Question about 1992 Mazda MX-6

1 Answer

Drivers side electric window switc

Disconected wiring and did not take note of what wire went where

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

What wire are you talking about? there should be 2 on the switch

Posted on Mar 11, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

Window control on drivers side wont work for passenger or driver and mirror control dont work

i would check the fuses for the passenger and passenger side front windows. It doesn't sound like a motor issue as both sides aren't responding. since both sides are not working it most likely isn't the switches. it might be the regulator, however, it's suspect that both side are failing at the same time seems to be a fuse issue.

I would look at this first and then work my way through the system.

good luck

Jul 20, 2014 | 2009 Dodge Journey

1 Answer

What else would cause the power windows to not work in a 2000 buick century other than the fuse and the switch

I have the same problem try this pull the swith out of the door panel. without disconecting on the bottom side of the connector i ran a long piece of wire from the neg batt terminal to the black wire the windows worked a broken or damaged ground seems to be common.the driver door i pull out the locking clip on the connector wich gave me better access to the black wire

Mar 03, 2013 | 2000 Buick Century

1 Answer

Lincoln Town Car The pasenger side windows(front and rear) just stoped working. i checked the fuses and everything seems to be alright. everything else is working properly all electric system exept...

The wires run under the front seats. They start at the drivers side and travel under the plastic panel at the door jam, then cross over to the other side. then they go forward and back to the doors and other electrical devices in the car. these wires can break anywhere. but usually at the door jams. Corners mostly. You will need an electrical schematic and ohm/volt meter to trace the wires. Also a piece of wire about 5 feet long and lots of time. This not a fuse or relay problem as all the doors work off one circuit breaker. If it went bad then none of the doors would work. Let me know, I can help. also there is the slight possibility that both motors went out at the same time. Randy

Aug 17, 2011 | Lincoln Town Car Cars & Trucks

2 Answers

The front passenger window only goes down but not

it's working from the drivers side. i would assume the passenger switch is bad or there is a wire disconnected from the switch.

Mar 29, 2010 | 2001 Hyundai Elantra

1 Answer

Heater doesnot blow out of floor ducts when switced, blows out of dash for all the time

ur ductwork under the dash is disconected or the part that you switch's to the diff vents broke off. when u pull the part out of the dash, there might be a metal bar attached to it. that might of broke off. if its all wires attached to it. then it might be the part that the wires plug in to

Mar 05, 2010 | 2001 Dodge Durango

1 Answer

Need electrical diagram for power windows motor . my power window drivers side went down but will not go up? I switch thr switch and it is not the switc. I think it is the motor.HELP!!!!!!!!!!!!!!!

ck for power in the up and down positions at motor... one wire will lite up and the other wire will down... if no power up try looking at the wires in the door jam there covered by a rubber boot... if power to motor in both directions then its the motor

Jul 31, 2009 | 1991 Ford F150

1 Answer

Power windows don' work , master switc is good an fuse looks good.

check the wiring in the drivers door jam in the rubber boot probably broken wire there more than likely blue wire.

Jun 05, 2009 | 2002 Mitsubishi Galant

1 Answer

Continuous ground fault csusede by driver side seat belt

if you disconect the wires going into the seat belt return box theres a wire connevtion going into it. disconect it and check to make sure its clean. and replace it connections are in good condition

Mar 20, 2009 | 1990 Jaguar XJ6

1 Answer

Alarm electric windows and mirrors and interior light not working

same problem here there are wires under the drivers carpet open that up and you will se alot of wires disconected cinnect them and you will be good to go but now when i connected the wires my windows dont work

Mar 09, 2009 | 2000 Volkswagen Passat 4Motion

Not finding what you are looking for?
1992 Mazda MX-6 Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

77939 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8832 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides