove the catalytic converters. You may be able to first remove the band clamp from between the converter and the exhaust manifold, then loosen the rest of the system and to get enough clearance to slide the converter towards the front of the vehicle but you will need to first remove the clamp that holds the converter to the rest of the exhaust. Hope this helps
_______________________
Both Catalytic Convertors

First you need to raise the vehicle.

Next, you need to pry the insulators from the support brackets and support the muffler and tailpipe with jackstands.

Then, loosen the the catalytic converter down pipe-to-front resonator clamps and separate the front resonator from the converter down-pipes. Carefully lay the free laying exhaust on the ground.

______________________
Right Catalytic Converter

Then, remove the down-pipe-to-transaxle bracket nut, loosen the clamp and separate the extension pipe from the converter.

Next lower the vehicle and remove the air filter and intake ducts. Disconnect the wiring harness for the O2 sensor and the remove the sensor.

Finally loosen the band clamp at the exhaust manifold and remove the converter from the engine compartment. You may need to replace these clamps after removal because you need to pry it apart and they will leak when you reinstall.

_____________________
Left Catalytic Converter

Now disconnect the wiring harness for the O2 sensor and the remove the sensor.

Next remove the down-pipe-to-transaxle bracket nut

Finally loosen the band clamp at the exhaust manifold and remove the converter from the engine compartment.

Apr 22, 2009 | 1999 Dodge Intrepid

1 Answer

2003 Dodge Stratus Catalytic Converter


it is part of your exhaust looks like a muffler kinda you should pay the 264 they can cost that much by there self just to buy the part just go to a few muffler shop to get a qote the go to the lowest

Dec 20, 2008 | 2003 Dodge Stratus

Not finding what you are looking for?
1999 Dodge Stratus Logo

Related Topics:

511 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...