Question about 1990 Toyota Cressida

Open Question

Drivers door wont open. lock is stuck. spring on locking mechanism is broken. where can i find a new spring. and which spring is it

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1861 Answers

SOURCE: driver side door lock

Pull the door panel & replace the electronic lock solenoid.
Not easy, but this is what you need to do.

Posted on Sep 09, 2008

Ad

SOURCE: 2005 Toyota Sienna Sliding Door Won't Open

Replace the battery or reset the computer could work. My 2 cents.

Posted on Nov 03, 2008

  • 65 Answers

SOURCE: 2004 toyota sienna sliding door locking trouble

Sounds like something isn't right.Try to disconnect the battery for a few minutes and see if that helps.Some times the ecu gets haywired and disconnecting the battery might reset it.And if it is the original battery you might want to get it tested.

Posted on Dec 04, 2008

  • 1861 Answers

SOURCE: 1991 Toyota Camry DX - Front Passenger Door Lock won't disengage

Your power door locke solenoid is seized. You will need to replace it. You are going to have to get the entire door panel off, and then reach in to manually pull the solenoid arm to retract the lock mechanism. Then the door will open.

Posted on Mar 06, 2009

  • 155 Answers

SOURCE: '00 Toyota Sienna-stuck door

the lock actuator is binding/hanging up, replace it and lube the linkages this should cure that problem....hope this helps...let me know...GL

Posted on Jul 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 Lexus LS430 with easy locks. Driver side rear door comes open while driving


Check out spring housing inside the door lock actuator. I had the same problem, some work anf JB weld will fix it,

Jul 23, 2012 | 2006 Lexus Ls 430

3 Answers

Citroen saxo 1.1 driver door will not open


hi drivers, i am looking into the same fault for my mums Saxo forte. there are three problems as well as the post above about the child lock. (on drivers door, remove the trim panel and cut the poly material away on the end near lock. look in to the right and with the 3 T30 size torx bolts removed, carefully tilt the lock towards you so u can see the white plastic.) the child lock is at the bottom. mums wasn't stuck so i looked further into it and found the handle mechanism to be jammed and broken. this has a linkage rod that needs replacing for a few pounds from Citroen. You will need a 4 mm drill and a rivet gun to change door handle. i fixed this and now door opens and closes and will work with the key. but door wont open from inside using the pull lever. looking closely at the top right of the lock unit check make sure the long link rod is connected at both ends, i have now found that there is a spring or connecting bit that allows the door to open from in car. i am trying to find the right part for this without replacing the lock mechanism at around 70. wen i find this and the door works fully again i will post the fix method.

Jul 09, 2012 | Cars & Trucks

1 Answer

Drivers door wont open


If it were me , I'd remove the inside door panel and take it from there. It may be that you can pry open the lock mechanism with a screw driver or a similar tool, allowing you to open the door - which obviously you must do. Even that, though, will not solve the cause of your problem. You may wind up at the dealer.

Aug 19, 2017 | 1986 Ford Tempo

2 Answers

Hi, I have a 1998 Jeep Grand Cherokee with a 'stuck' liftgate latch. It is stuck closed, so that I cannot close the liftgate. I have sprayed it with WD-40, Silicone spray, no luck. It feels like a spring...


Hi! The spring on the locking mechanism may be broken. You need to replace this spring. If you cannot find a spring for the locking mechanism then you can start putting on a similar one just as long that its powerful enough to hold the trigger on the latch. You may need pliers, spring, 12 or 14 closed / open wrench. Hope this helps and have a good one!

Apr 14, 2010 | Jeep Grand Cherokee Cars & Trucks

2 Answers

My driver side door wont close. the handles seem to do nothing. any advice?


the door lock mechanism has a broken spring internally .door lock has to be replaced.

Jan 15, 2010 | 1998 Ford Windstar

1 Answer

1993 Cutlass Supreme S 4 door sedan Drivers side front door locked when door was open, the locking mechanism is stuck is stuck and the door can not be closed. How can this be fixedd?


take a screwdriver and put in gap of mechanism and apply pressure while lifting door handle the latch should open if it falls back means spring is broken on latch will need to remove door panel and the 3 screws that hold it in place can get a replacement at a salvage yard for a few bucks

Dec 14, 2009 | 1993 Oldsmobile Cutlass Supreme

1 Answer

My 1995 camry xle v6 driver door wont unlock.


i just had this same problem. it was the lock assembly. the spring had broken on it and the lock was halfway unlocked and locked. so it would not move, therefor the door was stuck shut neither locked nor unlocked, but with no way to open it. so we had to manually unlock the door with a stick between the door panel and the window. then we were able to take off the whole door panel and fix the problem. but by this time, its probably easier just to buy a whole new door. hope it helps

Nov 30, 2009 | 1995 Toyota Camry

1 Answer

The driver side door lock wont go all the way up.


The outside door handle spring is broke ,or the latch spring is broke. The only way to tell is remove the door panel and inspect the rod from the handle to latch. Look for broken spring on handle. I have installed an external spring from the handle rod to latch to keep the rod in the full up position.

Nov 18, 2009 | 1999 Ford Ranger SuperCab

4 Answers

The driver door on my 2004kia optmia wont open.


If you have tried the inside, and outside door handle, and it does not open you need a new door latch assembly.

Jul 11, 2009 | 2003 Kia Optima

2 Answers

Central locking keeps locking the car. Unable to open drivers side door


Hello, we have a 2003 Kia Rio- problem as above- unlocking and then locking- only way in and out through passenger door.
This is what I have done and everything is back to normal- I hope it works for you.
1 Remove 25AMP fuse that controls door central locking from main box under the bonnet.
(AT this stage my passenger door opens- drivers side does not, the mechanism won't fully rotate)
2, Spray key with WD40 (or similar moisture repellent lubricant). Gently turn key to loosen mechanism- Partly remove key and spray lubricant into lock, have fun locking and unlocking!
3, Replace 25 amp fuse
4, Write yourself a cheque for garage labour and parts and wife brownie points!

Aug 09, 2008 | Kia Rio Cars & Trucks

Not finding what you are looking for?
1990 Toyota Cressida Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...