Question about 2001 Ford Windstar

1 Answer

Will not start bat is good starter is good - 2001 Ford Windstar

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.


    An expert who has answered 20 questions.

  • Expert
  • 56 Answers

Does it turn over? If so, listen at the fuel tank for a momentary whirring sound when the key is turned to "ON" not start. If no whirring is heard, the fuel pump is dead.

Posted on Oct 24, 2010


1 Suggested Answer

  • 2 Answers


Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Everything lights up but wont crank the engine ovet

The way to start is to ck your battery for 12V & clean bat terminals. Ck the ignition fuse &locate & ck the starter relay for power & ground. Jump the relay between the 2 conn (pwr/grd) See if you start.. Key on If OK r/r relay, If it doesn't work, follow the RED wire to the starter & ck for 12V there. Also ck for a good ground conn at the starter (both with good readings & clean conn. If all is well there when someone else is turning the ignition key to start, then the starter is NG If readings at the starter NG, relocate the starter relay. Good luck, Frank M

Feb 28, 2016 | Cars & Trucks

1 Answer

Engine ust started dragging when trying to start. bat/str good

Start with cleaning your battery terminals. If you can check voltage at the starter when trying to crank, and make sure you have good grounds everywhere.

If you need further help, reach me via phone at

Nov 28, 2013 | 2004 Saturn ION

1 Answer

Doesnt want to even attempt to start the battery is good

Try tapping the starter with a hammer while someone bumps the key. If it tries to turn replace starter if nothing happens then i would say the starter solenoid is probably bad.

Nov 26, 2013 | Cars & Trucks

1 Answer

Starting issue

Hi Mark, I would agree with your diagnostics. If you have replaced the battery already before replacing the starter motor make sure all the connection including the negative connections are clean and making good contact. Once that has been done and still no improvement go for the starter motor. Regards John

Jul 20, 2013 | 1999 Chevrolet Venture

1 Answer

Engine not starting at all

check all wire from bat to starter pole and so on start from bat and all the way to the spark plugs

Jan 24, 2013 | 1992 Mercedes-Benz E-Class

1 Answer

My taho wont start. When I go to start it it wont turnover it acts like the theres no starter. Battery is good. it has done this before but tried to start it a couple of time and it started. Do you think...

Find the starter relay in the fuse box under the hood and swap it with another relay of the same type. If the starter works then the relay is no good. Also check any fuse that is labeled Ign. or Bat.

Jan 06, 2011 | 2002 Chevrolet Tahoe

2 Answers

Subaru impreza 2002,will not start. The light for

needs a good battery to turn over and start up check bat leads,clean,tight,is bat okay

Jul 05, 2010 | 2002 Subaru Impreza

1 Answer

1992 ford ranger 4.0liter auto trans

The clicking noise is coming from your starter or more specifically your solenoid on your starter. (It's attached right on the side of your starter.) If you can find a way to get to it, take something hard and tap on the solenoid and that will free it up. If that doesn't work try tapping it and the starter while someone else is turning the key. If it happens again it means that your starter is going out and you will have to replace it but that is easy enough so don't worry about it. Hope this helps, let me know how it goes. Goodluck!

May 04, 2009 | 1992 Ford Ranger

1 Answer

All power is lost after turning key will not start have good bat starter and alt power comes back if bat un hooked and reset

Sounds like you may have some severly corroded terminals since you disconnect and reconnect the battery to establish power again. Check you cables and the connections. This includes the ground cable also.

Feb 26, 2009 | 1995 Lincoln Town Car

2 Answers

89 wrangler

there should be a sloenoid on the firewall it could be bad

Aug 26, 2008 | 1989 Jeep Wrangler

Not finding what you are looking for?
2001 Ford Windstar Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides