Question about 1990 Honda Accord

1 Answer

No reverse I have forward gears but no reverse,it happend all at once.If you put it in reverse all you gaet is a noise like grinding allmost.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Teacher:

    An expert who has written 2 tips or uploaded 1 video tip.

  • Expert
  • 77 Answers

Sounds like a cotter pin has broken and needs to be replaced.

Posted on Jun 05, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is it when in reverse the automatic transmission on a 1999 Camaro grinds?


Reverse is not "synchronized" forward gears are, so it does make some noise, try shifting to 2nd before engaging reverse to slow gear rotation and limit gear clash or grind.

Oct 08, 2012 | 1999 Chevrolet Camaro

1 Answer

My 2003 Ford Focus started making a grinding noise when in reverse and in right turns. After driving about 20 miles the symptoms disappeared. The symptoms have gotten progressively worse, vibration and...


Check the front engine mount..If its bad it could make a noise while turning or reverse..Hold the car in gear with your foot on the brake and carefully raise the engine ..do it in both reverse or forward and look for excessive movement..

Sep 22, 2011 | 2003 Ford Focus

1 Answer

In the highway the tranny just went, a grinding noise was heared from back of the tranny every time that put it in gear. after cooldown I was to able to move forward 50 mtrs, then, went again. After a...


You need to have it rebuilt

I would suggest you don't do that,having once
owned a trans repair shop

I would get rid of it & stay away from all van
type vehicles,especially caravans & all ford vans

Jul 17, 2011 | 1999 Dodge Grand Caravan

1 Answer

No Reverse


Check the oil trans filter. Could either be a bad linkage, or a bum synchro. Does it just flat not go into gear, or does it grind when you try to do it? Can you put it in reverse with the engine off?

I dont know exactly witch is you tranny; it sound like you broke the sun shell in the transmission.

For example, this is pretty common with the Chevvorlet 4l60e Transmission, when the sun shell breaks you will lose reverse and fourth gear, the only remedy is to replace the transmssion or have it repaired; the repair will require the transmission be removed and disassembled, you will need to purchase a new sun shell (get a heavy duty replacement) and a papper rubber kit for the repair, just find a good trans guy to provide the labor.

Hope this help.

Apr 06, 2010 | 1994 Jeep Grand Cherokee

1 Answer

Posted at Sun Dec 20, 2009 1:57 pm By


the rod you mentioned is called linkage, yes it's posible, snow may have jammed up under the car and is stopping it from properly engageing, or the grinding could be internal in the transmition, jack the car up, put jack stands under the frame,block the tiers, and take a real good look at were the linckage conects to the tranny, good luck

Dec 20, 2009 | 1992 Toyota Camry V6

1 Answer

Cant shift? reverse grinds? and pressure in clutch is low


What you describe sounds very much like the clutch is failing to disengage.
Fluid level being fine and no leaks under the car is good, but doesnt mean there isnt something wrong with either the master cylinder, slave cylinder, or the associated parts.

Highly unlikely there is a fault with the flywheel or clutch as failures with these would normally give no drive in any gear.

Oct 03, 2009 | 1994 Chevrolet Camaro

2 Answers

Engine runs vehicle wont move Possible ring gear? 84 Topaz


Is it a metal shaft? When you put it in drive does it make any noise? Does the speedometer move? Does it make a loud clicking sound when you put it back in Park?

May 23, 2009 | 2002 Ford Explorer

Not finding what you are looking for?
1990 Honda Accord Logo

Related Topics:

318 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...