Question about 1999 Nissan Altima

1 Answer

Automatic transmission nissan altima 1999 - 1999 Nissan Altima

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

My battery had a dead short in it which caused my transmission not to shift properly. The give away was that I checked to see if the altnator was putting out and it was not but the engine light was not telling me it was bad. I put a new battery in it and then the altnator stared putting voltage back in the battery. I had a dead short in the battery. The transmission worked fine after I changed the battery. Another problem was the fan for the air conditner and the windows would not work except when the battery charge was conected. This was my first time to see what a dead short in a battery would do. Hope this helps others with this problem.

Posted on Aug 08, 2012

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
ilragatzzo78

francisco navarro

  • 241 Answers

SOURCE: Replacing a starter for a 1999 Altima

  1. Disconnect battery ground cable.
  2. Disconnect starter wiring from starter.
  3. Remove starter retaining bolts and the starter.
  4. Reverse procedure to install.
the bolts should be on the drivers side.
you will have to crawl underneath the car to do this task

Posted on May 15, 2008

Anonymous

  • 2 Answers

SOURCE: 2003 nissan altima 2.5s transmission rough shift

Probably sensors! I have already replaced the crankshaft positioning sensor once, nissan replaced it once under recall and now it is bad again! Plus my speed sensor is bad too! Go to any part store and get diagnostic test ran, it will tell what sensors are bad.

Posted on Oct 02, 2008

Anonymous

  • 1 Answer

SOURCE: Transmission Fluid level Nissan altima 1998, automatic

Hi

The thing is that the car suppose to be idling and at "Normal operational temperature" with the engine idle and parked on an level ground.

Then check the level ...

Matthias

Posted on Dec 10, 2008

jamie

  • 1810 Answers

SOURCE: Nissan Altima tring to change my transmission fulid and filter

thats why you have to remove the frame and for this you need an engine support and the average mechanic will charge you arround 100 bucks to do it
some rental stores have them some dont good luck eithor way you go but for god sake be carefull

Posted on Dec 31, 2009

ZJLimited

ZJ Limited

  • 17970 Answers

SOURCE: How do you remove a 1999 Nissan Altima starter?

Nissan Car Altima & Sentra 1999-06 StarterRemoval & Installation

  1. Remove or disconnect the following:
    Negative battery cable Air duct Harness protector from the harness Starter wiring at the starter Starter-to-engine bolts Starter from the vehicle


  2. b53bb6c.jpg
    Fig. Starter location and mounting detail-3.0L Maxima with a manual transaxle


    b2eb267.jpg
    Fig. Starter location and mounting detail-3.5L Maxima

To install:
  1. Install or connect the following:
    Starter and torque the long bolt to 57-72 ft. lbs. (77-98 Nm) on Altima and Maxima and 41 ft. lbs. (55 Nm) on 350 Z. torque the short bolt to 22-30 ft. lbs. (30-41 Nm) Starter wiring Harness protector Air duct Negative battery cable
  1. Remove or disconnect the following:
    Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter

To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

1.6L & 2.0L Engines
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Remove or disconnect the following:
    Negative battery cable Wiring at the starter Bolts attaching the starter to the engine Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 70 inch lbs. (8 Nm) Starter electrical connections Negaative battery cable

1.6L, 1.8L & 2.0L Engines
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:
    Negative battery cable Wiring at the starter Bolts attaching the starter to the engine Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 70 inch lbs. (8 Nm) Starter electrical connections Negative battery cable

1.8L & 2.0L Engines
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:
    Negative battery cable Wiring at the starter Bolts attaching the starter to the engine Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 70 inch lbs. (8 Nm) Starter electrical connections Negative battery cable

2.4L & 2.5L Engines
  1. Remove or disconnect the following:
    Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

2.4L Engine
  1. Remove or disconnect the following:
    Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

2.5L Engine
  1. Remove or disconnect the following:
    Negative battery cable Air cleaner cover and duct Harness bracket Wiring at the starter Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

3.5L Engines
  1. Remove or disconnect the following:
    Negative battery cable Air cleaner case (upper) and air cleaner to electric throttle control actuator tube. Harness protector from the harness Starter wiring at the starter Starter-to-engine bolts Starter from the vehicle

    42c548c.jpg
    Fig. Starter location and mounting detail-3.5L engine

continue...

Posted on Apr 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Flayweal instal for altima 99 automatic


no flywheel in an automatic transmission car
it is a called a flex-plate and is just a thin plate with a ring gear welded to the outside edge

Nov 26, 2016 | 1999 Nissan Altima

1 Answer

I need to add automatic transmission fluid to my 2001 nissan altima gxe. But so far I could not locate the reservoir. Some one please help. Thanks


No reservoir,it goes in where the dip stick is,remove and put a funnel in hole and add,always check when engine is running and in park.

Feb 03, 2014 | 2001 Nissan Altima

2 Answers

What type of transmission fluid do I need for a 2001 nissan altima


nissan matic D or dextron III/ mercon atf can be used also

Jan 03, 2011 | 2001 Nissan Altima

1 Answer

Have a pan located at the front of my 1999 nissan altima on the right side underneath of the car that is leaking fluid. what is it? it has a hole in the bottom of the pan cause my wife ran over something.


If the fluid is red, it's automatic transmission fluid. If it's anything from honey-colored to black, it's engine oil.

Check both via the dipsticks if you can't visually identify the fluid. Depending on how long it's been leaking, it should be evidenced by a low level of one or the other.

Jul 24, 2010 | 1999 Nissan Altima

1 Answer

How to change transmission fluid????


Transmission Fluid Replacement Replace transmission fluid as follows:
  1. Operate engine until reaching operating temperature.
  2. Turn OFF engine.
  3. Remove the drain plug.
  4. Drain the transmission fluid into a suitable container.
  5. Install drain plug.
    • Torque to: 22-29 lb-ft. (29-39 Nm)
  6. Refill fluid to specified level.
Fluid Type Specifications 4 Speed Automatic Transmission - Nissan Matic "D"
5 Speed Automatic Transmission - Nissan Matic "K"
NOTE: Using Automatic Transmission fluid other than Genuine Nissan ATF will cause deterioration in driveability and automatic transmission durability, and may damage the automatic transmission, which is not covered by the NISSAN new vehicle limited warranty

Jun 20, 2009 | 2004 Nissan Altima

1 Answer

How to replace starter on 1999 Nissan Altima


You need to Replace starter or have battery checked for proper volts.

Jun 16, 2009 | 1999 Nissan Altima

1 Answer

Automatic transmission fluid


Manual States - Genuine Nissan Automatic Transmission Fluid "Matic D" , Dextron III , or Mercon is Acceptable . Brand is really a personal preference . cheers .

Jan 06, 2009 | 2002 Nissan Altima

1 Answer

2003 nissan altima 2.5s transmission rough shift


Probably sensors! I have already replaced the crankshaft positioning sensor once, nissan replaced it once under recall and now it is bad again! Plus my speed sensor is bad too! Go to any part store and get diagnostic test ran, it will tell what sensors are bad.

Sep 25, 2008 | 2003 Nissan Altima

Not finding what you are looking for?
1999 Nissan Altima Logo

186 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...