Question about Ford Laser

1 Answer

Distrubotr ford laser

Having troble with fard laser distributor, coil was broken have fixed it but car doers not start

Posted by on

  • jkcouts Jul 11, 2008

    once car engine gets hot from running when you cut the car off it doesnt want to start just turns over buts doesnt crank. Once it cooled off it would start. I replaced the coil and the problem went away. ran the car for 1 hour straight cut it off started right back up. But today it started doing the same thing. I had the coil tested and it tested good put the coil back on the car still wont start. Cooled off still wont start. Please help.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 241 Answers

What year is ist ??

Posted on Jun 08, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I fix my 1995 Ford F 150 XLT 300 CI.Inline 6 Cyl that cranks over but,will not start ?


Sounds like a grounding issue , check all hard frame grounds , try grounding the coil to batt

Dec 03, 2015 | Ford Cars & Trucks

1 Answer

1988 ford E350 MH 460 efi no start / no spark


I am having same problem did the test and was not getting signal to coil
Test showed no signal from pip so changed distributor and pip now I have signal from pip but still no spark so must be icm so replaced it and coil and still no spark signal is going in to icm but not coming out im stuck as well

Apr 20, 2014 | 2007 Ford E-350 Super Duty Length XLT

1 Answer

1988 ford bronco11 have feul,but no fire from distributor to coil


with distributer cap off have someone crank engine and see if your rotor is turning if not repair distributer or replace.

Apr 05, 2014 | 1988 Ford Bronco II

1 Answer

Truck wont start


Check for spark at the distributor if no spark check or replace coil pack. also check to see distributor is turning while engine cranking, if not, possible worn out or broken gear tooth on shaft inside engine.
if distributor turns, check for burnt or worn out points and/or contacts on distributor cap.

Dec 27, 2013 | 1986 Ford Ranger 2WD

1 Answer

Ignition spark


You need to replace the TFI module (on outside of distributor) and the distributor pickup coil inside the distributor.

May 08, 2013 | 1990 Ford F150

1 Answer

2002 FORD WINDSTAR SPORT CUT OFF NO SPARK


Remove distributor cup mark position of the distributor rotor start for a second and see if the rotor change position if is not is your timing belt is broken ,if change position check high tension lead from the coil ,rotor,and high tension leads ,coil positive lead and negative. check fuse .

Sep 20, 2012 | 2000 Hyundai Sonata

1 Answer

Car started and ran fine, quit while driving and now there is no spark and turns over.


Hello first of all

In reading your issue at hand not having no spark there is only a few things that can cause this being that its a 1988 car i will list below what you need to go over and check.

1.spark plug wires
2. distributor cap
3. ignition rotor
4. coil pick up
5. faulty distributor

That being said most are a easy and cheap fix plug wires run about 20-35 bucks autozones duralast brand , distributor cap runs between 7-18 bucks , ignition rotor 3-8 bucks , coil pick up about 15-30 bucks all at autozone.

Now there is no real way to tell if there bad but a good examination of the distributor cap and rotor should tell you corroded inside cracked worn down.

i would start with distributor cap , ignition rotor, coil pick up if the car starts after this replace spark plugs wires. If that does not fix it most likely you distributor is faulty itself.

i hope it helps if so could you leave me so 4 thumbs up feedback thanks so much

May 16, 2011 | 1988 Ford Festiva

2 Answers

93 ford probe gt loss of power at 3rpm we have changed the mass air flow censor and the distributer


check the plug s and the wirers if thier bad thats a start also if it coils check them and the distributor

Apr 06, 2010 | 1993 Ford Probe

1 Answer

1994 Ford F150 wont start, changed starter,solenoid and battery still wont start


1 Inspect Ignition Switch Improperly Connected or Faulty Ignition Switch. 2 Inspect Battery Battery Discharged or Faulty. 3 Inspect Battery Cable Coroded, Broken, Shorted or Poorly Connected Battery Cable. 4 Inspect Solenoid Switch Starter Solenoid Switch Faulty. 5 Inspect Starter Starter Motor Faulty. 6 Inspect Wireset Worn or Damaged Spark Plug Wires. 7 Inspect Coil -Ignition- Faulty Ignition Coil. 8 Inspect Distributor Cap Loose, Cracked or Worn Distributor Cap. 9 Inspect Spark Plug Incorrectly Gapped or Fouled Spark Plug(s). 10 Inspect Distributor Cap and Rotor Kit Loose, Cracked or Worn Distributor Cap. 11 Inspect Fuel Tank Fuel Tank Empty. 12 Inspect Carburetor Worn, Faulty or Damaged Carburetor. 13 Inspect Fuel Pump Faulty Fuel Pump.

Sep 03, 2009 | 1994 Ford F150 Styleside Supercab

2 Answers

62 ford falcon will not start


Hello, I see you have changed all but the condensor? this may be the last item to sort it?
Have you tried a hot wire direct to the coil to eliminate ignition switch?
Hope this helps!
Please remember to rate my effort.
Paul 'W'
Onyer~EDson(:0) {#><U.K.

Jan 20, 2009 | 1965 Ford Mustang

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

269 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...