Question about 1998 Chrysler Cirrus

Open Question

I have a '98 2.5L V6 Cirrus. One night the engine was running just fine and I stopped at a gas station ran inside came back out and as soon as I started it it had trouble getting RPM's no matter how hard I pushed the gas pedal. I pulled over and stopped it then tried to start it again and it wouldn't. Now every time I try to start it, it will turn over but not fully start. It just sits there and tries to crank up.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 17 Answers

SOURCE: Engine is stalling

I had a car do the same thing. It turned out it was the PCM. Also if that does'nt work try replacing the Crank sensor.

Posted on Jan 08, 2009

Ad
  • 416 Answers

SOURCE: Chrysler Pacifica will not start.

Most probably starter problems. It can be not starter itself some vires coming to it are loose. To locate the starter follow heavy wires coming from battery. This how starter looks like
http://www.autozone.com/N,16400045/shopping/partTypeResultSet.htm
Check the wires coming to it. Also check the fuse, it might be bad starter relay fuse too.
Please kindly let me know it the information was usefull for you or you still need more info
Good Luck

Posted on Feb 04, 2009

  • 202 Answers

SOURCE: need to see owners manual

There is a starter fuse in the black fuse box under the hood. It will have the label of each on it. If you replace the fuse, and it blows again, then the starter is bad.

Posted on May 15, 2009

  • 1392 Answers

SOURCE: 1999 CIRRUS WON'T START!!!

Right area. If it is a 2.4L, replace them. If it is a 2.5L, you need a distributor most likely.

Posted on Jun 18, 2009

  • 295 Answers

SOURCE: 1999 Chrysler Concord won't start at times and dies while driving

Have somone check the timing belt make sure it has not jumped any teeth common problem on a old car with high mileage.

Posted on Sep 04, 2009

Testimonial: "I verified the problem was the timing belt. I thought it was the MAP sensor but turns out, timing belt was about to break, thanks."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Received bad gas car is spuddering when I drive, what can I do?


The first thing you should have done was go back to the gas station and complained. If you can prove you bought the gas there, the station is on the hook for the cost of repairs. They have insurance to cover it. Then you take it to a shop to get it fixed.
You may have to change the filter screen in the tank since there is no external fuel filter on the car. And that injector may have to be replaced too.

Jan 24, 2013 | 2005 Nissan Altima 3.5

1 Answer

The engine starts using the gas pedal but stops when letting off


Well if it is an older car with a carb.,just adjust the throttle cable.....the cable might have slipped

Jul 29, 2012 | 2000 Dodge Durango

3 Answers

I start the car and it runs fine but in 5 sec it dies, the car ran just fine on friday night and now tuesday it has this symptom. It was also very cold this weekend


It is possible that you have some water in your fuel. If so, it can freeze if the weather is cold enough and prevent fuel from getting to your engine. If you can somehow warm the car up a bit, you can put some methyl or even better isopropyl alcohol in the fuel and run it for a while. Note that if it IS ice, it will go away as soon as the weather warms up enough. But it is a good idea to run some methyl or isopropyl alcohol, even if you do get it started when the weather warms up, so it doesn't happen again. It is very unlikely to get water in your fuel at a gas station. It happens due to condensation in the gas tank if you don't fill it up every time you get gas. If you keep it fairly low all the time, it will take a lot of moisture from the air. The methyl or isopropyl alcohol will blend with the water and allow it to burn off.

Feb 23, 2011 | 1998 Buick Regal

3 Answers

2002 express 1500 van, will not start


remove dog house locate test port and install guage should be 45-60 psi

Mar 03, 2010 | 2002 Chevrolet Express

1 Answer

When engine is warmed up the car begins hesitating


I really think it's the TPS, (throttle positioning sensor) on the throttle body. When this sensor is defective or out of position the vehicle will idle like that and even stall. If you haven't had it scanned, you should do so, that will probably tell you the problem.

May 28, 2009 | 2002 Nissan Xterra

1 Answer

Check engine light 2000 chrysler cirrus


if you live in the states autozone will scan the codes for free

Apr 14, 2009 | 2000 Chrysler Cirrus

1 Answer

1987 IROC, Ran out of gas,put gas in, now service engine light on


if you have high milieage you may have sucked in the gunk on the botton of your tank when you ran out of fuel check if you can hear the fuel pump running for about 2 sec with key on engine off if you hear nothing the problem is with your pump as they will burn out if they run dry for too long,if you hear the pump check for fuel pressure if pressure low check fuel filter to see if clogged by gunk from bottom of tank.

Mar 02, 2009 | 1987 Chevrolet Camaro

1 Answer

Won't run at three quarters of a tank


air vent in filler cap blocked

Oct 21, 2008 | 1996 Chrysler Cirrus

Not finding what you are looking for?
1998 Chrysler Cirrus Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...