Question about Hyundai Motor 2004 Sonata

1 Answer

Changing the starter

Starter stalls when starting but starts most of the time

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,665 Answers

INSPECT OVERRUNNING CLUTCH 1. Slide the overrunning clutch along the shaft. Replace it if does not slide smoothly. 2. Rotate the overrunning clutch (A) both ways. Does it lock in one direction and rotate smoothly in reverse? If it does not lock in either direction or it locks in both directions, replace it. changing the starter - 299a793.gif 3. If the starter driver gear (B) is worn or damaged, replace the overrunning clutch assembly: the gear is not available separately. Check the condition of the flywheel or torque converter ring gear if the starter drive gear teeth are damaged.
CLEANING 1. Do not immerse parts in cleaning solvent. Immersing the yoke assembly and/or armature will damage the insulation. Wipe these parts with a cloth only. 2. Do not immerse the drive unit in cleaning solvent. The overrun clutch is pre-lubricated at the factory and solvent will wash lubrication from the clutch. 3. The drive unit may be cleaned with a brush moistened with cleaning solvent and wiped dry with a cloth. findme(''); findme(''); findme(''); 7d082d0.gif

Posted on Jun 07, 2008

  • Kleanthis Mavropoulos
    Kleanthis Mavropoulos Jun 07, 2008

    Right click on picture and save to another directory so you can zoom in.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 2003 Isuzu rodeo 6 clyinder 4wheel . Starter turns over a little longer before cranking. Done tune up, changed out fuel regulator but still dose the same ,what is my problem . t


a little longer before cranking.

what does that mean?

dont crank,
cranks slow.
cranks (Fast) called normal.
cranks fast starts, then stalls.
cranks fast, starts easy, starts, runs and stays running, normal
at what point does it fail, and how exactly.

we can't hear it, or watch you, so...................................

Dec 13, 2015 | 2003 Isuzu Rodeo

1 Answer

I have had the same remote starter in my car for 8 years. It worked perfectly before but now if it is starting cold, it immediately stalls. The starter attempts 3 times and it starts then immediately


Have you had a battery test done? Sounds like a weak battery or dirty and loose battery connections. The cold weather doesn't help because it makes your engine oil thicker.

Nov 18, 2014 | Honda Cars & Trucks

1 Answer

Anti theft reset ignition


some cars , you must hold the brake to start. did you read the operators manual yet, if not , why not??????
park lockout. (takes brake foot to release)
doesnt start, there are 3 phase,
cranks does it? crank at 250rpm , fast and robust, does it
starts, does it? (your burning fuel now....)
sustains running, (if stalls in 2 seconds that is IMMO cutting out fuel)
stalls means it was running and it stalled, RPM is 0
post the true symptoms and stop guessing at parts, there are 3000 parts, where will that end?

Jan 21, 2014 | 2003 Toyota Corolla

1 Answer

Starter stalls when turning on


sounds like a grounding problem check all the grounds to make sure there not rusted

Jan 01, 2013 | 2006 Suzuki Aerio

1 Answer

My 1999 saturn SL2 i in stalled a new rebult stater motor about maybe one year ago , now the last 3 months about it's been a hit and miss on starting most of the time it starts then every so often


it might not be the starter it could just be a relay i would check the relay and if it is just clicking when you try to start it then that is probubly it if not maybe you have a bad batery

Feb 16, 2012 | Cars & Trucks

1 Answer

88F250 4x4 5.8L FI 5 speed. A friend has this & the starter went out. I replaced it & the solenoid. No big deal right? I returned it & the next day he called me & told me that the...


Its a solenoid...it engages the bendix and truck starts...bendix should retract because power to it gets shut off by ignition switch going to "run".

Only way bendix would stay engaged or get a signal to keep turning ???
Bad contacts in ignition switch...maybe ??
Start relay in under hood power distribution panel has hot or welded contacts ?

I've gotta think about this one...hope this gives some help...

Jul 30, 2011 | Ford F-250 Cars & Trucks

1 Answer

Engine does not start


ur timeings off or ur spark plugs need be change and gas filter 2 this stuff cause the motor to stall

Mar 15, 2010 | 2003 Kia Rio

3 Answers

1992 Oldsmobile custom cruiser stalls and won't start


Sounds like its not getting enough air then overfeulling .

Check the air mass sensor and air meter. also check all the pipes from the air box for splits etc.

Jan 22, 2010 | 1992 Oldsmobile Custom Cruiser

1 Answer

01 kia optima stalled and wont start...starter just clicks


It seems the starter is playing up.First check if your battery is charged fully or try to jump start and see what happens.If the engine start then it's either you need a new battery or else you need a replacement alternator.Test using a voltmeter if the actual altenator is working.Finally the last option is the starter motor that needs changing or fixing...Hope this helps.

Jul 03, 2009 | 2004 Kia Sorento

2 Answers

My Ford F350 stalls while driving and hard to start


Have you checked the MAP sensor or Oxygen sensor..?

Jan 22, 2009 | 1995 Ford F350

Not finding what you are looking for?
Hyundai Motor 2004 Sonata Logo

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...