Question about 2006 BMW Mini

Open Question

How to change spark plugs on a BMW Mini One

That's it really - MY 2002

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 154 Answers

SOURCE: changing spark plugs in 2002 tribute

Yes the old ones are not reusable

Posted on Aug 12, 2009

michigan man
  • 3533 Answers

SOURCE: How to change spark plugs of Chevy cavalier 2002

for the most part they are in between the fuel injector the best thing for you to do is stop by your local GM dealership in the part department and they be able to print you off the pictures and diagrams you need if all fails stop by your local library and get your hands on a Haynes auto repair manual for your car Merry Christmas and Happy New Year as always wish you the best of luck Michigan Man.

Posted on Dec 21, 2009

Testimonial: "great thanks for the info. bobbotg2005"

  • 223 Answers

SOURCE: how do you change spark plugs on a 2004 BMW 545

You need to remove the top cover 1st. Then remove the gray trim covers on the left and right banks by pulling straight up.You will find individual coils in each cylinder. Disconnect the connector of the coil and pull the coil straight up.The plugs are under each coil.

Posted on May 27, 2010

  • 14036 Answers

SOURCE: change sparks plug wires on my 2002 yukon denaili


Posted on Jun 30, 2010

  • 1874 Answers

SOURCE: i have a 2002 bmw

P1345 = Cylinder 2 misfire with fuel cut-off. Probable cause: Wiring, fuel level low, ignition / fuel system, intake leak, mechanical fault.
P0313 = Misfire detected - low fuel level. Probable cause: Fuel system, mechanical fault.

I suggest you to replace no.# 2 fuel injector. In your case if spark plug & ignition coil have been changed for cylinder no.# 2, there only fuel injector and / or an intake leak & mechanical fault are possible. Check the intake manifold for leaks and carry out a compression test for engine if you have necessary equipment, but I suspect bad fuel injector for cylinder no.# 2.

Posted on Dec 16, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How often should I change spark plugs on a 2010 Mini Cooper clubman?

There isnt really a mention on how often you should change your spark plugs some manufacturers say certain plugs are good for upto a certain mileage
Check with your spark plug manufacturers recommendation on spark plug changing intervals

Sep 24, 2017 | Mini Cars & Trucks

1 Answer

How to change spark plug bmw 540I

You need to remove plastic cover, then remove coils (1 per plug) then undo plug with 5/8" socket & extension. A really good source for parts & tech tips - or Pelican and if you need diagrams goto - you enter your vehicles indue and you'll have FREE access to all diagrams that factory has available

Mar 24, 2011 | 2009 BMW 5 Series

1 Answer

2002 bmw 530d saloon wont start. Its not fuel, its not the battery.It turns on and all electronics work OK! wat could be the problem?

How about the spark? Do the spark plugs get spark? If not, then check out the ignition system in the service manual.

Jan 31, 2011 | 2002 BMW 5 Series

1 Answer

Bmw 525i 2002 non start,no spark,no pulse at coil,code

If your getting no fire at the coil. that's why you're not getting fire to your plugs and therefore it won't start. Change out your coil. This should fix the problem.

Feb 24, 2010 | BMW 525 Cars & Trucks

1 Answer

How do I change the spark plugs on a BMW 523i engine and what is the correct spark gap?

The spark plug change is very straight forward. Basically, you remove the plastic valve cover trim panel, unplug the harness plugs from each of the ignition coils, remove the two nuts securing each coil, pull the coil up. The rubber spark plug connector boot should come up with the coil. You can now remove the spark plugs.

The spark plugs are not gappable. Install them as they come out of the box.

Replace the rubber connector boots at the same time, these wear out and can cause miss-fire problems.

Note that if you find oil in the spark plug wells, the valve cover gaskets must be replaced. Not only does this make a mess, but it deteriorates the boots and also causes miss-fires.

See the DIY article in the Spring 2005 issue of the Bavarian Autosport - Fast Times newsletter (see link below):

Contact Bavarian Autosport for the spark plugs and connector boots (and valve cover gaskets) at 800-535-2002, or order online.

Aug 31, 2009 | 2001 BMW 5 Series

2 Answers

2001 bmw 325i is misfiring?

misfire happens because there is still fuel not burned in the cylinder so when its pushed out its burned in exhaust tube because the heat thats why you hear these small explosions. this caused if your sparking pluge not firing well . or there is a leak in the intake valve . in your case i advice you to check your sparking plug . if this helped pls vooote

May 31, 2009 | 2002 BMW 3 Series

2 Answers

Cant locate spark plugs

If it is a 4 cylinder engine you should have 4 black thick wires going into four points in line, on a V6 engine there will be 6 of them, should be easy to find them now.

Dec 23, 2008 | 2002 BMW 3 Series

1 Answer

BMW 325 ic 1990 doesn't run

change your spark plugs and make sure battery is fully charged got to build compression back up

Nov 16, 2008 | 1990 BMW 3 Series

4 Answers

Eml on my mini coopers

the engine control unit has detected a fault light illuminated which in turn reduces ability to gain high revs as a damage limitation exercise , known as limp home , car requires diagnostic computer to check fault codes to indicate faulty component causing ecu to go into limp home mode

Sep 28, 2008 | 2003 Mini Cooper

1 Answer

1998 BMW Z3 1.9 Cylinder misfire codes. Rough on cold wet starts

Spark plug wires may be the cause. for cold damp start issues water is a conducter and will send spark directly to an engine ground not through spark plugs. also look for oil in spark plug wells this can also cause a misfire under certain conditions.

Aug 12, 2008 | 2002 BMW Z3

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

205 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Anthony Jones
Anthony Jones

Level 2 Expert

128 Answers


Level 2 Expert

254 Answers


Level 2 Expert

281 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides