Question about 1988 Ford Crown Victoria

Open Question

How to replace the speedometer cable in a 1988 ford crown victoria 5.0L 8cyl. my speedometer just wont work i have done everything i can think off.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 261 Answers

SOURCE: 2000 Ford Crown Victoria

when you hold the accelerator does the vehicle stay running? if so the problem is in ithe IAC idle air control motor, take a small screw driver and using the handle tap the iac motor and usualy the motor will kick in and the vehicle will run fine then if the problem is rectified replace the IAC

Posted on Nov 24, 2008

Ad
mrgreenz
  • 962 Answers

SOURCE: my speedometers does not work

Check the speed sensor at the tranny.Get a trouble code at any autoparts store.

Posted on Feb 06, 2009

  • 33 Answers

SOURCE: need wiring diagram for 2008 ford crown victoria

Hello,

You can purchase the wiring diagram for $5.99 from the following site: http://www.wiring-diagram.com/. You can also purchase a wiring diagram book from the following link: http://cgi.ebay.com/ebaymotors/2008-FORD-CROWN-VICTORIA-MARQUIS-WIRING-DIAGRAM-MANUAL_W0QQitemZ120394723100QQcmdZViewItemQQimsxZ20090320?IMSfp=TL090320147007r15080.

Hope this helps,

Chris

Posted on Mar 23, 2009

wyatt1582
  • 453 Answers

SOURCE: where is my fuel pump fuse in fuse box?

Fuel pump relay is under drivers side seat, as far as fuse its under the dash drivers side.

Posted on Apr 24, 2009

  • 102 Answers

SOURCE: how to trouble shoot starting system 98 ford crown victoria

Also check to see if there is power in the start wire form the ignition switch, the wire is a white wire with pink stripe, most likely not a common problem, but still something that could go wrong. this wire will feed the starter relay under the hood...

Posted on Sep 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Coolant Temperature Sensor 2003 Ford Crown Victoria 4.6L SFI 8cyl


Usually found right before or right after the thermostat.

May 02, 2014 | 1996 Ford Crown Victoria

1 Answer

2000 ford crown victoria not getting gas pressure


If you are not getting any gas pressure, then you need to replace the fuel pump.

Mar 04, 2014 | 1988 Ford Crown Victoria

1 Answer

How do you replace a 1994 crown victoria's speedometer cable?


No cable, it's electric. Run by a sensor on rear of transmission.

Dec 15, 2012 | 1994 Ford Crown Victoria

1 Answer

I have a 1995 crown victoria and the turn signals stay lit and autozone said i needed a flsher. so i got a cylinder flsher and it wont fit into my fuse block properly with the fuse block cover over it. can...


For 1995 Ford Crown Victoria 4.6L SFI 8cyl, the Flasher is located: Front seating area, driver side, under dash, driver side of pedal support bracket, mounted in fuse panel.

Hope helps with this.

Dec 06, 2010 | 1995 Ford Crown Victoria

1 Answer

I recently purchased a 2001 Crown Victoria P-71. It came woth a bullet hole through the speedometer and windshield. I have had the windshield replaced, but need help replacing the speedometer. How do I...


open the screws of cover of speedometer and pull it and release the locks then open the screws of speedometer and ungrip the cables. simple thing do not b afraid of opening it nothing will happen.

Aug 01, 2010 | 1991 Ford LTD Crown Victoria

1 Answer

Ford crown victoria


you must replace the multi fuction switch! also known as the turn signal switch! its common on ford crown vic!

Mar 06, 2010 | 2001 Ford Crown Victoria

1 Answer

Speedometer and odometer does not work in 1998 Crown Vic police interceptor


Either the speed sensor,or the dash cluster is of fault. Have Auto Zone test the speed sensor,if ok ,,, I would replace the cluster ( buy used ) much cheaper.
Please rate this.

Jul 27, 2009 | 1988 Ford Crown Victoria

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...