Question about 1996 Isuzu Rodeo

2 Answers

The Heat/Vent fan is not turning on

I noticed a couple of months ago that the fan for the Heater/Vent/ AC is not engaging or turning on. I have gone through all the fuses and everything is fine. The question is...What the heck is not working? When I hit the AC Button I can hear the AC trying to work but their is not air coming out the vents. It is getting hot. What does something like that cost? Is their a quick fix?

Posted by on


2 Answers

I had the same problem. Try replacing the blower resistor behind the glove compartment. ($59.00 for part at dealership & 20 minute easy job. Two screws at bottom of glove box and two screws on resistor and replace. The blower ($150.00) motor may be causing the resistors to blow. I have already blown two speeds on my new resistor and believe it is because the bottom bearing on the blower motor is a little tight causing it to stick or slow start at lower speeds. No problem yet on high. Probably needs replacing.

Posted on Jul 13, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 375 Answers

It can be simple and cheap to repair if the problem appear to be less gas but it also can be a problem with the air compressor which make in it a little bit expansive.

Posted on Jun 10, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

No A/C

Could be the main control panel. The ac clutch will engage if it gets power and the system is full of freon. The air should switch to the other vents even if the ac clutch does not engage.
You may need a shop manual to get the wiring diagrams to troubleshoot the system.

Jun 30, 2013 | Cars & Trucks

1 Answer

AC/Heater Blower Fan in 1990 LS400 works intermittently

Due to the age of your vehicle, the brushes in the fan motor are worn out. you will have to replace the fan motor, it is not serviceable.

May 30, 2017 | 2001 Lexus RX 300

1 Answer

Have a 08 Ford Fusion SEL. Bought in May '10. Starting this summer, the AC seems to have been taking longer to actually come on when the car is started. The hotter it is outside (especially if the car...

First off is it manual or automatic climate control ? Single zone or duel zone ? It's probably the front blower motor speed control ! electronics .

Mar 09, 2017 | 2008 Ford Fusion

1 Answer

Heat won't work. Heater made a grinding sound

Sound likes possibly the blend door motor has gone bad.
Take it to an AC shop and hav e them check that out....its not an expensive part or hard to change if you know what your doing and where to look

Aug 27, 2009 | 2003 Mitsubishi Galant

1 Answer

Radiator fan not turning on 02 intrepid

maybe the sensor that turns on the fans might of gone bad . . and turning on the ac when engine is gettin hot is not going to help instead turn on the heater to reduce the heat , also overheating causes hoses and gaskets to get soft and get destroyed

May 27, 2009 | 2002 Dodge Intrepid

1 Answer

2007 Dodge 2500 Mega Cab No Heat, AC, Defroster, Vent fan

possible faulty heater resistor block or control head

May 09, 2009 | Dodge Ram 2500 Cars & Trucks

1 Answer

There is no heat or AC plus fan c ontrol does not work.

are their any codes showing up? i'm assuming when the car was jumped the ignition was on, if so this could and can cause a lot of them! one thing you can try is to disconnect the two battery cables,leave them off for 10-15mins,reinstall,negitive first then the positive, again make sure everything is in the off position! good luck to u, hope we helped!

Mar 10, 2009 | 1998 Cadillac Eldorado

1 Answer

No heat or AC in MK4 Golf GTi

The only common faulf is that the heater motor resistor has burnt out or corroded due to a water ingress . The ac take a control feed from the first position resistor when the fan position 1 is selected . Regards VW Audi Tech

Dec 19, 2008 | 2000 Volkswagen GTI

Not finding what you are looking for?
1996 Isuzu Rodeo Logo

464 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14398 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides