Question about 1996 Jeep Grand Cherokee
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
difficult one but not surmountable,need right tools to remove grille and find a way into bottom of catch ,suggest you call your local mobile mechanic as this sort of thing is hands on and without car in front of me its difficult to advise as iam a general mechanic with a bad case of old timers.but most likely cause is the outer cable has pulled through the end fastening but what end ?? as i wrote its a hands on job.
Posted on Dec 02, 2008
u can use wire prob and tap back of fuses on metal contacts and whe it doesn't like on both side it is blown pull and replace
Posted on Jul 06, 2009
The sensor is located in the very front on top of engine slightly to the right, If you open the hood and lean over the engine just so you can see through the gap between the fan and the engine you will see two rubber radatior hoses kinda to the left then you will see the sensor to the right of them ,kinda looks like a spark plug with a plastic plug on the end of it with two wires connected to it.It screws into the ingine.
Posted on Oct 07, 2009
Testimonial: "thank you, very helpful"
It sounds like you have two issues.
The fan only runs on high because you have a bad resistor for the fan motor. ( the high speed is the only speed that doesn't run through the resistor.
I believe you also have a bad fan speed switch.
I hope this helps you.
Posted on Feb 03, 2011
Tips for a great answer:
Jan 30, 2013 | 1996 Jeep Grand Cherokee
May 01, 2012 | 1996 Jeep Grand Cherokee
Nov 20, 2011 | 1997 Jeep Grand Cherokee
Sep 29, 2011 | 1993 Jeep Grand Cherokee
Mar 05, 2011 | 1994 Jeep Grand Cherokee
Feb 05, 2010 | 1997 Jeep Cherokee
Jul 31, 2009 | 1996 Jeep Grand Cherokee
79 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: