Question about 1995 Chevrolet K1500

1 Answer

No spark&no fuel I have changed the distributor and all of the components also the coil it will start when it wants.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 75 Answers

Check the starter...
it could be that the starter is going out...

Posted on Oct 23, 2010

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: my 1991 chevy truck S10

also check your alternator, mine did the same and it ended up being the alternator

Posted on Aug 22, 2008

  • 306 Answers

SOURCE: truck has no spark changed fuel pump fuel filter

Odds are it is the $20.00 ignition control module but that may be another fluke change out of parts. LOL

Posted on May 01, 2009

  • 1 Answer

SOURCE: no spark no fuel no start! replaced and checked

funny thing is I have a 2002 GTI with the exact same problem. have spent the last three days at work trying to figure things out.. best of luckn email me if you figure anything out. [email protected]

Posted on Mar 19, 2010

  • 327 Answers

SOURCE: 98 jeep cherokee wont start it is not getting fuel

i just had the same problem on a 1997 4.0 . crank sensor is most likely bad you can spray starting fluid in the intake tube and car will start meaning you have spark but injectors will have no power I.E. crank sensor is bad 38.00 dollars at local parts store dealer told me 170.00 dollars make sure you push it all the way in when you install it i just posted a fix for this on this site today . after you start the car if it gives a misfire code and check engine light comes on loosen the crank sensor bolt and push it in again then tighten the bolt the cardboard on the sensor for the air gap wares off a little bit enabling you to push the sensor in a little bit more misfire should be gone there is only a few thousands of an inch adjustment for the air gap and it makes a difference. hope this helps

Posted on Jul 24, 2010

  • 14092 Answers

SOURCE: 1990 Isuzu 2.6 L 5 spd. No start.. Fuel pressure

COULD HAVE BAD IGNITION PICK UP COIL IN THE DISTRIBUTOR.CHECK WIRES TO IGNITION COIL AND MODULE FOR DAMAGE OR POOR CONNECTION.

Posted on Oct 03, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car doesn't start & there is no fuel sound. Already changed distributor, ignition coil, fuel pump main relay and fuel pump. Fuse is fine but I can't hear the fuel pump. Could you help? Thank you


try spraying starter fluid if starts recheck your installation of fuel components for power and wire connections are good --if no start than start checking ignition system for spark

May 23, 2016 | 1994 Honda Accord

3 Answers

1989 chevys10blazer won't start turns over but won't start one mechanic said it jumped time another one said ignition. Coil or distributor cap put gas in carburetor but it still didn't start


Pull off a spark plug wire and ground it over the engine. Crank the engine over and see if there is any spark from the wire. Sounds as if there is no spark to light the fuel you are putting in the carb. If no spark, possible ignition module/pick up coil inside the distributor/defective distributor cap/rotor/ignition coil/ wiring

Dec 18, 2015 | Cars & Trucks

2 Answers

98 Chevy 1500 Running down road dies Has fuel. Has spark.


If it has spark to the plugs, normal compression, and fuel, it should start. So assuming it does have normal compression, I would want to know if it will try to start by spraying carb cleaner into the throttle body to substitute the injector spray. One of the three components is missing.
Another thing to check is the distributor cap and rotor to make sure spark is reaching all of the plugs at the right time.

Aug 31, 2014 | 1998 Chevrolet K1500

1 Answer

No spark on 2002 sentra se-r replaced crankshaft sensor and camshaft sensor.


heres a list, ignition components damp or damaged, worn or faulty spark plugs, broken...loose....or disconnectedwiring in starting circuit, loose distributor changing ignition timing, ignition coil loose...faulty or disconnected wires. its good your cam & crank sensors were changed, but no spark indicates coil packs not able to get spark to plugs, but spark plugs may be fouled, replace them. replace distributor cap & rotor. check fuses, there's one for the ignition switch, check it. try all this see how it does,, also, if you haven't replaced both the AIR & FUEL FILTERS , DO SO !!!!!!!! just for thought, my daughter has a sentra gxe,2002, it started losing power on the highway, we had to have nissan replace it, $900 , you may have to deal with this, sell the car ! when you get it running, if you want. although , after we did repairs, tune-up, timing belt (not chain), etc., it runs like a top, she loves it ! good car if you ask me, just keep filters new, brakes good, it will go forever !

Mar 11, 2013 | 2002 Nissan Sentra

1 Answer

4x4 v8 1998 dodge truck won't start


well if ur not getting spark and u changed all of the ignition components lets think about the computer in order for the ignition to work you have crankshaft position sensor that fires the fuel injectors and the spark change that and if still nothing then change the camshaft postion sensor that sensor tells the computer that the 1 piston has came all the way up and it tells the crankshaft sensor to do its thing

Feb 21, 2013 | 1998 Dodge Ram 1500 4WD

3 Answers

No spark


First does the rotor turn when cranking engine?? possible timing chain is out or stripped gear..are you sure it has no spark??did you verify this with a high output spark tester ? did you spray starting fluid in the tbi unit ?

Mar 23, 2012 | 2000 Chevrolet Astro

1 Answer

I have a 1990 mitsubishi might max it wont run smooth unless you keep your foot on the gas and keep the rpms up a little bit and it wont drive cause it stalls everytime you try to move it. ive replaced the...


You've already eliminated the spark plug & wireset, distributor cap & rotor.
Sounds like your car needs a tune-up, specifically, the PCV (positive crankcase ventilation) valve, and/of the EGR (Exhaust Gas Recirculation) valve.

Components checked/replaced during a tune-up are:
air filter
motor oil
motor oil filter
breather filter
fuel filter(s)
fuel strainer
PCV valve
EGR valve
spark plugs
spark plug wires
ECM or distributor cap & rotor
cabin air filter
transmission oil filter
transmission oil
engine coolant
check all vacuum hoses and lines

Troubleshooting the no-start condition - from the 1990 Mitsu Mighty Max Repair Manual:

Priority Action Part Type -- Cause
1 Inspect Battery -- Battery Discharged or Faulty.
2 Inspect Battery Cable -- Corroded, Broken, Shorted or Poorly Connected Battery Cable.
3 Inspect Distributor Cap -- Distributor Cap Cracked or Burned.
3 Inspect Fuel Filter -- Clogged or Dirty Fuel Filter.
5 Inspect Ignition Coil -- Faulty Ignition Coil.
6 Inspect Wireset -- Worn, Damaged or Faulty Spark Plug Wire(s).
7 Inspect Spark Plug -- Incorrectly Gapped or Fouled Spark Plug(s).
8 Inspect Starter -- Starter Motor Faulty.
9 Inspect Fuel Pump -- Low Fuel Pressure.
10 Inspect Solenoid Switch -- Faulty Starter Solenoid Switch.
11 Inspect Fuel Pump Relay -- Faulty Fuel Pump Relay.
12 Inspect Fuel Injector Pressure Regulator -- Faulty Fuel Injector Pressure Regulator.
13 Inspect Ignition Switch -- Improperly Connected or Faulty Ignition Switch.
14 Inspect Starter Drive -- Faulty Starter Drive.
15 Inspect Fuel Injector -- Dirty or Worn Fuel Injectors.
16 Inspect Fuel Pump Strainer -- Clogged or Dirty Fuel Pump Strainerat.
17 Inspect Engine Control Computer -- Incorrect Operating Information Being Delivered and Sent From The EEC.
18 Inspect Fuel Tank -- Fuel Tank Empty.
19 Inspect Carburetor -- Carburetor Flooded or Faulty Choke.
20 Inspect Distributor -- Worn, Loose, or Incorrectly Installed Distributor.

Aug 17, 2011 | 1993 Mitsubishi Mighty Max

1 Answer

The engine will turn over but will not start i replaced the coil but there is no change.


You need fuel, air, and fire to start your vehicle. Make sure gas is getting to the engine and make sure it has spark to the engine. Check all your fuel components, fuses, relays, fuel reset if equipped. Did you replace anything else besides the coil? Plugs, wires, coil pack, distributor, rotor, cam sensor, crank sensor? Did you check your timing belt/chain? Let me know please.

Mar 06, 2011 | 2000 Chevrolet Blazer

5 Answers

1996 Nissan Sentra doesn't have sparks


Hi and welcome to FixYa,

Initially, to my understanding, 1995 to 1997 Sentras share the same ECU (except the '97 1.6L). Below ECU pin configuration may be of help.
4cb80e9.jpg
Additionally, depending on the regional version that you have, the '96 Sentra may be sharing the same electronic ignition with an Altima. If so, this might interest you.

Good luck and Thank you for using FixYa.

Jan 06, 2009 | 1996 Nissan Sentra

Not finding what you are looking for?
1995 Chevrolet K1500 Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...