Question about 2000 GMC Jimmy

2 Answers

Ignition key The ignition key won't go all the way in.

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

No key for a 2000 gmc k2500 I know how to replace with a key but i dont have key to turn to access retaining pin

Posted on Nov 30, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • GMC Master
  • 1,224 Answers

Key cylinder pin that holds it in is stuck replace key cylinder they will give you new key along with this

Posted on Jun 08, 2008

6 Suggested Answers

  • 22 Answers

SOURCE: Ignition key won`t turn on my chrysler cirrus

tap the lock cylender with a small hammer it will free up the tumblers and the insert key and its working again.

Posted on Jan 08, 2009

  • 14 Answers

SOURCE: 98 ranger locked in park,ignition key won''t turn to start

there is a harness that feeds the ignition remove your steering wheel cover and you will see about a dozen wires going into a clip that is attached to the back of the steering wheel , those wires give way and are not making contact reach in to the back and pull the harness forward and then try and push each wire back into the clip try this and see if it works it solved my problem basicly it is just a loose wire in the harness,,

Posted on Jan 13, 2009

  • 69 Answers

SOURCE: ignition key won t turn. steering wheel locked

the key may be worn badly or the ignition needs to be replaced.

Posted on Jul 31, 2009

  • 55 Answers

SOURCE: 1997 pontiac grand prix key won t turn ignition

well does the key go in does it turn to the start pos? if the dash dost power up its because the switch is bad if it will power up but not start it can be becuse of the resitor chip depends on what is going on if you cant get power its becuse of the switch

Posted on May 09, 2010

  • 1403 Answers

SOURCE: key stuck in ignition but it will turn, and

you most likely have a bad key switch cylinder assembly. you can try to spray wd40 solvent into the switch before you have the switch replaced,but sometimes it's a switch replacement that repairs the problem. have you inspected your ignition key to look for damage to the key itself? try a spare key to make sure it's the key,and not the key switch. you can also try turning the key while turning the steering wheel at the same time to get the key to work.sometimes the switch locks when parked in a bind,such as on a hill,or against a curb and so on. try this 1st before you have the ignition switch replaced. AAA auto club,if you're a member covers part of the replacement costs for a replacement switch also. you may have coverage through a cell phone also.one more thing to try, if you have a tilt steering column,try to reposition the steering wheel to see if you can get the key to turn. remember never force it enough to break your key off into the switch! thank you for choosing fixya.com!

Posted on May 13, 2011

ryanlutton
  • 966 Answers

SOURCE: My 1998 Olds Bravada has

I know in the newer versions of the Bravada, Trailblazers, Envoys, the ignition switch itself is always the culprit. Not the switch the key goes in, but it's located under the steering wheel column. I know how to replace the newer ones but not yours. That's the first place I'd look.

Posted on Jun 07, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ignition of ford edge will not turn completely off..it is stuck in position 2 in auxillary power


1-
My ignition key will not turn to off. I can remove the key, but it stays in the accessory mode. What's the fix?
My ignition key will not turn to off can remove the key but it stays in...

2.
Ignition key is stuck and does not turn Inspection Service & Cost
Ignition key is stuck and does not turn Inspection Service Cost...

3.
Ignition key won turn

Aug 24, 2016 | 2012 Ford Edge

1 Answer

Ignition wont turn


if you mean the key won`t turn to start the car you may have a worn key and or ignition switch. try another key to see if its the key. also make sure there is not tension on the ignition by way of the steering wheel being turned in the full left or right turn causing tension on the ignition.

Aug 15, 2014 | Cars & Trucks

1 Answer

Key won't turn in the ignition


probably need a new ignition lock or your key is wore. ignition locks arn't too bad to change depending on the vehicle.

Jul 14, 2013 | Cars & Trucks

1 Answer

Toyota rav 4


ignition keylock cylinder broken or could have the wrong ignition key.

May 06, 2013 | 1998 Toyota RAV4

1 Answer

Cranks and then goes dead


First check your fuel pressure it should be 41-47 psi with key on and engine off if its below 32 psi replace the fuel pump and filter.If fuel pump checks out to be good then take ignition switch out and check for burned ignition switch wires and worn ignition key tumblers and ignition lock cylinder.These cars are known for faulty ignition switches and ignition lock cylinders.Ignition switch gets to hot then it won't start until it cools off.

Dec 30, 2011 | 1996 Pontiac Grand Am

1 Answer

1998 Plymouth grand voyager ignition won't turn


I have had this happen on my 98 Voyager. Just have a new key cut. This new key will sometimes cure the problem. The older keys get worn out and won't unlock the ignition. Try this before a much more expensive and time consuming change of the ignition.

Nov 01, 2011 | 1998 Plymouth Voyager

1 Answer

My key wont turn to off in order to remove my key from ignition while in parking


Ignition - Key Stuck In Ignition Switch/Won't Turn Bulletin No.: 06-02-35-005 Date: February 28, 2006 TECHNICAL Subject: Key Stuck in Ignition, Key Will Not Return to Off Position, Shifter Button Won't Release in Park Position (Adjust Shifter Detent Finger) Models: 2002-2005 Chevrolet Monte Carlo Condition Customers may comment on any of the following conditions: - The key is stuck in the ignition cylinder. - They cannot return the key to the off position to remove the key. - The shifter button won't release in the park position. Cause This condition may be caused by the detent finger shifting over time. This may result in mis-alignment and binding of the shift rod on the shift position guide.
WHERE YOUR SHIFTER IS YOU WILL HAVE TO TAKE IT APART ..MAYBE THE RUBBER BOOT IS IT THE WAY,OR THE SHIFT LOCK SELINOID WHENT BAD

Aug 05, 2011 | 2005 Chevrolet Monte Carlo

1 Answer

Put key in ignition and it won't turn


Your ignition is bad, or your key might be worn out if you have more then one you might try that. Other wise you will have to replace the ignition switch.

Jul 28, 2011 | 1989 Ford Thunderbird

1 Answer

Ignition key won t turn. steering wheel locked


the key may be worn badly or the ignition needs to be replaced.

Jul 31, 2009 | 2004 Saturn VUE

2 Answers

Ignition key won`t turn on my chrysler cirrus


tap the lock cylender with a small hammer it will free up the tumblers and the insert key and its working again.

Jan 08, 2009 | 1999 Chrysler Cirrus

Not finding what you are looking for?
2000 GMC Jimmy Logo

Related Topics:

203 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...