Question about 1999 Ford Taurus

1 Answer

Engine problem. I would appreciate it a lot if someone could tel me what might be wrong wit my car. Its a 1999 Ford Mondeo 2.5Si V6. I've done a dual exhaust convertion on it a while ago. The problem now is the following: The one exhaust stays wet. First I thought a broken gasket but my water level remains normal, the car uses no water. Then one day I've noticed that steam only comes from the exhaust that functions normally. On further inspection I found the the other exhaust is ice cold while the other one did warm up. The airflow out of each seem the be the same so no pressure is lost. What may cause the one side of my engine not to expell hot air. I've not noticed a loss in performance nor in increase in consumption, however I am still worried. Please help me. This is the first time I"ve heard of such a problem. Thanks in Advance E Maree

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Antifreeze in muffler

Posted on Jul 28, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How can I find lifters for an australian head ford mondeo 1999 1800 16v

enter your engine code into google and source hydraulic valve lifters

Aug 20, 2014 | Cars & Trucks

1 Answer

1999 Ford Taurus stall-out

its ur feul injectors when they get hot their shorting out not alowing the gas to flow either not enough or in ur case and most to much so the car is flooding out then causeing the engine to be flooded with gas which will cause the car to bog out

May 15, 2013 | 1999 Ford Taurus

2 Answers

I'm looking for a diagram of the timing chain and timing marks for mondeo st 220?

Duratec ST-220 used in the top of the line Mondeo 3.0 liter V6.

The original Duratec V6 was introduced in Europe in 1993 in the Ford Mondeo (Ford Contour/ Mercury Mystique in NA). Then in 2000 the smaller 4 cyl Mondeo engines also got the Duratec name, as well as others. Check this for 3.0L 6cyl...


Fig. Be sure the timing marks are as shown after the chain has been installed-2001-04 3.0L (VIN S) engine ( zoom link here )

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Feb 15, 2012 | Cars & Trucks

1 Answer

My ford mondeo wont start . I drove it no problems parked up went back to it 1 hour later and would not start. It sounds like no compression. I've checked cams no breaks timing chain seems tight

yes the timing belt seems ok but get someone to turn engine over and make sure they turn because sometimes the teeth come off the belt at the bottom pulley so although it appears ok it may not be the case and when this happens they go as the engine stops .

Sep 15, 2011 | 2006 Ford Focus

1 Answer

2.0 litre petrol engine crank bearings and small end bearings gone, can this work be done without taking out the engine ? Mondeo is a 52 plate 2.0 Ghia Eurotorque engine.

No,as the pistons only come out from the top.
why dont you get a recon short engine,all the work has been done for you....

May 29, 2010 | 1999 Ford Taurus

1 Answer

Knocking noise from top of engine. goes sometimes when you rev the engine. all cam shafts and tappets ok and no vibrations. seems to be from right hand side of engine?FORD MONDEO 2.5 v6 st24. 1999model

hi have you checked the oil pick up pipe in the sump they have a metle gauze type filter at bottom of pipe which can get blocked restricting the amount of oil getting to the top end of the engine regards

Feb 03, 2010 | 1999 Ford Escort

1 Answer

What is the correct idle in a ford explorer 1999 v6 4.0 L when is hot?Thank you.

This is controlled by the ECM (Engine control module)I usually keeps it between 650-750 RPM's and will sometimes fluctuate when a load is turned on, but not a lot. Sometimes the tachometer in the dash reads wrong, so it maybe right at the tach is wrong. WHY DID YOU ASK THIS QUESTION, IS THERE ANOTHER CONCERN??

Jan 07, 2010 | 1999 Ford Explorer

1 Answer

How do i reset the service light on my mark 2 v6 mondeo geah x

I do not have a Ford Escort, but to turn off my service light I either have to use a scan tool or start the engine so many times without the problem before the light shuts itself off.

Jul 18, 2009 | 1999 Ford Escort

Not finding what you are looking for?
1999 Ford Taurus Logo

Related Topics:

130 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

5622 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides