Question about 1998 Jeep Wrangler

3 Answers

Motor mount i think my rear motor mount might be broken and ive looked everywhere online and cant find a diagram. i have a picture of it but thats not helping me either. if you could put me in the vecintity of where its located that would be great.

Posted by on


3 Answers

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 17 Answers

The front mounts support the engine at each side (passenger and driver side of the engine block.

These supports are made of resilient rubber.

(1) Disconnect negative cable from battery.
(2) Raise the vehicle
(3) Support the engine using a block of wood between the oil pan and floor jack so you dont dent the oil pan.
(4) Remove the nut from the through bolt but DO NOT remove the through bolt.
(5) Remove the retaining bolts and nuts from the
support cushions
(6) Remove the through bolt.
(7) Remove the support cushions.

Transmission mount (aka rear engine mount)

A resilient rubber cushion supports the transmission
at the rear between the transmission extension
housing and the rear support crossmember or skid

(1) Disconnect negative cable from battery.
(2) Raise the vehicle and support the transmission.
(3) Remove the nuts holding the support cushion
to the crossmember
(4) remove the crossmember (sometimes you dont have to completely remove it but its easier if you do)
5. Remove the tranny mount

Posted on Jun 11, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Jeep Master
  • 1,224 Answers

You have sveral mounts to motor mounts both sides then you have tranny mounts

Posted on Jun 10, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 702 Answers

The engine mounts are located about the middle of the block on the side of the engine. The only other mount is located under transmission.

Posted on Jun 10, 2008

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Have some sort of broken part in rear of my car

If the manual doesn't contain the picture, then you should be able to find one online. If you are worried about realiability, you can usually get help from the dealer you got the car. They may have diagrams that can help you decide what parts you need.

Elisa Jed '

Apr 07, 2014 | 1998 Chevrolet Lumina

1 Answer

Can't find a Rear Wiper Arm replacement

Try looking in a breakers yard or check ebay to see if anyone selling your part.

Dec 11, 2013 | 2008 Dodge Grand Caravan

1 Answer

My truck has a vibration which i have not been able to pin point.ive changed transmission mounts motor mounts harmonic balancer transmission converter,ujoints,evrything but the drive shaft.ive ownwd it for...

thats got me....the only thing that i can think of is has the vehicle been involved in a colision before you owned it,you may need to do a plumb make sure the chassis is square.sorry cant think of anything else to do.

May 24, 2010 | 1990 Dodge Ram

2 Answers

Engine repair forgot how brackets and braces go please help need diagram or pictures

Which brackets are you refering to? The motor mount brackets?
You can go to and register for free online repair manual with many diagrams and step by step directions.

Nov 23, 2009 | 1999 Buick LeSabre

3 Answers

Loud knocking under drivers right foot. Cant see anything under the car everything looks good. But can feel knocking agains foot when driving. Even when stopped at light can fell some kind of knocking and...

It sounds like a broken motor mount.
It may be a "lost" motor mount screw / nut.

Symptom? It probably makes more noise/thump when you make a sharp turn to right or left.
Also when you "rev" the engine...

Hope this helps!

Sep 06, 2009 | 2005 Nissan Altima

2 Answers

How do you replace serpentine belt on 1998 Olds88

i actually just bought the same car. there is a spacer about 4 inches long near the a/c compressor that has a long stud going thru it and a nut at the end.this is what "traps' the serp have to look closely otherwise you will think you have to disconnect motor mount.the stud unscrews-its an inverted(female)torx.ive been a mechanic for 20 years.its not the simplest design they could have made.the stud threads into either the block or timing cover,i forget which.once you have the stud out,wiggle or pry the long spacer out and youll be able to remove the belt.

Jul 30, 2009 | 1998 Oldsmobile 88

Not finding what you are looking for?
1998 Jeep Wrangler Logo

Related Topics:

466 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides