Question about 2004 Dodge Ram 1500

Open Question

How to change clutch pack on dodge 1500 rear axle

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 10 Answers

SOURCE: can not remove rear axle on chevy avalanche 4x4 1500.

you will need to take off the differential cover (drain and change diff oil at this time)

rotate the axle so that you can get at the cross pin and remove it by undoing a small bolt that holds it in place. it should slide out with ease, but i have had them stick, take care not to let the cross pin get lodged where it is difficult to extract

a single C-clip is holding each axle inside the differential housing

you will need to push in from the outer end of the axle, while simultaneously manipulating the C-clip off of the inner axle, repeat this same process on the other side

i will put some of pics up in a minute

Posted on Feb 09, 2009

Ad
  • 1 Answer

SOURCE: remove front axle from differential on 2003 dodge ram

That works fine on a relatively new vehicle but one that has run in salt etc you'll save a lot of time if you remove the steering knuckle completey by separating lower ball joint and outer tie rod end ball joint and bring the whole steering knuckle to a bench to separate the hub/bearing. Soak everything with penetrant, loosen the bolts a few turns and try hitting right on the bolt heads. I also made a very sharp wedge from a chisel and rammed it hard on the other side to seoarate the hub. It will finally come apart then you'll see all the **** that was binding it due to an alumininum knuckle re-acting with a steel hub. Clean the hole and grease everything and fit new bearings

Posted on Feb 15, 2009

  • 23 Answers

SOURCE: instructions on replacing rear axle end oil seals 90 silverado pu

Where's it leakin?

Posted on May 12, 2009

badealer888
  • 414 Answers

SOURCE: can't get rear drums off of 94 dodge ram 1500

Look between the lug studs for a phillipsscrew. You will have to use amn impact scewdriver to get it if.
Also there may be a retaining ring around on of the studs.

Posted on Jun 30, 2009

  • 98 Answers

SOURCE: 98 dodge ram 1500 rear axle, setting the backlash

there are adjusters on each side of carrier. do most of adjusting from driver side.need about 8 thou of backlash

Posted on Aug 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Clutch pack


It connects 2 drivetrain parts by using metal to metal friction surfaces. There can be a clutch pack in a rear differential to make a connection to drive the rear axle shafts. There can be clutch packs in automatic transmissions to make a solid connection to make the driveshaft turn.


Do a Web search for clutch packs(paks) on your specific model.

Mar 13, 2014 | Ford Expedition Cars & Trucks

1 Answer

How do you remove the rear axle on a dodge ram 1500 p-up 2 wheel drive?


1st jack and use jack stands to safely lift the truck.disconnect brake lines and cables, remove tires,unbolt universal rear end to driveshaft, unbolt center bolts from axle to leaf springs, pull the rear end out from the side-much easier with two people. reverse process to put the new one on. I assume when you say axle you mean entire rear end. If you need to remove one axle side just take off tire and brake then remove rear end punkin cover and pull shear pin to remove your ring gear and planetary gear-pull axle shaft.

Sep 02, 2011 | Dodge Ram 1500 Cars & Trucks

2 Answers

Where do I install the rear-end oil on a Dodge Ram 1500


I supose you are talking about the rear axle? if so, unscrew the bolts of the rear axle's cover and let the oil flow out into a container. once it's empty, clean the cover and the surface on the axle where the cover goes on to, apply a seal onto the cover and put the cover back on and screw al of the bolts back into place and tighten them. you will find a rubber plug in the cover, take it out and fill the rear axle untill the liquid comes out of the plughole. Put the rubber plug in and you're done! Watch out if you got al limited slip differential, you will need to put an additive into the oil so you won't burn the clutches of you limited slip differential.

Dec 09, 2010 | 2004 Dodge Ram 1500

1 Answer

There is a electronic plug that seats own top of my 2500 dodge pickups axle


FRONT OR REAR AXLE
REAR IS SPEED SENSOR
FRONT I THINK HAS SPEED SENSOR AND ACTUATOR

Dec 09, 2010 | 1998 Dodge Ram 1500 4WD

1 Answer

Fluid leak from left rear axle housing


This is caused by a leaking rear axle seal you will need to pull the left rear axle out and change the seal and check for a worn axle bearing, this requires the removal of the differential cover, pin and center block or posi spring and clutch pack (if so equipped) and spider gears and then the "C" clip that retains the axle into the gear carrier, u will need a tube of silicone to reseal the cover and a axle seal installer tool and about 2 hours of your time

Oct 28, 2010 | 2000 Ford Mustang

1 Answer

On my 2001 Dodge Ram 1500 5.2 2WD, I just found


This is a very simple job to do. Raise the front of truck off the ground,block the rear tires. Using pliers and a hammer,remove the grease cap from hub. Remove the cotter key and nut from axle,pull out slowly and remove outer bearing. then remove hub from axle. To remove inner bearing ,prop hub on a board and use a large punch to drive out bearing and seal. Clean out inside the hub and install new bearing and seal. Replace all parts in the reverse as you took them off. Hope this will help you.

May 14, 2010 | 2001 Dodge Ram 1500 Truck 2WD

2 Answers

Rear end noise on 2002 Dodge ram 1500


If you have a positraction differential, you need posi additive along with the new lube. After it's in, take it to a parking lot and make tight left turns then tight right turns to get the lube between the posi plates. That usually frees it up unless there is an actual mechanical problem in the diff.
good luck!

Apr 03, 2010 | 2006 Dodge Ram 2500

1 Answer

I have a 99 dodge ram 2500 cummins, the rear end recently started chattering when turning, especially noticeable off the start, i did clean out my rear diff and added diff fluid to the bottom of the hole,...


MORE THAN LIKELY YOU NEED TO ADD THE FRICTION MODIFIER TO THE REAR AXLE FLUID..THIS TRUCK CALLS FOR 80W90 GEAR OIL AS WELL..I HOPE THIS HELPS..HOPEFULLY NO DAMAGE HAS BEEN DONE TO CLUTCH PACKS IN CARRIER

Aug 03, 2009 | 1999 Dodge Ram 2500 4WD

1 Answer

SIDE TO SIDE CLUNK


SOULDS TO ME LIKE AXLE IS TRYING TO COME OUT MAY HAVE BUSTED THE AXLE CLIP

Feb 12, 2009 | 2000 Dodge Ram 1500 Truck

1 Answer

97 dodge grandcaravan


just as your mechanic said it is the overrunning clutch case and you might be able to save it by changing the fluid in it and adding an additive we alway use the limited slip additive made for GM and it has gone away within 100 mile of driving. what this clutch does is links the front to the rear axel and if your tires do not match in size (overall diameter) this clutch has to work over time. and wil ruin this clutch . so check your tires first and hope the additive will save your clutches. good luck

Aug 23, 2008 | 1997 Dodge Grand Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

487 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...