Question about 1995 Mercury Villager

1 Answer

My 1995 mercury villager-gs liftgate lathe is stuck when i try to open with handle, an answer would be greatly appreciated!!

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mercury Master
  • 4,388 Answers
Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I unlatch a stuck latch on my rear vent window - 1995 mercury villager van


CRC maybe sprayed on latch
like
https://www.crcindustries.com.au/products/corrosion-protection-and-inhibitors/salt-terminator/lubricants-and-penetrants/high-speed-penetrant

May 09, 2018 | 1995 Mercury Villager

1 Answer

2000 Mercury Mountaineer rear liftgate handle is broken, how can I open it?


either crawl into back or if u have split gate where window opens u have to remove the little plastic access cover {on rear panel}and in the hole push against the rod to open ...once opened u can remove the rear panel and lube and or repair the clips that actuate the lock and release rods

Jan 05, 2013 | 2000 Mercury Mountaineer

1 Answer

Liftgate will no open, have taken all the screws out of the plasticc panel on the inside and it still will not remove is tight aroung the hydralic lifter bars is there instructions on how to remove the...


Have you tried holding in the plastic trim that surrounds the liftgate handle, with one hand, while pulling on the liftgate handle, to try and open the liftgate? I've seen this happen on a few Grand Cherokees and that should get it to open. Just make sure you hit the power unlock switch before trying that.

Sep 08, 2011 | 1995 Jeep Grand Cherokee

1 Answer

I can not open my 1995 mercury villager


no switch in van. Spray with penetratingoil & see if it loosens up.

Fixed back glass or does glass open? Handle on back glass?

Go here

http://groups.yahoo.com/group/villagerquest/

Jul 28, 2010 | 1995 Mercury Villager

2 Answers

1996 Mercury Villager liftgate will not close. Tried moving latch (not stuck and appears to spring back), pushing in black 'lock' button next to latch, handle up and down, with key and automatically,...


Maybe the chasis lock (the "U" shaped ring that is located in the base of the trunk moved forward, try to loosen it (not completely) with a star screwdriver, move it backwards (maybe you will need a hammer to accomplish this), then tighten it again and check if it closes. If it does just check if the door seals completely, otherwise you may have to untighten the same part and move it a bit forward tighten it again and check wich is the best position where it closes & seals completely.

Jul 16, 2009 | 2006 Subaru Outback

2 Answers

Rear tail gate will not open


how to i open a stuck lift garte on a ford winstar 2000 lock broken too

Jun 14, 2009 | 2001 Ford Escape

1 Answer

2002 Mercury Villager with weird brake problem


check the brake booster and vac supply to it. big hose on the booster.

Jun 05, 2009 | 2002 Mercury Villager

5 Answers

Mercury Villager headlight assembly diagaram for removal


This is easy. Lift the lid open. Look at the back of the sealed beam and you will see a clip and an o ring. Pull the clip up and pull wires back toward the driver's seat. Unscrew the o ring and firmly pull the bulb out toward the driver again. Note the 3 tabs on the bulb seat and realign the new bulb with those tab ( 2 bottom, 1 top). Replace with #9007 bulbs..do them both.

Jul 01, 2008 | 1995 Mercury Villager

1 Answer

I HAVE A 1996 MERCURY VILLAGER AND YESTERDAY THE BACK HATCH WOULD'T OPEN. IT'S LIKE IT 'S CAUGHT ON SOMETHING


The handle may be stuck in the open position due to rust. Try to push back the handle and play (open/close/open) with the lock control. The same thing will eventually happen to the sliding door, and the culprit is the inside handle, stuck in the open position, preventing the door to close completely. Good luck.

Jun 29, 2008 | 1996 Mercury Villager

Not finding what you are looking for?
1995 Mercury Villager Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

gerry bissi

Level 3 Expert

4388 Answers

Marvin
Marvin

Level 3 Expert

85178 Answers

fordexpert

Level 3 Expert

5692 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...