Question about 2000 Dodge Caravan
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
you need to put a ratchet ******** the front of the engine and remove the dog bone engine mount this will allow the engine to be pulled forward with strap and you can reach behind and remove the plugs or you can get them from underneath the van hand tightened with a spark plug socket and wrench if you overtighten they will break
Posted on Nov 11, 2008
a lot of pain and heart ache. even on a rack they are a pain . check with your dealer there wae a recall on them for failing its worth the phone call to see kdc744
Posted on Feb 08, 2009
Yes, these are tough to get at from the top. Put the front on jack stands or ramps, and you can reach them a little easier from the bottom. You just need to reach up where the exhaust pipe comes down, and you can even see what you're doing this way.
Posted on Apr 02, 2009
the cooling fan relay is not in the fuse box.
it is a solid state relay bolted to the radiator core support just behind the bumper
Posted on Jun 16, 2009
There are tow ways to get to the plugs, You can get to them from the top or from the bottom. There's quite a bit a bit of room in the transmission tunnel, and you can reach up and actually touch the plugs. There is trouble with the "alternator plug" (#1) , Hard to reach it from below, and you may ended up removing the alternator bracket and shoving the alternator back.
From the top end, removed the windshield wipers/cowl assembly, the intake plenum, remove the bracket from the alternator, easy, and the hardest part is just removing the bracket holding a wire harness from the back of the plenum, the bolts are a little hard to get to due to the a/c lines, but after they were out the plenum removed with ease and I replaced the back plugs(with champion double platinum RN14PMP5 OEM's) and replace the spark plug wires with BWD Selects. They are very good wires. Used anti-seize of course. Mounted the wire harness bracket back, put the plenum(with new gasket), vacuum lines, sensors, and alt.bracket back on then changed out the front ones. Replaced Wipers and your good to go.
Note: if from the bottom rotate the alternator to get the pass side and from below to get the middle and drivers side. You can use a jack stands and a creeper. Takes about an hour. Yes it's a PITA but, going from below greatly reduces the chance of spinning a bolt head off or breaking something else in the process of getting to the plugs. No special tools needed. Good luck and if your lazy like i am just change the front ones and have a local shop replace the rear, they have the lift and will only cost an hour shop rate in your area. $65.00/hour average.
Posted on Jul 01, 2009
Tips for a great answer:
Apr 08, 2015 | 2011 Dodge Grand Caravan
Jan 13, 2012 | 2000 Dodge Grand Caravan
Nov 06, 2011 | 2000 Dodge Grand Caravan
Jun 06, 2011 | 2000 Dodge Caravan
May 15, 2010 | 2002 Dodge Grand Caravan
Oct 22, 2009 | Dodge Grand Caravan Cars & Trucks
Sep 17, 2009 | 2004 Dodge Grand Caravan
Mar 31, 2009 | 1994 Dodge Grand Caravan
125 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: