Question about 2005 Ford Mustang

1 Answer

2005 Mustang, Rear Center Tail-light replacement

It appears that the center rear tail light (on the trunk) is not working. How do I remove & replace the bulb?

Posted by on

  • Anonymous Mar 31, 2014

    change bulbs in tail gate

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I remove back cover by pulling directly (straight) down.......It has no screws, that was what was a little confusing.......

Posted on Jun 09, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2005 matrix keeps blowing 15amp rear running light fuse every time light get turned on all other lights work fine.whats causing this?


fuses blow because of dead shorts or excess current draw
to blow a 15 amp fuse indicates a dead short
by disconnecting the rear lights , the problem is in something else you have replaced
could be a problem in the head light wiring

Feb 05, 2016 | 2005 Toyota Matrix XR

1 Answer

How do I remove the rear bumper on a 2003 hyundai sonata


You have to remove four screws near the center of the rear bumper that are visible when you open the trunk. Then remove the inside upholstery cover for each rear tail light and then remove the four brass bolts that hold each rear tail light assembly. Unhook the wiring harness so the tail light assembly can be removed and laid aside. Then remove the two screws on each side which were covered by the bottom of the tail lights. Next, remove some of the upholestry retaining pins close to the rear tailights so you can access the spcae behind them. You need to remove two brass nuts close to the outer aspect of where the tailights are located and two screws that are located several inches farther forward that are holding the more frontal aspect of the rear bumper on each side. Finally, remove two retaining screws at the bottom of the most forward aspect of the bumper (wheel well) and one at the top of the most forward aspect of the bumper and you should now be able to remove it! Hope this helps! John in Lexington

Jul 20, 2012 | Hyundai Sonata Cars & Trucks

1 Answer

How do I remove drivers side tail light?


Open the rear hatch, you'll see two plastic push pin fasteners on the side of the tail light lense. Pull out the center peice of the fasteners and the remove the rest of the faster. Remove the tail light assembly.

Jan 14, 2012 | 2005 Dodge Grand Caravan

1 Answer

How to install rear tail light bulb


Remove the interior on the rear body panel, you will see 2 black wing nuts that can be hand turned to remove the tail light plus there might be a additional two screws or bolts on the outside inner of the taillight as you open the trunk lid. 4 in total. slide the light out and replace the burned out light bulb. and reverse the removal instructions d47c41a.gif
Good Luck

Oct 16, 2010 | 2005 Chevrolet Cobalt

1 Answer

Can left 2000 mustang tail light lamp be replaced


Call a different dealer I never heard of that on any left or right tail lamp.
center stop lights yes I have

Feb 04, 2010 | 2000 Ford Mustang

1 Answer

Replace rear tail light bulb on a 2005 nissan maxima


Open the trunk, from the inside remove the side trunk liner (by removing the plastic tabs the liner can be pulled back). Once the liner is pulled back you will need to remove two nuts which secure the tail light in place. Once the two nuts are removed you can start pulling the whole tail light assembly out. There are two other tabs that secure the tail light in place which may give you some resistance but the light should come out without too much force once the two nuts are removed.
Once the tail light is out you can change whatever bulbs you need to.

Oct 04, 2009 | 2005 Nissan Maxima

1 Answer

How to replace rear turn signal bulbs?


Remove trim panel inside trunk. A plastic nut retains tail light assembly in body. Remove the bolt, slide whole tail light from body, disconnect the wires, twist bulb socket to access bulbs.

Jul 04, 2009 | 2005 Volkswagen New Beetle Convertible

1 Answer

NEED TO REPLACE A TAIL LIGHT BULB IN A 2005 CHEVROLET IMPALA


and Repair Notes TAIL LAMP REPLACEMENT REMOVAL PROCEDURE Open the rear compartment. Remove wingnut and pull back the rear compartment trim panel from the tail lamp. Remove the wingnuts from the tail lamp. Remove the tail lamp from the rear body panel. Disconnect the electrical connector from the tail lamp. Remove the tail lamp socket, turning counterclockwise. Remove the bulb from the tail lamp socket. Remove the sidemarker lamp socket, turning counterclockwise. Remove the bulb from the sidemarker lamp socket. INSTALLATION PROCEDURE Install the bulb to the tail lamp socket. Install the bulb to the sidemarker lamp socket. Install the sidemarker lamp socket, turning clockwise. Install the tail lamp socket, turning clockwise. Connect the electrical connector to the tail lamp. Install the tail lamp to the rear body panel. Install the wingnuts to the tail lamp. Pull back the rear compartment trim panel to the tail lamp and install the wingnut. Close the rear compartment.

Jun 08, 2009 | 2005 Chevrolet Impala

1 Answer

Need to replace right rear brake light bulb. can't get into the area.


Is it the rear tail light itself, or the side marker? I may have the same issue if its the side marker. However, the tail light itself is simple, remove the panel in the trunk side, and there are three seperate light fixtures, the bottom being the main tail light, the middle is the signal indicator and the top is the upper brake light.

Mar 16, 2009 | 2005 Scion xB

1 Answer

Replacing rear turn signal bulb in 2003 Mustang


remove the trim panel at the very rear of trunk, remove it and place it out of the way, remove tail light Assembly retaining nuts top and bottom, I think there are 6 per side, pull the tail light assembly straight back to access the bulbs for replacement.

Dec 04, 2008 | 2003 Ford Mustang

Not finding what you are looking for?
2005 Ford Mustang Logo

296 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

63801 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...